AEG Integrated fridge freezer SCT71800S1 User Manual

4. HELPFUL HINTS AND TIPS
4.1 Hints for energy saving
• Do not open the door frequently or
leave it open longer than absolutely
necessary.
• If the ambient temperature is high and
the Temperature Regulator is set to
low temperature and the appliance is
fully loaded, the compressor may run
continuously, causing frost or ice on
the evaporator. If this happens, set the
Temperature Regulator toward warm-
er settings to allow automatic defrost-
ing and so a saving in electricity con-
sumption.
4.2 Hints for...

• do not exceed the storage period in-
dicated by the food manufacturer.
5. CARE AND CLEANING
CAUTION!
Unplug the appliance before car-
rying out any maintenance oper-
ation.
This appliance contains hydrocar-
bons in its cooling unit; mainte-
nance and recharging must
therefore only be carried out by
authorized technicians.
5.1 Periodic cleaning
The equipment has to be cleaned regu-
larly:
• clean the inside and accessories with
lukewarm water and some neutral
soap.
• regularly check the door seals and...

5.3 Defrosting of the freezer
The freezer compartment of this model,
on the other hand, is a "no frost" type.
This means that there is no buildup of
frost when it is in operation, neither on
the internal walls nor on the foods.
The absence of frost is due to the con-
tinuous circulation of cold air inside the
compartment, driven by an automatically
controlled fan.
5.4 Periods of non-operation
When the appliance is not in use for
long periods, take the following precau-
tions:•disconnect the...

ProblemPossible causeSolution
The buzzer sounds.
The Alarm light
flashing.The temperature in the
freezer is too high.Refer to "High Tempera-
ture Alarm".
The compressor op-
erates continually.The temperature is not
set correctly.Set a higher temperature.
 The door is not closed
correctly.Refer to "Closing the
door".
 The door has been
opened too frequently.Do not keep the door
open longer than necessa-
ry.
 The product temperature
is too high.Let the product tempera-
ture decrease to...

ProblemPossible causeSolution
The temperature in
the refrigerator is
too high.There is no cold air circu-
lation in the appliance.Make sure that there is
cold air circulation in the
appliance.
The temperature in
the freezer is too
high.Products are too near to
each other.Store products so that
there is cold air circulation.
There is too much
frost.Food is not wrapped cor-
rectly.Wrap the food correctly.
 The door is not closed
correctly.Refer to "Closing the
door".
 The temperature regula-
tor is...

Cli-
mate
classAmbient temperature
SN+10°C to + 32°C
N+16°C to + 32°C
ST+16°C to + 38°C
T+16°C to + 43°C
7.2 Electrical Connection
CAUTION!
Any electrical work required to
install this appliance should be
carried out by a qualified electri-
cian or competent person.
WARNING!
This appliance must be earthed.
The manufacturer declines any li-
ability should these safety meas-
ures not be observed.
AB
C
D E
The wires in the mains lead are
coloured in accordance with the
following code:A Green and Yellow:...

The door of the appliance opens to the
right. To open the door to the left, do
these steps before you install the appli-
ance.
• Loosen and remove the upper pin.
• Remove the upper door.
• Remove the spacer.
• Loosen the middle hinge.
• Remove the lower door.
• Loosen and remove the lower pin.
On the opposite side:
• Tighten the lower pin.
• Install the lower door.
• Tighten the middle hinge.
• Install the spacer.
• Install the upper door.
• Tighten the upper pin.
ENGLISH17 

7.4 Ventilation requirements
5 cmmin.
200 cm2
min.
200 cm2
The airflow behind the appliance must
be sufficient.
7.5 Installing the appliance
CAUTION!
Make sure that the mains cable
can move freely.Do the following steps:
x
x
If necessary cut the adhesive sealing
strip and apply it to the appliance as
shown in figure.
18www.aeg.com 

1 2
Install the appliance in the niche.
Push the appliance in the direction of
the arrow (1) until the upper gap cover
stops against the kitchen furniture.
Push the appliance in the direction of
the arrow (2) against the cupboard on
the opposite side of the hinge.
4 mm
44 mm
Adjust the appliance in the niche.
Make sure that the distance between
the appliance and the cupboard front-
edge is 44 mm.
The lower hinge cover (in the accesso-
ries bag) makes sure that the distance
between the appliance and the...

Remove the correct part from the
hinge cover (E). Make sure to remove
the part DX, in the case of right hinge,
SX in opposite case.
EE
B DC
Attach the covers (C, D) to the lugs and
the hinge holes.
Install the vent grille (B).
Attach the hinge covers (E) to the
hinge.
G
H
Connect the appliance laterally to the
kitchen furniture sidewall:
1.Loosen the screws of the part (G)
and move the part (G) till the furni-
ture sidewall.
2.Tighten the screws of the part (G)
again.
3.Attach the part (H) to the part...