AEG Freestanding fridge freezer S83520CMW2 User Manual

							ProblemPossible causeSolutionA square symbol is shown
instead of numbers on the
Temperature Display.Temperature sensor prob-
lem.Contact the nearest Author-
ised Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).The lamp does not work.The lamp is in stand-by.Close and open the door.The lamp does not work.The lamp is defective.Contact the nearest Author-
ised Service Centre.The compressor operates
continually.Temperature is set incor-
rectly.Refer to "Operation" chapter. Many food products were
put in at the same time.Wait some hours and then
check the temperature again. The room temperature is
too high.Refer to climate class chart on
the rating plate. Food products placed in
the appliance were too
warm.Allow food products to cool to
room temperature before stor-
ing.The FROSTMATIC function
is switched on.Refer to "FROSTMATIC func-
tion".The COOLMATIC function
is switched on.Refer to "COOLMATIC func-
tion".The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.This is normal, no error has
occurred.The compressor starts after a
period of time.The compressor does not
start immediately after
pressing the COOLMATIC,
or after changing the tem-
perature.This is normal, no error has
occurred.The compressor starts after a
period of time.Water flows inside the re-
frigerator.The water outlet is clog-
ged.Clean the water outlet.Food products prevent that
water flows into the water
collector.Make sure that food products
do not touch the rear plate.Water flows on the floor.The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.Attach the melting water out-
let to the evaporative tray.ENGLISH11 
						

							ProblemPossible causeSolutionTemperature cannot be set.The FROSTMATIC or
COOLMATIC function is
switched on.Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".DEMO appears on the dis-
play.The appliance is in demon-
stration mode.Keep the mode key pressed
for approximately 10 seconds
until a long sound is heard and
display shuts off for a short
time.The temperature in the ap-
pliance is too low/too high.The temperature regulator
is not set correctly.Set a higher/lower tempera-
ture.The food products' temper-
ature is too high.Let the food products temper-
ature decrease to room tem-
perature before storage.Many food products are
stored at the same time.Store less food products at the
same time.The FROSTMATIC function
is switched on.Refer to "FROSTMATIC func-
tion".The COOLMATIC function
is switched on.Refer to "COOLMATIC func-
tion".If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.6.2  Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised Service Centre.7.  INSTALLATIONWARNING!
Refer to Safety chapters.7.1  Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
classAmbient temperatureSN+10°C to + 32°CN+16°C to + 32°CST+16°C to + 38°CT+16°C to + 43°Cwww.aeg.com12   
						

							7.2 Electrical ConnectionCAUTION!
Any electrical work required to install this appliance
should be carried out by a
qualified electrician or
competent person.WARNING!
This appliance must be
earthed.
The manufacturer declines
any liability should these
safety measures not be
observed.
The wires in the mains lead are coloured
in accordance with the following code:
• A - green and yellow: Earth
• C - brown: Live
• D - blue: Neutral
As the colours of the wires in the mains
lead of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug,
proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either
with the letter “E“ or by the earth
symbol 
 or coloured green and
yellow.
2. Connect the wire coloured blue to
the terminal either marked with the
letter “N“ or coloured black.
3. Connect the wire coloured brown to
the terminal either marked with the
“L“ or coloured red.
4. Check that no cut, or stray strands of
wire is present and the cord clamp
( E ) is secure over the outer sheath.
Make sure the electricity supply
voltage is the same as that indicated on the appliance rating plate.
5. Switch on the appliance.
The appliance is supplied with a 13 amp
fuse ( B). In the event of having to change
the fuse in the plug supplied, a 13 amp
ASTA approved (BS 1362) fuse must be
used.WARNING!
A cut off plug inserted into a
13 amp socket is a serious
safety (shock) hazard. Ensure
that it is disposed of safely.7.3  Installation and replacing
of the CLEANAIR CONTROL
filter
On delivery the carbon filter is in a plastic
bag to preserve performance. The filter
should be placed in the drawer before
the appliance is turned on.
1. Open the drawer.
2. Take the filter out of the plastic bag.
3. Insert the filter in the drawer.
4. Close the drawer.
To get the best performance the carbon
air filter should be changed once every year.
New active air filters can be purchased
from your local dealer.
The air filter is a consumable
accessory and as such is not
covered by the guarantee.ENGLISH13  A BC D E      
						

							7.4 Installation of the
appliance and door reversalPlease refer to separate
instructions on installation
(ventilation requirements,
levelling) and door reversal.8.  TECHNICAL DATAHeight1840 mmWidth595 mmDepth642 mmRising time17 hVoltage230 - 240 VFrequency50 Hz
The technical information is situated in
the rating plate, on the external or
internal side of the appliance and in the energy label.
9.  ENVIRONMENT CONCERNSPlease recycle all materials marked with
the symbol 
. Dispose of all packaging
materials appropriately and help to
protect the environment, and future
generations. Do not dispose of electrical
equipment marked with the 
 symbol
along with the general house hold waste.
Dispose all electrical goods via
applicable local authority collections, or
at local authority or, commercial
recycling centres.
*
www.aeg.com14    
						

							ENGLISH15 
						

							www.aeg.com/shop280155861-A-122016