AEG Gas hob HG995440NB User Manual

6.3 Cleaning the hob
•Remove immediately:  melted plastic,
plastic foil, sugar and food with sugar. If not, the dirt can cause damage to
the hob. Take care to avoid burns.
• Remove when the hob is sufficiently
cool:  limescale rings, water rings, fat
stains, shiny metallic discoloration.
Clean the hob with a moist cloth and
non-abrasive detergent. After
cleaning, wipe the hob dry with a soft
cloth.
• To clean the enamelled parts, cap
and crown, wash them with warm
soapy water and dry them carefully...

7.2 If you cannot find a
solution...
If you cannot find a solution to theproblem yourself, contact your dealer or
an Authorised Service Centre. Give the data from the rating plate. Make sure,
you operated the hob correctly. If not the
servicing by a service technician or
dealer will not be free of charge, alsoduring the warranty period. The
instructions about the Service Centre and
conditions of guarantee are in the
guarantee booklet.7.3  Labels supplied with the
accessories bag
Stick the adhesive labels...

B.S. 5440, Par. 2 and B.S. 6891 Current
Editions.
The hob should not be installed in a bed sitting room with a volume of less than 20 m³. If it is installed in a room of
volume less than 5 m³ an air vent of
effective area of 100 cm² is required. If it
is installed in a room of volume between
5 m³ and 10 m³ an air vent of effective area of 50 cm² is required, while if the
volume exceeds 11 m³ no air vent is
required.
However, if the room has a door which
opens directly to the outside no air vent
is...

CAUTION!
Make sure that the gas
supply pressure of the
appliance obeys the
recommended values.Rigid connection:
Carry out connection by using metal rigid
pipes (copper with mechanical end).
8.4  Injectors replacement
1.Remove the pan supports.
2. Remove the caps and crowns of the
burner.
3. With a socket spanner 7 remove the
injectors and replace them with the
ones which are necessary for the type of gas you use (see table in
"Technical Information" chapter).
4. Assemble the parts, follow the...

• or E — Earth terminal
Before carrying out the connection,
make sure:
1. The limiter valve and the electrical
system can take the appliance load
(see the rating plate)
2. The supply system is equipped with
an efficient earth connection in
compliance with the current
standards and regulations
3. The outlet or omnipolar switch used
for connection is easily accessible
with the appliance installed.
The appliance is supplied with a 3 core
flexible power cable with a 3 amp plug. If
it is necessary to change...

8.8 Assembly
1.
2.
3.
4.
If a furniture unit is
installed at a distance of
400 mm above the hob,
there must be a
minimum safety distance
of 50 mm to the left or
right from the edge of
the hob.
5.
6.
7.
A) supplied seal
B) supplied brackets
8.
www.aeg.com16  min. 45 mm
min. 650 mm
830 mm
min. 100 mm
40 mm480 mm 50 mm400 mm    B
A   

CAUTION!
Install the appliance only on
a worktop with flat surface.8.9  Possibilities for insertion
The panel installed below the hob must
be easy to remove and let an easy accessin case a technical assistance
intervention is necessary.
Kitchen unit with door or drawer
A. Removable panel
B. Space for connections
Kitchen unit with oven
The electrical connection of the hob and
the oven must be installed separately for
safety reasons and to let easy remove
oven from the unit.
9.  TECHNICAL DATA9.1  Hob...

Appliance category:II2H3+ Gas connection:R 1/2" Appliance class:3 9.4 Gas burners for NATURAL GAS G20 20 mbarBURNERNORMAL POWER kWMINIMUM POWER
kWINJECTOR MARK
1/100 mmTriple Crown3,81,4146Semi-rapid1,90,4596Auxiliary1,00,33709.5  Gas burners for LPG G30/G31 28-30/37 mbarBURNERNORMAL
POWER kWMINIMUM
POWER kWINJECTOR
MARK 1/100
mmNOMINAL GAS FLOW g/hG30 28-30
mbarG31 37 mbarTriple Crown3,81,498276271Semi-rapid1,90,4571138136Auxiliary1,00,3350737110.  ENERGY EFFICIENCY10.1  Product information...

10.2 Energy saving
• Before use, make sure that the burners and pan supports are assembled correctly.
• Use cookware with diameters applicable to the size of burners. • Center the pot on the burner.
• When you heat up water, use only the amount you need.
• If it is possible, always put the lids on the cookware.
• When the liquid starts to boil, turn down the flame to barely simmer the liquid. • If it is possible, use a pressure cooker. Refer to its user manual.11.  ELECTROLUX / AEG MAJOR APPLIANCES -...

7.All gas appliances are to be installed
by a gas installer, registered with
SAQCC GAS. Electrical appliances
are to be installed by a qualified
electrician who is an authorised
service agent or assisted by an
authorised service agent from who
proof of installation will be required.
8. Repairs carried out under warranty
have a guarantee period of 3 (three)months on the parts and labour
supplied to repair the unit and does
not extend the warranty nor does it
start a new warranty. Parts removed
during...