Home > AEG > Fridge freezer > AEG Integrated fridge freezer SCS51813S1 User Manual

AEG Integrated fridge freezer SCS51813S1 User Manual

Here you can view all the pages of manual AEG Integrated fridge freezer SCS51813S1 User Manual. The AEG manuals for Fridge freezer are available online for free. You can easily download all the documents as PDF.

Page 11

WARNING!
Do not touch frozen
goods with wet hands.
Hands can freeze to the
goods.
3. Leave the door open. 
In order to speed up the defrosting process, place a pot of warm water inthe freezer compartment. In addition,remove pieces of ice that break away
before defrosting is complete.
4. When defrosting is completed, dry
the interior thoroughly.
5. Switch on the appliance.
After three hours reload the previously removed food into the freezer
compartment.
7.5  Periods of non-operation
When the appliance is...

Page 12

ProblemPossible causeSolution Many food products to be
frozen were put in at the
same time.Wait some hours and then
check the temperature
again. The room temperature is too
high.Refer to climate class chart
on the rating plate. Food products placed in the
appliance were too warm.Allow food products to cool
to room temperature before
storing.The door is not closed cor-
rectly.Refer to "Closing the door".The FROSTMATIC function
is switched on.Refer to "FROSTMATIC
function".There is too much...

Page 13

ProblemPossible causeSolutionTemperature cannot be set.The FROSTMATIC or COOL-
MATIC function is switched
on.Switch off FROSTMATIC or
COOLMATIC manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "FROST-
MATIC or COOLMATIC
function".The temperature in the ap-
pliance is too low/too high.The temperature regulator is
not set correctly.Set a higher/lower tempera-
ture.The door is not closed cor-
rectly.Refer to "Closing the door".The food...

Page 14

Climate
classAmbient temperatureSN+10°C to + 32°CN+16°C to + 32°CST+16°C to + 38°CT+16°C to + 43°CSome functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only
be guaranteed within the
specified temperature
range. If you have any
doubts regarding where to
install the appliance, please
turn to the vendor, to our
customer service or to the
nearest Authorised Service
Centre.9.2  Electrical ConnectionCAUTION!
Any electrical work required to...

Page 15

9.3 Ventilation requirements
The airflow behind the appliance must
be sufficient.CAUTION!
Refer to the assembly instructions for the
installation.9.4  Door reversibility
1.Loosen and remove the upper pin.
2. Remove the upper door.
3. Remove the spacer.
4. Loosen the middle hinge.
5.Remove the lower door.
6. Loosen and remove the lower pin.
7.Tighten the lower pin on the
opposite side.
8. Install the lower door.
9. Tighten the middle hinge.
10. Install the spacer.
11. Install the upper door.
12. Tighten...

Page 16

2.Install the appliance in the niche.
3. Push the appliance in the direction of
the arrows (1) until the upper gap cover stops against the kitchen
furniture.
4. Push the appliance in the direction of
the arrows (2) against the cupboard on the opposite side of the hinge.
5. Adjust the appliance in the niche. 
Make sure that the distance between
the appliance and the cupboard front-edge is 44 mm.
The lower hinge cover (in the
accessories bag) makes sure that the
distance between the appliance and
the...

Page 17

9.Attach the covers (C, D) to the lugs
and the hinge holes.
10. Install the vent grille (B).
11. Attach the hinge covers (E) to the
hinge.
12. Connect the appliance laterally to
the kitchen furniture sidewall.
13. Loosen the screws of the part (G) and
move the part (G) till the furniture
sidewall.
14. Tighten the screws of the part (G)
again.
15. Attach the part (H) to the part (G).
16. Disconnect the parts (Ha), (Hb), (Hc)
and (Hd).
17. Install the part (Ha) on the inner side
of the kitchen furniture....

Page 18

19.Open the appliance door and the
kitchen furniture door at an angle of
90°.
20. Insert the small square (Hb) into
guide (Ha).
21. Put together the appliance door and
the furniture door and mark the
holes.
22. Remove the brackets and mark a
distance of 8 mm from the outer
edge of the door where the nail must
be fitted (K).
23. Place the small square on the guide
again and fix it with the screws
supplied.
24. Align the kitchen furniture door and
the appliance door by adjusting the
part (Hb).
25. Press...

Page 19

10. NOISES
There are some sounds during normal running (compressor, refrigerant circulation).
ENGLISH19BRRR!
HISSS!
CLICK!
BLUBB!
CRACK!
SSSRR
R!
OK CLICK!CLICK!SSSRRR!SSSRRR! BRRR!BRRR!HISSS!HISSS!  

Page 20

11. TECHNICAL INFORMATION11.1  Technical data   Heightmm1780Widthmm560Depthmm550Rising timeHours22VoltageVolts230 - 240FrequencyHz50The technical information are situated in
the rating plate, on the external orinternal side of the appliance and in the energy label.12.  ENVIRONMENT CONCERNSRecycle the materials with the symbol .
Put the packaging in applicable
containers to recycle it. Help protect the
environment and human health and to recycle waste of electrical and electronic
appliances. Do not...
Start reading AEG Integrated fridge freezer SCS51813S1 User Manual

Related Manuals for AEG Integrated fridge freezer SCS51813S1 User Manual

All AEG manuals