AEG Integrated fridge freezer SCN51810S0 User Manual

7.1 What to do if...ProblemPossible causeSolutionThe appliance does not op-
erate.The appliance is switched
off.Switch on the appliance. The mains plug is not con-
nected to the mains socket
correctly.Connect the mains plug to the
mains socket correctly. There is no voltage in the
mains socket.Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.The appliance is noisy.The appliance is not sup-
ported properly.Check if the appliance stands
stable.The lamp does not...

ProblemPossible causeSolutionWater flows on the floor.The melting water outlet is
not connected to the
evaporative tray above the
compressor.Attach the melting water out-
let to the evaporative tray.Temperature cannot be set.The FROSTMATIC or
COOLMATIC function is
switched on.Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".The temperature in the ap-
pliance is too low/too high.The...

Climate
classAmbient temperatureSN+10°C to + 32°CN+16°C to + 32°CST+16°C to + 38°CT+16°C to + 43°CSome functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only
be guaranteed within the
specified temperature
range. If you have any
doubts regarding where to
install the appliance, please
turn to the vendor, to our
customer service or to the
nearest Authorised Service
Centre.8.2  Electrical ConnectionCAUTION!
Any electrical work required to...

8.3 Ventilation requirements
The airflow behind the appliance must
be sufficient.CAUTION!
Refer to the assembly instructions for the
installation.8.4  Door reversibility
1.Loosen and remove the upper pin.
2. Remove the upper door.
3. Remove the spacer.
4. Loosen the middle hinge.
5.Remove the lower door.
6. Loosen and remove the lower pin.
7.Tighten the lower pin on the
opposite side.
8. Install the lower door.
9. Tighten the middle hinge.
10. Install the spacer.
11. Install the upper door.
12. Tighten...

2.Install the appliance in the niche.
3. Push the appliance in the direction of
the arrows (1) until the upper gap cover stops against the kitchen
furniture.
4. Push the appliance in the direction of
the arrows (2) against the cupboard on the opposite side of the hinge.
5. Adjust the appliance in the niche. 
Make sure that the distance between
the appliance and the cupboard front-edge is 44 mm.
The lower hinge cover (in the
accessories bag) makes sure that the
distance between the appliance and
the...

9.Attach the covers (C, D) to the lugs
and the hinge holes.
10. Install the vent grille (B).
11. Attach the hinge covers (E) to the
hinge.
12. Connect the appliance laterally to
the kitchen furniture sidewall.
13. Loosen the screws of the part (G) and
move the part (G) till the furniture
sidewall.
14. Tighten the screws of the part (G)
again.
15. Attach the part (H) to the part (G).
16. Disconnect the parts (Ha), (Hb), (Hc)
and (Hd).
17. Install the part (Ha) on the inner side
of the kitchen furniture....

19.Open the appliance door and the
kitchen furniture door at an angle of
90°.
20. Insert the small square (Hb) into
guide (Ha).
21. Put together the appliance door and
the furniture door and mark the
holes.
22. Remove the brackets and mark a
distance of 8 mm from the outer
edge of the door where the nail must
be fitted (K).
23. Place the small square on the guide
again and fix it with the screws
supplied.
24. Align the kitchen furniture door and
the appliance door by adjusting the
part (Hb).
25. Press...

9. NOISES
There are some sounds during normal running (compressor, refrigerant circulation).
www.aeg.com18BRRR!
HISSS!
CLICK!
BLUBB!
CRACK!
SSSRR
R!
OK CLICK!CLICK!SSSRRR!SSSRRR! BRRR!BRRR!HISSS!HISSS!  

10. TECHNICAL INFORMATION10.1  Technical data   Dimensions of the recess  Heightmm1780Widthmm560Depthmm550Rising timeHours16VoltageVolts230 - 240FrequencyHz50The technical information are situated in
the rating plate, on the external orinternal side of the appliance and in the energy label.11.  ENVIRONMENT CONCERNSRecycle the materials with the symbol .
Put the packaging in applicable
containers to recycle it. Help protect the
environment and human health and to recycle waste of electrical and...

www.aeg.com/shop222370667-A-382014