AEG Integrated dishwasher F67622VI0P User Manual

• The indicator  continues to
flash.
• The display shows the current
setting: 
 = Acoustic signal off.
3. Press 
 to change the setting.
 = Acoustic signal on.
4. Press the on/off button to confirm
the setting.7.  OPTIONSDesired options must be
activated every time before
you start a programme.
It is not possible to activate
or deactivate options while a
programme is running.Not all options are
compatible with each other.
If you have selected non
compatible options, the
appliance will automatically...

8. BEFORE FIRST USE1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the
baskets.
When you start a programme, the
appliance can take up to 5 minutes to
recharge the resin in the water...

Fill the rinse aid dispenser
when the indicator ( A)
becomes clear.If you use multi-tablets and
the drying performance is
satisfactory, the rinse aid
refill indication can be
disabled.
We recommend to always
use rinse aid for better
drying performance, also in
combination with multi-
tablets containing rinsing
agent.9.  DAILY USE1.Open the water tap.
2. Press the on/off button to activate
the appliance.
Make sure that the appliance is in
programme selection mode. • If the salt indicator is on, fill...

Starting a programme with
delay start
1. Set a programme.
2. Press 
 again and again until the
display shows the delay time you
want to set (from 1 to 24 hours).
The delay indicator comes on.
3. Close the appliance door to start the
countdown.
While a countdown is running it is
possible to increase the delay time but not to change the selection of the
programme and options.
When the countdown is completed, the programme starts.
Opening the door while the
appliance operates
If you open the door while a...

rinse aid and salt must be used in
addition to the multi-tablets.
However, in areas with hard and very hard water we recommend to usesolo-detergent (powder, gel, tabletswithout additional functions), rinse aid
and salt separately for optimal
cleaning and drying results.
• Detergent tablets do not fully dissolve with short programmes. To prevent
detergent residues on the tableware,
we recommend that you use the
tablets with long programmes.
• Do not use more than the correct
quantity of detergent. Refer...

11. CARE AND CLEANINGWARNING!
Before maintenance,
deactivate the appliance and
disconnect the mains plug
from the main socket.Dirty filters and clogged
spray arms decrease the
washing results. Make a
check regularly and, if
necessary, clean them.11.1  Cleaning the filters
The filter system is made of 3 parts.
1.Turn the filter ( B) counterclockwise
and remove it.
2. Remove the filter ( C) out of filter ( B). 
3. Remove the flat filter ( A).
4. Wash the filters.
5.Make sure that there are no residues
of...

CAUTION!
An incorrect position of the
filters can cause bad
washing results and damage
to the appliance.11.2  Cleaning the upper spray
arm
We recommend to clean regularly the upper spray arm to avoid soil to clog the
holes.
Clogged holes can cause unsatisfactory
washing results.
1. Pull out the upper basket.
2. To disengage the spray arm from the
basket, press the spray arm upwards
in the direction indicated by the
lower arrow and simultaneously turn
it clockwise.
3. Wash the spray arm under running...

• To maintain the performance of yourappliance at its best, we recommendto use monthly a specific cleaning
product for dishwashers. Follow
carefully the instructions on the
packaging of the product.We recommend the
''sanitisation'' of the
appliance before and after a
long absence (e.g. holidays).
Follow the ''sanitisation''
procedure described in the
chapter ''Options'' (refer to
''ExtraHygiene'').12.  TROUBLESHOOTINGIf the appliance does...

Problem and alarm codePossible cause and solutionThe anti-flood device is on.
The display shows 
.
• Close the water tap and contact an Authorised Service Centre.The appliance stops and
starts more times during op-
eration.• It is normal. It provides optimal cleaning results and en- ergy savings.The program lasts too long.• Select the TimeSaver option to shorten the program time.
• If the delayed start option is set, cancel the delay setting or wait for the end of the countdown.The remaining time in the...

12.1 The washing and drying results are not satisfactoryProblemPossible cause and solutionPoor washing results.• Refer to  "Daily use" , "Hints and tips"  and basket
loading leaflet.
• Use more intensive washing programmes.
• Clean spray arm jets and filter. Refer to  "Care and
Cleaning" .Poor drying results.• Tableware has been left for too long inside a closed
appliance.
• There is no rinse aid or the dosage of rinse aid is not enough. Set the rinse aid dispenser to a higher...