AEG Freestanding washer dryer L77695WD User Manual

11.2 Drying at automatic levels
The laundry can be dried at pre-defined levels of dryness:
1. Press Drying level again and again
until the display shows one of the
dryness level indicator:
•
: IRON DRY level indicator for
cotton items
•
: CUPBOARD DRY level
indicator for cotton and synthetic
items
•
: EXTRA DRY level indicator
for cotton items
The display shows a time value,
calculated on the default load size. If the
amount of your laundry is more or less than the default size, the appliance
adjusts...

2.Load the laundry one item at a time.To have a good drying
performance  do not exceed
the maximum drying loads
recommended in the user
manual.  Do not set a spin
speed lower than the
automatic speed of the set
programme.
3. Put the detergent and the additives
in the appropriate compartment.
4. Turn the programme dial to the
washing programme.
The display shows the indicators of the
different washing phases.
5. Set the available options.
12.2  Washing & Automatic
drying
1. Press Drying level again and...

• To do not wash dark fabrics after youwashed and dried light coloured
fabrics (new sponge, wool, sweatshirt ) and the contrary.
• To dry this type of fabrics at open air when they are washed the first time.
• To clean the drain filter.
• After the drying phase, clean the empty drum, the gasket and the doorwith a wet cloth.12.6  How to remove the fluff
in the garments
To remove the fluff inside the drum, set a
special programme:
1. Empty the drum.
2. Clean the drum, the gasket and the
door with a wet...

programme temperature and the
level of soil.
• If your appliance has not the detergent dispenser with the flap
device, add the liquid detergents with
a dosing ball (supplied by the
detergent's manufacturer).13.4  Ecological hints
• Set a programme without the
prewash phase to wash laundry withnormal soil.
• Always start a washing programme with the maximum load of laundry.
• If necessary, use a stain remover when you set a programme with a low
temperature.
• To use the correct quantity of the...

To avoid the static charge at the end of
the drying cycle:
1. Use fabric conditioner in the washing
cycle.
2. Use special fabric conditioner for
tumble dryers.When the drying programme is
completed remove the laundry in a short time.14.  CARE AND CLEANINGWARNING!
Refer to Safety chapters.14.1  External cleaning
Clean the appliance only with soap and
warm water. Fully dry all the surfaces.
CAUTION!
Do not use alcohol, solvents
or chemical products.14.2  Descaling
If the water hardness in your area is...

3.4.14.6 Cleaning the inlet hose and the valve filter1.2.3.4.14.7 Cleaning the drain filterDo not clean the drain filter if the water in the appliance is hot.www.aeg.com26  12 3   45°
20°   

1.2.3.4.5.6.7.8.ENGLISH2712 21
1  12 12   1
2  

9. 14.8 Emergency drain
Because of a malfunction, the appliance cannot drain the water.
If this occurs, do steps (1) through (9) of
'Cleaning the drain filter'. If necessary,
clean the pump.
When you drain the water with the
emergency drain procedure, you must
activate again the drain system:
1. When you drain the water with the
emergency drain procedure, you
must activate again the drain system:
Put 2 litres of water in the main wash
compartment of the detergent
dispenser.
2. Start the programme...

• - No communication between
electronic elements of the appliance.
Switch off and switch on again.
•
 - The anti-flood device is on.
Disconnect the appliance and close
the water tap. Contact the Authorised Service Centre.
WARNING!
Deactivate the appliance
before you do the checks.15.2  Possible failuresProblemPossible solutionThe programme does
not start.Make sure that the mains plug is connected to the mains sock-
et. Make sure that the appliance door is closed. Make sure that there is not a damaged...

ProblemPossible solution Set the drain programme if you set an option which ends with
water in the tub.The spin phase does not
operate or the washing
cycle lasts longer than
usually.Set the spin programme. Make sure that the drain filter is not clogged. Clean the filter, if
necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase
again. This problem may be caused by balance problems.There is water on the
floor.Make sure that the couplings of the water...