AEG Integrated fridge freezer SCS61400S2 User Manual

							ProblemPossible causeSolution Food products placed in the
appliance were too warm.Allow food products to cool
to room temperature before
storing.The door is not closed cor-
rectly.Refer to "Closing the door".There is too much frost and
ice.The door is not closed cor-
rectly or the gasket is de-
formed/dirty.Refer to "Closing the door".The water drainage plug is
not correctly positioned.Position the water drainage
plug in the correct way.Food products are not wrap-
ped properly.Wrap the food products bet-
ter.Temperature is set incorrect-
ly.Refer to "Operation" chap-
ter.Water flows on the rear plate
of the refrigerator.During the automatic de-
frosting process, frost melts
on the rear plate.This is correct.Water flows into the refriger-
ator.The water outlet is clogged.Clean the water outlet.Food products prevent that
water flows into the water
collector.Make sure that food prod-
ucts do not touch the rear
plate.Water flows on the floor.The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.Attach the melting water
outlet to the evaporative
tray.The temperature in the ap-
pliance is too low/too high.The temperature regulator is
not set correctly.Set a higher/lower tempera-
ture.The door is not closed cor-
rectly.Refer to "Closing the door".The food products' tempera-
ture is too high.Let the food products tem-
perature decrease to room
temperature before storage.Many food products are
stored at the same time.Store less food products at
the same time.The thickness of the frost is
greater than 4-5 mm.Defrost the appliance.The door has been opened
often.Open the door only if neces-
sary.ENGLISH11 
						

							ProblemPossible causeSolutionThere is no cold air circula-
tion in the appliance.Make sure that there is cold
air circulation in the appli-
ance.There is too much con-
densed water on the rear
wall of the refrigerator.Door was opened too fre-
quently.Open the door only when
necessary.Door was not closed com-
pletely.Make sure the door is closed
completely.Stored food was not wrap-
ped.Wrap food in suitable pack-
aging before storing it in the
appliance.Door does not open easily.You attempted to re-open
the door immediately after
closing.Wait a few seconds between
closing and re-opening of
the door.If the advice does not lead
to the desired result, call the
nearest Authorized Service
Centre.7.2  Replacing the lampThe appliance is equipped
with a longlife LED interior
light.CAUTION!
Disconnect the plug from the mains socket.
1. At the same time, with the fingers
expand up and down the transparent
cover and unhook it in the direction
of the arrows.
2. Replace the lamp with one of the
same power and shape, specifically
designed for household appliances.
The maximum power is shown on the
light bulb cover.
3. Reassemble the lamp cover.
4. Connect the plug to the mains
socket.
5. Open the door.
Make sure that the light comes on.7.3  Closing the door
1.Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised Service Centre.
www.aeg.com12   1
2 1  
						

							8. INSTALLATIONWARNING!
Refer to Safety chapters.8.1  LocationRefer to the assembly
instructions for the
installation.
To ensure best performance, install the
appliance well away from sources of heat such as radiators, boilers, direct sunlight
etc. Make sure that air can circulate freely
around the back of the cabinet.
8.2  Positioning
Install the appliance in a dry, well
ventilated indoors where the ambient temperature corresponds to the climateclass indicated on the rating plate of theappliance.
Climate
classAmbient temperatureSN+10°C to + 32°CN+16°C to + 32°CST+16°C to + 38°CT+16°C to + 43°CSome functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only
be guaranteed within the
specified temperature
range. If you have any
doubts regarding where to
install the appliance, please
turn to the vendor, to our
customer service or to the
nearest Authorised Service
Centre.8.3  Ventilation requirements
The airflow behind the appliance must
be sufficient.
8.4  Electrical ConnectionCAUTION!
Any electrical work required to install this appliance
should be carried out by a
qualified electrician or
competent person.WARNING!
This appliance must be
earthed.
The manufacturer declines
any liability should these
safety measures not be
observed.
The wires in the mains lead are coloured
in accordance with the following code:
• A - green and yellow: Earth
• C - brown: Live
ENGLISH13   5 cmmin. 
200 cm2
min. 200 cm
2   A BC D E  
						

							•D - blue: Neutral
As the colours of the wires in the mains
lead of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug,
proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either
with the letter “E“ or by the earth
symbol 
 or coloured green and
yellow.
2. Connect the wire coloured blue to
the terminal either marked with the
letter “N“ or coloured black.
3. Connect the wire coloured brown to
the terminal either marked with the
“L“ or coloured red.
4. Check that no cut, or stray strands of
wire is present and the cord clamp
( E ) is secure over the outer sheath.
Make sure the electricity supply
voltage is the same as that indicated on the appliance rating plate.
5. Switch on the appliance.
The appliance is supplied with a 13 amp
fuse ( B). In the event of having to change
the fuse in the plug supplied, a 13 amp
ASTA approved (BS 1362) fuse must be
used.WARNING!
A cut off plug inserted into a
13 amp socket is a serious
safety (shock) hazard. Ensure
that it is disposed of safely.9.  TECHNICAL DATA9.1  Technical data   Heightmm1441Widthmm540Depthmm549Rising timeHours20VoltageVolts230 - 240FrequencyHz50The technical information is situated in
the rating plate, on the external orinternal side of the appliance and in the energy label.10.  ENVIRONMENTAL CONCERNSRecycle the materials with the symbol .
Put the packaging in applicable
containers to recycle it. Help protect the
environment and human health and to recycle waste of electrical and electronic
appliances. Do not dispose appliancesmarked with the symbol  with the
household waste. Return the product to
your local recycling facility or contact
your municipal office.
*
www.aeg.com14     
						

							ENGLISH15 
						

							www.aeg.com/shop211623090-B-392016