Home > AEG > Hub > AEG Gas hob HG65NM4320 User Manual

AEG Gas hob HG65NM4320 User Manual

Here you can view all the pages of manual AEG Gas hob HG65NM4320 User Manual. The AEG manuals for Hub are available online for free. You can easily download all the documents as PDF.

Page 11

ProblemPossible causeRemedyThe flame extinguishes im-
mediately after ignition.Thermocouple is not heated
up sufficiently.After lightning the flame,
keep the knob pushed for
equal or less than 10 sec-
onds.The flame ring is uneven.Burner crown is blocked with
food residues.Make sure that the injector is
not blocked and the burner
crown is clean.7.2  If you cannot find a
solution...
If you cannot find a solution to theproblem yourself, contact your dealer or
an Authorised Service Centre. Give the data...

Page 12

plate. The rating plate is on the bottom
of the hob.
Model .......................................
PNC .........................................
Serial number ...........................8.2  Important safety
requirements
This hob must be installed in accordance with the Gas Safety (Installation and Use)
Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition).
For appliances installed in the Republicof Ireland please refer to NSAI- DomesticGas Installation I.S. 813 Current Editions...

Page 13

When the final connection has been
made, it is essential that a thorough leak
test is carried out on the hob and
installation.
Make sure that the main connection pipe
does not exert any strain on the hob.
If you use flexible metal pipes make sure
that they agree to ISO 10380 and ISO
10807 standards. Be careful they do not
come in touch with mobile parts or they are not squeezed. Also be careful whenthe hob is put together with an oven.CAUTION!
It is important to install the elbow correctly, with the...

Page 14

Electrical Requirements
Permanent electrical installation must
agree with the latest I.E.E. Regulations and local Electricity Board regulations.
For your own safety the installation must
be done by a qualified electrician (e.g.
your local Electricity Board, or a
contractor who is on the roll of the
National Inspection Council for Electrical
Installation Contracting [NICEIC]).The manufacturer refuses
to be held responsible, if
these safety measures are
not abided by.Supply connections
This hob has to be...

Page 15

To replace the connection
cable use only H03V2V2-F
T90 or equivalent type.
Make sure that the cable
section is applicable to the
voltage load and the
working temperature. The
yellow/green earth wire (B)
must be approximately 2 cm
longer than the live and
neutral wire (A).
1. Connect the green and yellow (earth)
wire to the terminal which is marked
with the letter 'E', or the earth
symbol 
, or coloured green and
yellow.
2. Connect the blue (neutral) wire to the
terminal which is marked with the...

Page 16

If a furniture unit is
installed at a distance of
400 mm above the hob,
there must be a
minimum safety distance
of 50 mm to the left or
right from the edge of
the hob.
5.
6.
7.
8.
9.
A) supplied seal
B) supplied brackets
10.
11.
CAUTION!
Install the appliance only on
a worktop with flat surface.8.9  Possibilities for insertion
The panel installed below the hob must
be easy to remove and let an easy accessin case a technical assistance
intervention is necessary.
www.aeg.com16     A
B     

Page 17

Kitchen unit with door or drawerA.Removable panel
B. Space for connectionsKitchen unit with oven
The electrical connection of the hob and
the oven must be installed separately for
safety reasons and to let easy remove
oven from the unit.
9.  TECHNICAL DATA9.1  Hob dimensionsWidth594 mmDepth510 mm9.2 Bypass diametersBURNERØ BYPASS 1/100 mmRapid42Semi-rapid32Auxiliary289.3 Other technical data
TOTAL POWER:
Gas original:G20 (2H) 20 mbar = 8 kWGas replacement:G30 (3+) 28-30 mbar = 567 g/h
G31 (3+) 37 mbar =...

Page 18

Gas connection:R 1/2" Appliance class:3 9.4 Gas burners for NATURAL GAS G20 20 mbarBURNERNORMAL POWER kWMINIMUM POWER
kWINJECTOR MARK
1/100 mmRapid3,00,75119Semi-rapid2,00,4596Auxiliary1,00,33709.5  Gas burners for LPG G30/G31 28-30/37 mbarBURNERNORMAL
POWER kWMINIMUM
POWER kWINJECTOR
MARK 1/100
mmNOMINAL GAS FLOW g/hG30 28-30
mbarG31 37 mbarRapid2,80,7586204200Semi-rapid2,00,4571145143Auxiliary1,00,3350737110.  ENERGY EFFICIENCY10.1  Product information according to EU 66/2014Model identification...

Page 19

• Center the pot on the burner.
• When you heat up water, use only the amount you need.
• If it is possible, always put the lids on the cookware.
• When the liquid starts to boil, turn down the flame to barely simmer the liquid. • If it is possible, use a pressure cooker. Refer to its user manual.11.  ELECTROLUX / AEG MAJOR APPLIANCES -
WARRANTY CONDITIONSFor domestic use only.
Not for commercial or industrial use. Any alteration or modification of theequipment voids the warranty.
Failure to use a...

Page 20

authorised service agent from who
proof of installation will be required.
8. Repairs carried out under warranty
have a guarantee period of 3 (three) months on the parts and labour
supplied to repair the unit and does
not extend the warranty nor does it
start a new warranty. Parts removed
during guarantee repairs become the
property of Electrolux.
9. After expiry of 6 (six) months from the
date of purchase the warranty shall
be available only to the original retail
purchaser of Electrolux domestic...
Start reading AEG Gas hob HG65NM4320 User Manual

Related Manuals for AEG Gas hob HG65NM4320 User Manual

All AEG manuals