AEG Integrated compact dishwasher F55210VI0 User Manual

Refill the rinse aid dispenser when therinse aid indicator ( C)on the display
comes on.
Adjust the rinse aid dosage
Factory setting: position 3.
You can set the rinse aid dosage
between position 1 (lowest dosage) and
position 4 (highest dosage).
Turn the rinse aid selector ( A) to increase
or decrease the dosage.7.  HINTS AND TIPS7.1  Loading the basket
The rows of prongs in the basket can be
lowered to load pots, pans and bowls.
Mix spoons with other cutlery to prevent
them from bonding together.
The...

CAUTION!
Make sure that the spray arm
can turn freely before you
start a programme.7.2  Hints and tips
• Do not put in the appliance items that
can absorb water (sponges,
household cloths).
• Remove the remaining food from the items.
• Make soft the remaining burned food on the items.
• Put hollow items (cups, glasses and pans) with the opening down.
• Make sure that water does not collect in containers or in bowls.
• Make sure that cutlery and dishes do
not bond together.
• Make sure that the glasses do...

8.4 To clean the external
surfaces
Clean the external surfaces of the
appliance and the control panel with a
moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive cleaning pads or solvents (e.g. acetone).8.5  Protecting against frost
Protect the appliance from frost, for
example in winter. After each cycle:
1. Disconnect the appliance from the
electrical supply.
2. Shut off water supply and disconnect
the water inlet pipe from the water
valve.
3. Drain water from the inlet...

Problem and alarm codePossible solutionThe appliance does not drain the wa-
ter.• Make sure that the drain hose is correctly con- nected.
• Make sure that the filters in the appliance are clean.
• Make sure that the kitchen sink drains correct- ly.Once you have checked the appliance,set and start the programme again. If the
problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.The necessary information for the Service...

ProblemPossible causePossible solutionThere are bluish layers on
glasses and dishes.The rinse aid dosage is too
high.Set the rinse aid dispenser
to a lower position.The detergent can be the
cause.Try a different brand of de-
tergent.The dishes are wet and dull.A programme without a dry-
ing phase has been selec-
ted.Set a programme with a dry-
ing phase.The rinse aid dispenser is
empty.Fill the rinse aid dispenser
with rinse aid.9.3  Error codesCodeMeaningPossible causeE1Longer inlet timeTap is not open...

10.2 Aesthetic panelAesthetic panel dimensionsDimensionValue (mm)Width590 (min. 550)Height407 (min. 388)Thickness16 - 22Installation of aesthetic panel
1.Assemble the handle, hinge and
bracket.
A. Handle
B. Bracket, screws 4*12
C. Hinge, screws 4.2*16
2. Fix the panel onto the door with
screws.
A. Screw 4*12
B. Screw 4.2*16
10.3  Tension adjustment of
the door springCAUTION!
To adjust the door spring call an Authorised Service
Centre.
The door springs are set at the factory to
the proper tension for the...

Door spring tension is
correct when the door
remains horizontal in the
fully open position, yet, you
can close them with a slight
move of a finger .10.4  Electrical connectionWARNING!
Do not use an extension
cord or and adapter plug
with this appliance.WARNING!
Do not cut or remove the
earthing.WARNING!
Make the electrical
connection with the power
cord.For rating voltage check the
rating plate.10.5  Water drain connection
• Connect the water drain hose into a
drain pipe with minimum diameter of
40 mm.
•...

11. TECHNICAL INFORMATION11.1  Technical tableWater pressure0.04 - 1.0 MPaPower supplyRefer to rating plateCapacity6 place settingsType / DescriptionWQP6-3305EStandard place settings6Energy efficiency class 1)A+Annual energy consumption 2)174 kWhEnergy consumption of the standard cleaning cy-
cle0.61 kWhPower consumption of off-mode0 WPower consumption of left-on mode0.4 WAnnual water consumption 3)1820 lDrying efficiency class 4)BStandard cleaning cycle 5)ECO 50°CProgramme duration of the standard...

Rated voltage / frequency230 V~/ 50 HzWater pressure (flow pressure)0.4 - 10bar = 0.04 - 1 MPa1) A+++ (highest efficiency) to D (lowest efficiency)
2)  Energy consumption "180" kWh per year, based on 280 standard cleaning cycles using cold water fill
and the consumption of the low power modes. Actual energy consumption will depend on how the ap-
pliance is used.
3)  Water consumption "1960" litres per year, based on 280 standard cleaning cycles. Actual water con-
sumption will depend on...

www.aeg.com/shop100001027-A-132016