AEG Gas hob HC412000GB User Manual
Here you can view all the pages of manual AEG Gas hob HC412000GB User Manual. The AEG manuals for Hub are available online for free. You can easily download all the documents as PDF.
Page 11
WARNING! The following instructions about installation, connection and maintenance must be carried out by qualified personnel in compli- ance with standards and local regulations in force. 8.1 Gas Connection Make sure that during the installation the appliance is not connected to elec- trical supply. Disconnect the mains plug or deactivate the fuses. Disconnect the mains gas supply. Make sure that there is a stop tap as- sembled between the gas supply of house and the appliance. The settings for this...
Page 12
– the fastening clamps are not rusted; – expired term is not due. If one or more defects are visible, do not repair the pipe, but replace it. When installation is complete, make sure that the seal of each pipe fitting is correct. Use a soapy solution, not a flame! 8.2 Injectors replacement 1.Remove the pan supports. 2.Remove the caps and crowns of the burner. 3.With a socket spanner 7 remove the injectors and replace them with the ones which are necessary for the type of gas you use. 4.Assemble the...
Page 13
• Make sure that there is an access to the mains plug after installation. • Do not pull the mains cable to discon- nect the appliance. Always pull the mains plug. • The appliance must not be connected with an extansion cable, an adapter or a multiple connection (risk of fire). Check that the ground connection is in conformity with the standard and regulations force. • The power cable must be placed in such a way that it does not touch any hot part. • Connect the appliance to the mains with a device that...
Page 14
min. 30 mm min. 20 mm • Seal the gap between the worktop and glass ceramic with silicone. • Put some soapy water on the silicone. • Pull off the excess silicone with the scraper. 8.7 The installation of more than one appliance Added parts:connection bar(s), heat re- sistant silicon, rubber shape, sealing strap. Only use special a heat - resistant silicon. The worktop cut out Distance from the wall : minimum 50 mm Depth : 490 mm Width : sum widths of all the appliances to be built-in and subtract 20 mm...
Page 15
7.Put the subsequent appliance in the worktop cut out . Make sure that the front ends of the appliances are on the same level. 8.Tighten the fixing plate / retaining grip screws. 9.Seal the gap between the worktop and appliances and between appli- ances with silicone. 10.Put some soapy water on the silicon. 11.Press the rubber shape with some strength against the glass ceramic and move it slowly along the space. 12.Do not touch the silicon until it be- come hard, it can last about a day. 13.Carefully...
Page 16
pered with by person not authorised by us. • Electrolux Service Force Centre must undertake all service work under this guarantee • Any appliance or defective part re- placed shall become the Company's property. • This guarantee is in addition to your statutory and other legal rights. Exclusions • Damage, calls resulting from trans- port, improper use, neglect, light bulbs, removable parts of glass, plas- tic. • Costs for calls to put right appliance which is improperly installed, calls to appliances...
Page 17
• The appliance guarantee is personal to the original purchaser of the appli- ance and cannot be transferred to an- other user. • The appliance is installed and used in accordance with instructions issued by Electrolux and is only used within the home, i.e. is not used for commercial purposes.• The appliance is installed in accord- ance with all relevant regulations in force within your new country of resi- dence. The provisions of this European Guaran- tee do not affect any of the rights gran- ted to...
Page 18
Nederland+31 17 24 68 300Vennootsweg 1, 2404 CG - Al- phen aan den Rijn Norge+47 81 5 30 222Risløkkvn. 2 , 0508 Oslo Österreich0810 955030Herziggasse 9, 1230 Wien Polska+48 22 43 47 300ul. Kolejowa 5/7, 01–217 Wars‐ zawa Portugal+35 12 14 40 39 39Quinta da Fonte - Edifício Gon- çalves Zarco - Q 35 -2774-518 Paço de Arcos Romania+40 21 451 20 30Str. Garii Progresului 2, S4, 040671 RO Schweiz - Suisse - Svizzera0848 848 111Industriestrasse 10, CH-5506 Mä- genwil Slovenija+38 61 24 25 731Gerbičeva ulica...