AEG Gas hob HG65SY4550 User Manual

7. TROUBLESHOOTINGWARNING!
Refer to Safety chapters.7.1  What to do if...ProblemPossible causeRemedyThere is no spark when you
try to activate the spark gen-
erator.The hob is not connected to
an electrical supply or it is
connected incorrectly.Check if the hob is correctly
connected to the electrical
supply. The fuse is blown.Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician. Burner cap and crown are
placed incorrectly.Place...

7.3 Labels supplied with the
accessories bag
Stick the adhesive labels as indicated
below:A. Stick it on Guarantee Card and send
this part (if applicable).
B. Stick it on Guarantee Card and keep
this part (if applicable).C. Stick it on instruction booklet.8.  INSTALLATIONWARNING!
Refer to Safety chapters.8.1  Before the installation
Before you install the hob, write down
the information bellow from the rating
plate. The rating plate is on the bottom
of the hob.
Model...

However, if the room has a door whichopens directly to the outside no air vent
is required even if the volume is between 5 m³ and 11 m³.
If there are other fuel burning appliances in the same room, B.S. 5440 Part 2
Current Edition, should be consulted to determine the requisite air vent
requirements.
For appliances installed in the Republic
of Ireland please refer to the NSAI-
Domestic Gas Installation I.S. 813 Current
Editions Table Four.Location
The hob may be located in a kitchen, a
kitchen/diner or...

8.4 Injectors replacement
1. Remove the pan supports.
2. Remove the caps and crowns of the
burner.
3. With a socket spanner 7 remove the
injectors and replace them with the
ones which are necessary for the type of gas you use (see table in
"Technical Information" chapter).
4. Assemble the parts, follow the same
procedure backwards.
5. Replace the rating plate (it is near the
gas supply pipe) with the one for the
new type of gas supply. You can find this plate in the package supplied
with the...

2.The supply system is equipped with
an efficient earth connection in
compliance with the current
standards and regulations
3. The outlet or omnipolar switch used
for connection is easily accessible
with the appliance installed.
The appliance is supplied with a 3 core
flexible power cable with a 3 amp plug. If
it is necessary to change the fuse, use a 3
amp ASTA-approved (BS 1362) fuse.
A. Green and Yellow
B. 3 amp fuse
C. Brown
D. Cord clamp
E. Blue
The wires in the cord are coloured as
follows:
Green...

8.8 Assembly
1.
2.
3.
4.
If a furniture unit is
installed at a distance of
400 mm above the hob,
there must be a
minimum safety distance
of 50 mm to the left or
right from the edge of
the hob.
5.
6.
7.
8.
9.
www.aeg.com16  min. 55 mm
min. 650 mm
560 mm
min. 100 mm
30 mm4
80 
mm
min. 600 mm 50 mm400 mm       

A) supplied seal
B) supplied brackets
10.
11.
CAUTION!
Install the appliance only on
a worktop with flat surface.8.9  Possibilities for insertion
The panel installed below the hob must be easy to remove and let an easy accessin case a technical assistance
intervention is necessary.Kitchen unit with door or drawer
A. Removable panel
B. Space for connections
Kitchen unit with oven
The electrical connection of the hob and
the oven must be installed separately for
safety reasons and to let easy remove
oven...

BURNERØ BYPASS 1/100 mmAuxiliary329.3 Other technical data
TOTAL POWER:
Gas original:G20 (2H) 20 mbar = 9 kWGas replacement:G30 (3+) 28-30 mbar = 654 g/h
G31 (3+) 37 mbar = 643 g/hElectric supply:220-240 V ~ 50/60 Hz
3 core flexible cable with non rewireable plug fitted with a 3 amp
cartridge fuseAppliance category:II2H3+ Gas connection:R 1/2" Appliance class:3 9.4  Gas burners for NATURAL GAS G20 20 mbarBURNERNORMAL POWER kWMINIMUM POWER
kWINJECTOR MARK
1/100 mmTriple...

Number of gas burners 4
Energy efficiency per gas burner
(EE gas burner)
Left rear - Semi-rapid55.2%Right rear - Semi-rapid55.2%Left front - Triple Crown52.0%Right front - Auxiliarynot applicableEnergy efficiency for the gas hob
(EE gas hob) 54.1%
EN 30-2-1: Domestic cooking appliances burning gas - Part 2-1 : Rational use of energy - General
10.2  Energy saving
• Before use, make sure that the burners and pan supports are assembled correctly.
• Use cookware with diameters applicable to the size of...

www.aeg.com/shop867329136-D-392016