AEG Freestanding washer dryer L76685NWD User Manual
Have a look at the manual AEG Freestanding washer dryer L76685NWD User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 513 AEG manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
ProblemPossible solution Set the drain or the spin programme if there is water in the drum.Make sure that the appliance receives electrical power.This problem may be caused by a failure of the appliance. Contact the Authorised Service Centre. If you need to open the door, please read carefully «Emergency door opening».The appliance makes an unusual noise.Make sure the levelling of the appliance is correct. Refer to 'In- stallation'. Make sure that the packaging and/or the transit bolts are re- moved. Refer to 'Installation'. Add more laundry in the drum. The load may be too small.The cycle is shorter than the time displayed.The appliance calculates a new time according to the laundry load. See the ‘Consumption Values’ chapter.The cycle is longer than the time displayed.An unbalanced laundry load increases the duration time. This is a normal behaviour of the appliance.The washing results are not satisfactory.Increase the detergent quantity or use a different detergent. Use special products to remove the stubborn stains before you wash the laundry. Make sure that you set the correct temperature. Decrease the laundry load.You cannot set an op- tion.Make sure that you press only the wanted button(s).The appliance does not dry or does not dry cor- rectly.Turn the water tap on.Make sure the drain filter is not clogged.Reduce the laundry load.Make sure you have set the correct cycle. if necessary ,set again a short drying time.The laundry is full of dif- ferent colours fluff.The fabrics washed in the previous cycle released fluff of a dif- ferent colour: • The drying phase helps to eliminate some fluff. • Clean the clothes with a fluff remover. In case of an excessive amount of fluff in the drum run the spe- cial programme to clean it (refer to “Fluff in the fabrics" for more details).ENGLISH31
After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Authorised Service Centre. If the display shows other alarm codes. Deactivate and activate the appliance. If the problem continues, contact the Authorised Service Centre.15.3 Emergency door opening In case of power failure or functioning failure the appliance door remainslocked. The washing programme continues when the power is restored. If the door remains locked in case of failure, it is possible to open it using the emergency unlock function. Before opening the door:CAUTION! Make sure that the water temperature is not too high and the laundry is not hot. If necessary, wait until they cool down.CAUTION! Make sure that the drum is not rotating. If necessary, wait until the drum stops rotating.Make sure that the water level inside the drum is not too high. If necessary, proceed with an emergency drain (refer to «Emergency drain» in «Care and cleaning» chapter).To open the door, proceed as follows: 1. Press the On/Off button to switch the appliance off. 2. Disconnect the mains plug from the mains socket. 3. Open the filter flap. 4. Keep the emergency unlock trigger pulled downward and, at the same time, open the appliance door. 5. Take out the laundry and then close the appliance door. 6. Close the filter flap. 16. TECHNICAL DATADimensionWidth/ Height/ Depth/ Total depth600 mm/ 850 mm/ 605 mm/ 639 mmElectrical connectionVoltage Overall power Fuse Frequency230-240 V 2200 W 13 A 50 HzLevel of protection against ingress of solid particles and moisture ensured by the protective cover, ex- cept where the low voltage equipment has no pro- tection against moistureIPX4www.aeg.com32
Water supply pressure1)Minimum Maximum0,5 bar (0,05 MPa) 8 bar (0,8 MPa)Maximum wash loadCotton8 kgMaximum dry loadCotton Synthetics6 kg 3 kgSpin SpeedMaximum1600 rpm1) The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar). If you cannot connect the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your domestic cold water storage system. Make sure not to exceed a distance of 5.02 m (16.5 ft) between the appliance inlet hose and the bottom of the water storage tank.17. ENVIRONMENTAL CONCERNSRecycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliancesmarked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. * ENGLISH33