AEG Freestanding freezer A72710GNW0 User Manual

CAUTION!
Unplug the appliance before car-
rying out any maintenance oper-
ation.
This appliance contains hydrocar-
bons in its cooling unit; mainte-
nance and recharging must
therefore only be carried out by
authorized technicians.
6.2 Periodic cleaning
The equipment has to be cleaned regu-
larly:
• clean the inside and accessories with
lukewarm water and some neutral
soap.
• regularly check the door seals and
wipe clean to ensure they are clean
and free from debris.
• rinse and dry thoroughly.
Do not...

ProblemPossible causeSolution
The buzzer sounds.
The Alarm icon flash-
ing.The temperature in the
freezer is too high.Refer to "HighTempera-
ture Alarm".
 The door is not closed
correctly.Refer to "Door open
alarm".
 upper or lower
square is shown in
the temperature dis-
play.An error has occurred in
measuring the tempera-
ture.Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not
be possible).
“dEMo” appears...

ProblemPossible causeSolution
The temperature in
the freezer is too
warm.Food is too near to each
other.Store food so that there is
cold air circulation.
 Large quantities of food
to be frozen were put in
at the same time.Insert smaller quantities of
food to be frozen at the
same time.
The appliance does
not operate.The appliance is switched
off.Switch on the appliance.
 The mains plug is not
connected to the mains
socket correctly.Connect the mains plug to
the mains socket correctly.
 The appliance has...

8.2 Location
AB
100 mm
min 20 mm
The appliance should be installed well
away from sources of heat such as radia-
tors, boilers, direct sunlight etc. Ensure
that air can circulate freely around the
back of the cabinet. To ensure best per-
formance, if the appliance is positioned
below an overhanging wall unit, the min-
imum distance between the top of the
cabinet and the wall unit must be at least
100 mm . Ideally, however, the appliance
should not be positioned below over-
hanging wall units. Accurate...

8.3 Electrical Connection
AB
C
D ECAUTION!
Any electrical work required to
install this appliance should be
carried out by a qualified electri-
cian or competent person.
WARNING!
This appliance must be earthed.
The manufacturer declines any li-
ability should these safety meas-
ures not be observed.
The wires in the mains lead are
coloured in accordance with the
following code:
A-Green and Yellow: Earth
C- Brown: Live
E- Blue: Neutral
As the colours of the wires in the mains
lead of this appliance may...

8.4 Rear spacers
2
431You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1.Release the screw.
2.Engage the spacer below the screw.
3.Turn the spacer to the right position.
4.Tighten again the screws.
8.5 Levelling
Accurate levelling prevents the vibration
and noise of the appliance during opera-
tion. To adjust the height of the appli-
ance loosen or tighten the two adjusta-
ble front feet.
16www.aeg.com 

8.6 Door reversibility
1 2
3
8 6
7
To carry out the following opera-
tions, we suggest that this be
made with another person that
will keep a firm hold on the doors
of the appliance during the oper-
ations.
To change the opening direction of the
door, do these steps:
• Remove the plug from the power
socket.
• Tilt back the appliance carefully so
that the compressor cannot touch the
floor.
• Remove the plinth (1).
• Remove the cap (2) and position it on
the opposite side.
• Unscrew the hinge (3) and...

1
23
6
5
4
• Remove the handle. Unscrew the top
handle bracket from the handle rod
(1). Unscrew the bottom handle brack-
et from the door (2)
• Unscrew the top handle bracket from
the door (3).
• Re-screw the handle bracket on the
door (4). Turn the handle bracket with
the handle and screw them to the
door (5) and the fitted handle bracket
(6)
• Re-insert the door on the lower hinge
pivot .
• Re-insert the door on the upper hinge
pivot slightly tilting the door.
• Screw the lower hinges.
• Stand the...

CLICK!CLICK!
BRRR!
BRRR!
BLUBB!BLUBB!
HISSS!
HISSS!
ENGLISH19 

SSSRRR!SSSRRR!
CRACK!
CRACK!
10. TECHNICAL DATA
   
Dimension  
 Height1850 mm
 Width600 mm
 Depth660 mm
Rising Time 20 h
Voltage 230-240 V
Frequency 50 Hz
The technical information are situated in
the rating plate on the internal left side
of the appliance and in the energy label.
11. ENVIRONMENT CONCERNS
Recycle the materials with the
symbol  . Put the packaging in
applicable containers to recycle it.Help protect the environment and
human health and to recycle waste
of electrical and electronic...