AEG Freestanding refrigerator S63300KDW0 User Manual

HELPFUL HINTS AND TIPS
NORMAL OPERATING
SOUNDS
• You may hear a faint gurgling and a
bubbling sound when the refrigerant is
pumped through the coils or tubing.
This is correct.
• When the compressor is on, the refrig-
erant is being pumped around and you
will hear a whirring sound and a pulsat-
ing noise from the compressor. This is
correct.
• The thermic dilatation might cause a
sudden cracking noise. It is natural, not
dangerous physical phenomenon. This
is correct.
• When the compressor switches on...

CARE AND CLEANING
CLEANING THE INTERIOR
Before using the appliance for the first
time, wash the interior and all internal ac-
cessories with lukewarm water and some
neutral soap so as to remove the typical
smell of a brand-new product, then dry
thoroughly.
Do not use detergents or abrasive
powders, as these will damage
the finish.
CAUTION!
Unplug the appliance before car-
rying out any maintenance opera-
tion.
This appliance contains hydrocar-
bons in its cooling unit; mainte-
nance and recharging must...

TROUBLESHOOTING
During operation of the appliance some
smaller but annoying trouble can often
occur, which does not require calling a
technician out. In the following chart infor-
mation is given about them to avoid un-
necessary charges on service.
The operation of the appliance
goes with certain sounds (com-
pressor and circulating sound).
This not means a trouble, but a
normal operation.
The appliance operates discontin-
uously, so the stopping of com-
pressor does not mean being no
current. That is...

ProblemPossible causeSolution
 Food prevent that water
flows into the water collec-
tor.Make sure that food do not
touch the rear plate.
Water flows on the
ground.The melting water outlet
does not flow in the evap-
orative tray above the
compressor.Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
cold.The Temperature regula-
tor may be set incorrectly.Set a warmer temperature.
The temperature in
the appliance is too
warm.The Temperature regula-
tor may be...

REPLACING THE LAMP
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter .
CLOSING THE DOOR
1.Clean the door gaskets.
2.If necessary, adjust the door. Refer to
"Installation".
3.If necessary, replace the defective
door gaskets. Contact the Service
Center.
(1*/,6+15 

INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
POSITIONING
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
classAmbient temperature
SN+10°C to + 32°C
N+16°C to + 32°C
ST+16°C to + 38°C
T+16°C to + 43°C
LOCATION
AB
100 mm
min 20 mm
The appliance should be installed well
away from...

ELECTRICAL CONNECTION
AB
C
D ECAUTION!
Any electrical work required to in-
stall this appliance should be car-
ried out by a qualified electrician
or competent person.
WARNING!
This appliance must be earthed.
The manufacturer declines any lia-
bility should these safety meas-
ures not be observed.
The wires in the mains lead are
coloured in accordance with the
following code:
A-Green and Yellow: Earth
C- Brown: Live
E- Blue: Neutral
As the colours of the wires in the mains
lead of this appliance may not...

REAR SPACERS
2
431You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1.Release the screw.
2.Engage the spacer below the screw.
3.Turn the spacer to the right position.
4.Tighten again the screws.
LEVELLING
Accurate levelling prevents the vibration
and noise of the appliance during opera-
tion. To adjust the height of the appliance
loosen or tighten the two adjustable front
feet.
DOOR REVERSIBILITY
3
4
15 2
To carry out the following opera-
tions, we suggest...

2
1
• Unscrew the upper pin and screw it on
the opposite side.
• Refit the door.
• Make sure the edge of the door is par-
allel with the edge of the top.
A
B
• Unscrew the pin (A) and screw it on the
opposite side.
• Remove the cap (B) and position it on
the opposite side.
• Screw the lower hinges.
• Refit the plinth.
• Stand the appliance upright.
• Fit the handle on the opposite side and
put the plastic caps (contained in the
instructions bag) in the free holes.
• Do a final check to make sure that:
–...

NOISES
There are some sounds during normal
running (compressor, refrigerant circula-
tion).
BRRR! HISSS!
CLICK!
BLUBB!
CRACK!
SSSRRR!
OK
CLICK!CLICK!
BRRR!
BRRR!
BLUBB!BLUBB!
20www.aeg.com