AEG Induction hob HK855200FB User Manual

• The function decreases the power tothe other cooking zones connected to
the same phase.
• The heat setting display of the reduced zones changes between twolevels.5.  HINTS AND TIPSWARNING!
Refer to Safety chapters.5.1  CookwareFor induction cooking zones
a strong electro-magnetic
field creates the heat in the
cookware very quickly.Use the induction cooking
zones with correct cookware.
Cookware material
• correct:  cast iron, steel, enamelled
steel, stainless steel, the bottom made of multi-layer (with...

the increase of the cooking zone
consumption of power. It means that the cooking zone with the medium heat
setting uses less than a half of its power.The data in the table is for
guidance only.Heat settingUse to:Time
(min)Hints - 1Keep cooked food warm.as nec-
essaryPut a lid on the cookware.1 - 3Hollandaise sauce, melt: but-
ter, chocolate, gelatine.5 - 25Mix from time to time.1 - 3Solidify: fluffy omelettes,
baked eggs.10 - 40Cook with a lid on.3 - 5Simmer rice and milkbased
dishes, heating up ready-...

surface at an acute angle and move
the blade on the surface.
• Remove when the hob is sufficiently
cool:  limescale rings, water rings, fat
stains, shiny metallic discoloration.Clean the hob with a moist cloth and
some detergent. After cleaning, rub the hob dry with a soft cloth.7.  TROUBLESHOOTINGWARNING!
Refer to Safety chapters.7.1  What to do if...ProblemPossible causeRemedyYou cannot activate or oper-
ate the hob.The hob is not connected to
an electrical supply or it is
connected incorrectly.Check...

ProblemPossible causeRemedy The highest heat setting is
set.The highest heat setting has
the same power as the func-
tion.The heat setting changes
between two levels.Power management function
operates.Refer to "Daily use" chapter.The sensor fields become
hot.The cookware is too large or
you put it too near to the
controls.Put large cookware on the
rear zones if possible.There is no signal when you
touch the panel sensor
fields.The signals are deactivated.Activate the signals.
Refer to "Daily...

ProblemPossible causeRemedy comes on.There is an error in the hob
because a cookware boils
dry. Automatic Switch Off
and the overheating protec-
tion for the zones operate.Deactivate the hob. Remove
the hot cookware. After ap-
proximately 30 seconds, acti-
vate the zone again. If the
cookware was the problem,
the error message goes out.
Residual heat indicator can
stay on. Let the cookware
become sufficiently cool.
Check if your cookware is
compatible with the hob.
Refer to “Hints and tips”
chapter.7.2...

8.4 Assemblywww.aeg.com16min. 50mm
min.500mm
min.2mm  min. 2 mm
A B
A 12 mm28 mm 38 mmB 57 mm41 mm31 mm
min  30 mmmin. 500 mm
< 20 mm > 20 mm
min. 2 mm
A
B
A 12 mm28 mm 38 mm B 57 mm41 mm31 mm
min. 500 mm R 5mm
min. 55mm490+1
mm750 +1
mm min. 38 mm min. 2 mm  

 
9. TECHNICAL INFORMATION9.1  Rating plateModell HK855200FBPNC 949 595 396 01Typ 58 GBD CM AU220 - 240 V 50 - 60 HzInduction 7.4 kWMade in GermanySer.Nr. .................7.4 kWAEG 9.2 Cooking zones specificationCooking zoneNominal power
(maximum heat
setting) [W]Power function
[W]Power function
maximum dura-
tion [min]Cookware diam-
eter [mm]Left front140025004125 - 145Left rear2300320010125 - 210Middle front2300320010125 - 210Right front140025004125 - 145Right rear2300320010125 - 210The power of the...

10. ENERGY EFFICIENCY10.1  Product information according to EU 66/2014Model identification HK855200FBType of hob Built-In HobNumber of cooking zones 5Heating technology InductionDiameter of circular cook-
ing zones (Ø)Left front
Left rear
Middle front
Right front
Right rear14.5 cm
21.0 cm
21.0 cm
14.5 cm
21.0 cmEnergy consumption per
cooking zone (EC electric
cooking)Left front
Left rear
Middle front
Right front
Right rear172.8 Wh / kg
165.2 Wh / kg
175.5 Wh / kg
176.2 Wh / kg
175.5 Wh / kgEnergy...

ENGLISH19 

www.aeg.com/shop867328185-A-102016