AEG Freestanding fridge freezer S53520CTX2 User Manual

• it is advisable to show the freezing indate on each individual pack toenable you to keep tab of the storagetime.6.6  Hints for storage of frozen
food
To obtain the best performance from this
appliance, you should:
• make sure that the commercially frozen foodstuffs were adequatelystored by the retailer;
• be sure that frozen foodstuffs are transferred from the foodstore to the
freezer in the shortest possible time;
• not open the door frequently or leave it open longer than absolutely
necessary;
• once...

4.If accessible, clean the condenser
and the compressor at the back of the appliance with a brush.
This operation will improve the
performance of the appliance and save
electricity consumption.7.5  Defrosting of the
refrigerator
Frost is automatically eliminated from the
evaporator of the refrigerator
compartment every time the motor compressor stops, during normal use.
The defrost water drains out through atrough into a special container at the
back of the appliance, over the motor
compressor, where it...

ProblemPossible causeSolution There is no voltage in the
mains socket.Connect a different electrical
appliance to the mains sock-
et. Contact a qualified elec-
trician.The appliance is noisy.The appliance is not suppor-
ted properly.Check if the appliance
stands stable.The lamp does not work.The lamp is in stand-by.Close and open the door.The lamp does not work.The lamp is defective.Contact the nearest Author-
ized Service Centre.The compressor operates
continually.Temperature is set incorrect-
ly.Refer...

ProblemPossible causeSolutionTemperature cannot be set.The FROSTMATIC or COOL-
MATIC function is switched
on.Switch off FROSTMATIC or 
COOLMATIC manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "FROST-
MATIC or COOLMATIC
function".Door is misaligned or inter-
feres with ventilation grill.The appliance is not level-
led.Refer to "Levelling".The temperature in the ap-
pliance is too low/too high.The temperature regulator is
not set correctly.Set a...

Climate
classAmbient temperatureN+16°C to + 32°CST+16°C to + 38°CT+16°C to + 43°CSome functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only
be guaranteed within the
specified temperature
range. If you have any
doubts regarding where to
install the appliance, please
turn to the vendor, to our
customer service or to the
nearest Service Centre9.2  Location
The appliance should be installed well
away from sources of heat such as...

As the colours of the wires in the mains
lead of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug,
proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either
with the letter “E“ or by the earth
symbol 
 or coloured green and
yellow.
2. Connect the wire coloured blue to
the terminal either marked with the
letter “N“ or coloured black.
3. Connect the wire coloured brown to
the terminal either marked with the
“L“ or...

3.Remove the door from the middle
hinge pivot (2).
4. Place the cover of the upper hinge
into the holes on the opposite side.
5. Screw off the screws of the middle
hinge (3).
6. Remove the plugs on the upper side
of both doors and move them to the
other side.
7. Remove the lower door from the
lower hinge pivot (4).
8. Screw off the pivot of the lower hinge
(5) and screw the lower hinge pivot
(6) into the left drill of the lower
hinge.
9. Screw off the screws of the lower
hinge and remove the hinge (8)....

17.Attach the door handles and plugs
on the opposite side.
Do a final check to make
sure that:
• All screws are tightened. • The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
If the ambient temperature
is cold (i.e. in Winter), the
gasket may not fit perfectly
to the cabinet. In that case,
wait for the natural fitting of
the gasket. In case you do
not want to carry out the
above mentioned
operations, contact the
nearest After Sales Service
Force. The After Sales
Service...

The technical information are situated in
the rating plate, on the external orinternal side of the appliance and in the energy label.11.  ENVIRONMENTAL CONCERNSRecycle the materials with the symbol .
Put the packaging in applicable
containers to recycle it. Help protect the
environment and human health and to recycle waste of electrical and electronic
appliances. Do not dispose appliances
marked with the symbol 
 with the
household waste. Return the product to
your local recycling facility or contact...

www.aeg.com/shop280152963-A-512013