AEG Front loader washing machine L68480FL User Manual

							ProblemPossible solutionThe spin phase does not
operate or the washing
cycle lasts longer than
usually.Set the spin programme. Make sure that the drain filter is not clogged. Clean the filter, if
necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase
again. This problem may be caused by balance problems.There is water on the
floor.Make sure that the couplings of the water hoses are tight and
there is not water leakages. Make sure that the drain hose have no damages. Make sure you use the correct detergent and the correct quan-
tity of it.You cannot open the ap-
pliance door.Make sure that the washing programme is finished. Set the drain or the spin programme if there is water in the
drum.The appliance makes an
unusual noise.Make sure the levelling of the appliance is correct. Refer to 'In-
stallation'. Make sure that the packaging and/or the transit bolts are re-
moved. Refer to 'Installation'. Add more laundry in the drum. The load may be too small.The cycle is shorter than
the time displayed.The appliance calculates a new time according to the laundry
load. See the ‘Consumption Values’ chapter.The cycle is longer than
the time displayed.An unbalanced laundry load increases the duration time. This
is a normal behaviour of the appliance.The washing results are
not satisfactory.Increase the detergent quantity or use a different detergent. Use special products to remove the stubborn stains before you
wash the laundry. Make sure that you set the correct temperature. Decrease the laundry load.You cannot set an op-
tion.Make sure that you press only the wanted button(s).After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.ENGLISH21 
						

							14. TECHNICAL DATADimensionWidth/ Height/ Depth/
Total depth600 mm/ 850 mm/ 520 mm/ 576 mmElectrical connectionVoltage
Overall power
Fuse
Frequency230-240 V
2200 W
13 A
50 HzLevel of protection against ingress of solid particles
and moisture ensured by the protective cover, ex-
cept where the low voltage equipment has no pro-
tection against moistureIPX4Water supply pressure1)Minimum
Maximum0,5 bar (0,05 MPa)
8 bar (0,8 MPa)Water supply 2)Cold waterMaximum LoadCotton8 kgEnergy Efficiency ClassA+++Spin SpeedMaximum1400 rpm1)  The appliance works correctly if the water pressure is not less than 0.05 MPa (0.5 bar). If you can not
connect the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your
domestic cold water storage system. Make sure not to have more than a distance of 5.02 m (16.5 ft) be- tween the appliance inlet hose and the bottom of the water storage tank.2)  Connect the water inlet hose to a water tap with a 3/4'' thread.15.  ENVIRONMENT CONCERNSRecycle the materials with the symbol .
Put the packaging in applicable
containers to recycle it. Help protect the
environment and human health and to recycle waste of electrical and electronic
appliances. Do not dispose appliancesmarked with the symbol  with the
household waste. Return the product to
your local recycling facility or contact
your municipal office.
*
www.aeg.com22   
						

							ENGLISH23 
						

							www.aeg.com/shop192964040-A-522014