AEG Integrated freezer AGS58200F0 User Manual

							Do not pull, move or damage any pipes and/or cables inside the cabinet.
Never use detergents, abrasive powders, highly perfumed cleaning products or wax polishes
to clean the interior as this will damage the surface and leave a strong odour.
Once a year remove the ventilation grill at the base of the appliance and clean the air chan-
nels with a vacuum cleaner. This operation will improve the performance of the appliance
and save electricity consumption.
CAUTION!
Take care of not to damage the cooling system.
Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the
plastics used in this appliance. For this reason it is recommended that the outer casing of
this appliance is only cleaned with warm water with a little washing-up liquid added.
After cleaning, reconnect the equipment to the mains supply.
Defrosting the freezer
A certain amount of frost will always form on the freezer shelves and around the top com-
partment.
Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm.
To remove the frost, follow the instructions below:
1. Turn the Temperature regulator to the 0 setting and disconnect the mains plug from
the mains socket.
2. Remove any stored food, wrap it in several layers of newspaper and put it in a cool
place.
3. Leave the door open.
4. Remove the three large drawers.
5. When defrosting is completed, remove the water that has collected in the small bottom
drawer and dry the interior thoroughly.
Insert the plug into the wall socket and turn the thermostat control to a medium setting.
After let the appliance run for at least two hours in the Fast Freeze mode, replace the
previously removed food into the compartments.Care and cleaning
11 
						

							Cleaning the air channels
1. Remove the plinth (1), then the ventila-
tion grid (2).
2. Clean the ventilation grid.
3. Carefully pull the air deflector out (3),
checking that there is no water left from
the defrosting.
4. Clean the lower part of the appliance with
a vacuum cleaner.
Periods of non-operation
When the appliance is not in use for long periods, take the following precautions:
1. disconnect the appliance from electricity supply
2. remove all food
3. defrost and clean the appliance and all accessories
4. leave the door/doors open to prevent unpleasant smells.
If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food
inside from spoiling in case of a power failure.
WHAT TO DO IF…
WARNING!
Before troubleshooting, disconnect the mains plug from the mains socket.
Only a qualified electrician or competent person must do the troubleshooting that is not in
this manual.
There are some sounds during normal use (compressor, refrigerant circulation).
ProblemPossible causeSolution
The appliance does not
operate. The Pilot light
does not flash.The appliance is switched off.Switch on the appliance.
 The mains plug is not connected
to the mains socket correctly.Connect the mains plug to the
mains socket correctly.
 The appliance has no power.
There is no voltage in the mains
socket.Connect a different electrical ap-
pliance to the mains socket.
Contact a qualified electrician.
321
12What to do if… 
						

							ProblemPossible causeSolution
The Pilot light flashes.The appliance is not working
properly.Contact a qualified electrician.
The Alarm light flashes.The temperature in the freezer is
too high.Refer to Excessive Temperature
Alarm
The acoustic alarm soundsThe temperature in the freezer is
too high.Refer to Excessive Temperature
Alarm
 The door is left open.Close the door.
The compressor operates
continually.The temperature is not set cor-
rectly.Set a higher temperature.
 The door is not closed correctly.Refer to Closing the door.
 The door has been opened too
frequently.Do not keep the door open longer
than necessary.
 The product temperature is too
high.Let the product temperature de-
crease to room temperature be-
fore storage.
 The room temperature is too
high.Decrease the room temperature.
 The Fast Freeze function is
switched on.Refer to Fast Freeze function.
The temperature in the
freezer is too low.The temperature regulator is not
set correctly.Set a higher temperature.
 The Fast Freeze function is
switched on.Refer to Fast Freeze function.
The temperature in the
freezer is too high.The temperature regulator is not
set correctly.Set a lower temperature.
 The door is not closed correctly.Refer to Closing the door.
 The product temperature is too
high.Let the product temperature de-
crease to room temperature be-
fore storage.
 Many products are stored at the
same time.Store less products at the same
time.
 Products are too near to each
other.Store products so that there is
cold air circulation.
There is too much frost.Food is not wrapped correctly.Wrap the food correctly.
 The door is not closed correctly.Refer to Closing the door.
 The temperature regulator is not
set correctly.Set a higher temperature.
Closing the door
1. Clean the door gaskets.What to do if…
13 
						

							2. If necessary, adjust the door. Refer to Installation.
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
   
Dimension  
 Height815 mm
 Width596 mm
 Depth550 mm
Rising Time 29 h
Voltage 230-240 V
Frequency 50 Hz
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
WARNING!
Read the Safety Information carefully for your safety and correct operation of the appli-
ance before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated indoor (garage or cellar) also, but for
optimum performance install this appliance at a location where the ambient temperature
corresponds to the climate class indicated on the rating plate of the appliance:
Climate classAmbient temperature
SN+10°C to + 32°C
N+16°C to + 32°C
ST+16°C to + 38°C
T+16°C to + 43°C
Electrical Connection
CAUTION!
Any electrical work required to install this appliance should be carried out by a qualified
electrician or competent person.
WARNING!
This appliance must be earthed.
The manufacturer declines any liability should these safety measures not be observed.
14Technical data 
						

							12
3
4
5
The wires in the mains lead are coloured in accordance with the following code:
1Green and Yellow: Earth
3Brown: Live
5Blue: Neutral
As the colours of the wires in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
1. Connect the wire coloured green and yellow to the terminal marked either with the let-
ter “E“ or by the earth symbol 
 or coloured green and yellow.
2. Connect the wire coloured blue to the terminal either marked with the letter “N“ or
coloured black.
3. Connect the wire coloured brown to the terminal either marked with the “L“ or col-
oured red.
4.
Check that no cut, or stray strands of wire is present and the cord clamp 
4 is secure
over the outer sheath.
5. Make sure the electricity supply voltage is the same as that indicated on the appliance
rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug fitted 
2 . In the event of having to change
the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.
WARNING!
A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it
is disposed of safely.Installation
15 
						

							NOISES
There are some sounds during normal running (compressor, refrigerant circulation).
BRRR! HISSS!
CLICK!
BLUBB!
CRACK!
SSSRRR!
OK
CLICK!CLICK!
BRRR!
BRRR!
BLUBB!BLUBB!
16Noises 
						

							HISSS!
HISSS!
SSSRRR!SSSRRR!
CRACK!
CRACK!
ENVIRONMENTAL CONCERNS
The symbol  on the product or on its packaging indicates that this product may not be
treated as household waste. Instead it should be taken to the appropriate collection point
for the recycling of electrical and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential negative consequences for the
environment and human health, which could otherwise be caused by inappropriate waste
handling of this product. For more detailed information about recycling of this product,
please contact your local council, your household waste disposal service or the shop where
you purchased the product.Environmental concerns
17 
						

							18 
						

							19 
						

							www.aeg.com/shop211621222-01-25012011