Home > AEG > Hub > AEG Induction hob HK874400FB User Manual

AEG Induction hob HK874400FB User Manual

Here you can view all the pages of manual AEG Induction hob HK874400FB User Manual. The AEG manuals for Hub are available online for free. You can easily download all the documents as PDF.

Page 11

To stop the sound: touch .The function has no effect
on the operation of the
cooking zones.4.9  STOP+GO
This function sets all cooking zones that
operate to the lowest heat setting.
When the function operates, you cannot
change the heat setting.
The function does not stop the timer
functions.
To activate the function:  touch 
. comes on.
To deactivate the function:  touch 
.
The previous heat setting comes on.
4.10  Lock
You can lock the control panel while
cooking zones operate. It prevents an...

Page 12

5. HINTS AND TIPSWARNING!
Refer to Safety chapters.5.1  CookwareFor induction cooking zones
a strong electro-magnetic
field creates the heat in the
cookware very quickly.Use the induction cooking
zones with correct cookware.
Cookware material
• correct:  cast iron, steel, enamelled
steel, stainless steel, the bottom made of multi-layer (with correct mark
from a manufacturer).
• not correct:  aluminium, copper,
brass, glass, ceramic, porcelain.
Cookware is correct for an induction
hob if:
• some water...

Page 13

the heat setting, it is not proportional to
the increase of the cooking zone
consumption of power. It means that the cooking zone with the medium heat
setting uses less than a half of its power.The data in the table is for
guidance only.Heat settingUse to:Time
(min)Hints - 1Keep cooked food warm.as nec-
essaryPut a lid on the cookware.1 - 3Hollandaise sauce, melt: but-
ter, chocolate, gelatine.5 - 25Mix from time to time.1 - 3Solidify: fluffy omelettes,
baked eggs.10 - 40Cook with a lid on.3 - 5Simmer...

Page 14

6.2 Cleaning the hob
• Remove immediately:  melted plastic,
plastic foil, sugar and food with sugar. If not, the dirt can cause damage to
the hob. Take care to avoid burns. Put the special scraper on the glass
surface at an acute angle and move the blade on the surface.
• Remove when the hob is sufficiently
cool:  limescale rings, water rings, fatstains, shiny metallic discoloration.
Clean the hob with a moist cloth and
non-abrasive detergent. After
cleaning, wipe the hob dry with a soft
cloth.
• Remove...

Page 15

ProblemPossible causeRemedyResidual heat indicator does
not come on. The zone is not hot because
it operated only for a short
time.If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.Automatic Heat Up function
does not operate.The zone is hot.Let the zone become suffi-
ciently cool. The highest heat setting is
set.The highest heat setting has
the same power as the func-
tion.The heat setting changes
between two levels.Power management function
operates.Refer to...

Page 16

ProblemPossible causeRemedy comes on.The electrical connection is
incorrect. The supply voltage
is out of range.Speak to a qualified electri-
cian to check the installation. comes on.There is an error in the hob
because a cookware boiled
dry. Automatic Switch Off
and the overheating protec-
tion for the zones operate.Deactivate the hob. Remove
the hot cookware. After ap-
proximately 30 seconds, acti-
vate the zone again. If the
cookware was the problem,
the error message goes out.
Residual heat indicator...

Page 17

higher) mains cable type: H05V2V2-FT min 90°C.8.4  AssemblyENGLISH17min. 50mm
min.500mm
min.2mm  min. 2 mm
A B
A 12 mm28 mm 38 mmB 57 mm41 mm31 mm
min  30 mmmin. 500 mm
< 20 mm > 20 mm
min. 2 mm
A
B
A 12 mm28 mm 38 mm B 57 mm41 mm31 mm
min. 500 mm R 5mm
min. 55mm490+1
mm750 +1
mm min. 38 mm min. 2 mm  

Page 18

 
8.5 Protection boxIf you use a protection box (an additional
accessory), the front airflow space of 2
mm and the protective floor directly
below the hob are not necessary. The
protection box accessory may not be
available in some countries. Please
contact your local supplier.You can not use the
protection box if you install
the hob above an oven.9.  TECHNICAL DATA9.1  Rating plateModel HK874400FBPNC 949 595 223 01Typ 60 GBD CC AU220 - 240 V 50 - 60 HzInduction 7.4 kWMade in GermanySer.Nr....

Page 19

9.2 Cooking zones specificationCooking zoneNominal power
(maximum heat
setting) [W]Power function
[W]Power function
maximum dura-
tion [min]Cookware diam-
eter [mm]Left front2300320010125 - 210Left rear2300320010125 - 210Right front2300320010125 - 210Right rear2300320010125 - 210The power of the cooking zones can be different in some small range from the
data in the table. It changes with the
material and dimensions of the
cookware.For optimal cooking results use
cookware not larger than the diameter in...

Page 20

• Use the residual heat to keep thefood warm or to melt it.11.  ENVIRONMENTAL CONCERNSRecycle the materials with the symbol .
Put the packaging in applicable
containers to recycle it. Help protect the
environment and human health and to recycle waste of electrical and electronic
appliances. Do not dispose appliancesmarked with the symbol  with the
household waste. Return the product to
your local recycling facility or contact
your municipal office.
*
www.aeg.com20   
Start reading AEG Induction hob HK874400FB User Manual

Related Manuals for AEG Induction hob HK874400FB User Manual

All AEG manuals