AEG Integrated freezer AGS58800S0 User Manual

							6. WHAT TO DO IF…
WARNING!
Before troubleshooting, discon-
nect the mains plug from the
mains socket.
Only a qualified electrician or
competent person must do the
troubleshooting that is not in this
manual.
ProblemPossible causeSolution
The appliance does
not operate. The Pi-
lot light does not
flash.The appliance is switched
off.Switch on the appliance.
 The mains plug is not
connected to the mains
socket correctly.Connect the mains plug to
the mains socket correctly.
 The appliance has no
power. There is no volt-
age in the mains socket.Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
The Pilot light flash-
es.The appliance is not
working properly.Contact a qualified electri-
cian.
The Alarm light
flashes.The temperature in the
freezer is too high.Refer to "High tempera-
ture alarm"
The compressor op-
erates continually.The temperature is not
set correctly.Set a higher temperature.
 The door is not closed
correctly.Refer to "Closing the
door".
 The door has been
opened too frequently.Do not keep the door
open longer than necessa-
ry.
 The product temperature
is too high.Let the product tempera-
ture decrease to room
temperature before stor-
age.
 The room temperature is
too high.Decrease the room tem-
perature.
 The FROSTMATIC func-
tion is switched on.Refer to "FROSTMATIC
function".
The temperature in
the freezer is too
low.The temperature regula-
tor is not set correctly.Set a higher temperature.
 The FROSTMATIC func-
tion is switched on.Refer to "FROSTMATIC
function".
ENGLISH11 
						

							ProblemPossible causeSolution
The temperature in
the freezer is too
high.The temperature regula-
tor is not set correctly.Set a lower temperature.
 The door is not closed
correctly.Refer to "Closing the
door".
 The product temperature
is too high.Let the product tempera-
ture decrease to room
temperature before stor-
age.
 Many products are stored
at the same time.Store less products at the
same time.
 Products are too near to
each other.Store products so that
there is cold air circulation.
There is too much
frost.Food is not wrapped cor-
rectly.Wrap the food correctly.
 The door is not closed
correctly.Refer to "Closing the
door".
 The temperature regula-
tor is not set correctly.Set a higher temperature.
6.1 Closing the door
1.Clean the door gaskets.
2.If necessary, adjust the door. Refer
to "Installation".
3.If necessary, replace the defective
door gaskets. Contact the Service
Center.
7. INSTALLATION
7.1 Positioning
WARNING!
If you are discarding an old appli-
ance that has a lock or catch on
the door, you must ensure that it
is made unusable to prevent
young children being trapped in-
side.
The appliance shall have the
plug accessible after installation.
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
classAmbient temperature
SN+10°C to + 32°C
N+16°C to + 32°C
ST+16°C to + 38°C
T+16°C to + 43°C
7.2 Electrical Connection
CAUTION!
Any electrical work required to
install this appliance should be
carried out by a qualified electri-
cian or competent person.
12www.aeg.com 
						

							WARNING!
This appliance must be earthed.
The manufacturer declines any li-
ability should these safety meas-
ures not be observed.
AB
C
D E
The wires in the mains lead are
coloured in accordance with the
following code:
A Green and Yellow: Earth
CBrown: Live
E Blue: Neutral
As the colours of the wires in the mains
lead of this appliance may not corre-
spond with the coloured markings iden-tifying the terminals in your plug, pro-
ceed as follows:
1.Connect the wire coloured green
and yellow to the terminal marked
either with the letter “E“ or by the
earth symbol 
 or coloured green
and yellow.
2.Connect the wire coloured blue to
the terminal either marked with the
letter “N“ or coloured black.
3.Connect the wire coloured brown to
the terminal either marked with the
“L“ or coloured red.
4.Check that no cut, or stray strands of
wire is present and the cord clamp D
is secure over the outer sheath.
5.Make sure the electricity supply volt-
age is the same as that indicated on
the appliance rating plate.
6.Switch on the appliance.
The appliance is supplied with a 13 amp
plug fitted B. In the event of having to
change the fuse in the plug supplied, a
13 amp ASTA approved (BS 1362) fuse
must be used.
WARNING!
A cut off plug inserted into a 13
amp socket is a serious safety
(shock) hazard. Ensure that it is
disposed of safely.
Refer to the assembly instruc-
tions for the installation.
8. NOISES
There are some sounds during normal
running (compressor, refrigerant circula-
tion).
ENGLISH13 
						

							BRRR!HISSS!
CLICK!
BLUBB!
CRACK!
SSSRR
R!
OK
CLICK!CLICK!SSSRRR!SSSRRR!
BRRR!BRRR!HISSS!HISSS!
BLUBB!BLUBB!CRACK!CRACK!
14www.aeg.com 
						

							9. TECHNICAL DATA
   
Dimension of the recess  
 Height880 mm
 Width560 mm
 Depth550 mm
Rising Time 20 h
Voltage 230-240 V
Frequency 50 Hz
The technical information are situated in
the rating plate on the internal left side
of the appliance and in the energy label.
10. ENVIRONMENT CONCERNS
Recycle the materials with the
symbol  . Put the packaging in
applicable containers to recycle it.
Help protect the environment and
human health and to recycle waste
of electrical and electronicappliances. Do not dispose
appliances marked with the symbol with the household waste. Return the
product to your local recycling
facility or contact your municipal
office.
ENGLISH15 
						

							www.aeg.com/shop
222365771-A-072013