AEG Freestanding freezer A72020GNW0 User Manual

ENUser ManualFreezerA72020GNW0A72020GNX0    

CONTENTS
1. SAFETY INFORMATION.................................................................................................3
2.  SAFETY INSTRUCTIONS................................................................................................ 4
3.  CONTROL PANEL........................................................................................................... 5
4.  DAILY...

1.  SAFETY INFORMATION
Before the installation and use of the appliance,carefully read the supplied instructions. The manufacturer is not responsible for any injuries ordamages that are the result of incorrect installation or
usage. Always keep the instructions in a safe and
accessible location for future reference.
1.1  Children and vulnerable people safety
•This appliance can be used by children aged 8 years
and above and by persons with reduced capabilities
provided that they have been given...

•Do not use water spray and steam to clean the
appliance.
• Clean the appliance with a moist soft cloth. Only use
neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects.
• Do not store explosive substances such as aerosol
cans with a flammable propellant in this appliance.
• If the supply cord is damaged, it must be replaced by
the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard.2.  SAFETY INSTRUCTIONS2.1...

• Do not change the specification ofthis appliance.
• Do not put electrical appliances (e.g. ice cream makers) in the applianceunless they are stated applicable bythe manufacturer.
• Be careful not to cause damage to the refrigerant circuit. It contains
isobutane (R600a), a natural gas with a
high level of environmental
compatibility. This gas is flammable.
• If damage occurs to the refrigerant circuit, make sure that there are no
flames and sources of ignition in the
room. Ventilate the room.
• Do not...

3.1 Switching on
1. Plug the appliance into electrical
mains socket.
2. To turn on the appliance, touch the
temperature key until all LED
indicators light up.After approximately 3
seconds LED indicators fade
and the temperature is set
to the default setting (ECO
mode). Only the
temperature key and LED
indicator next to ECO mode
icon illuminate.3.2  Switching off
1.To switch off the appliance press the
temperature key for 3 seconds.
All LED indicators turn off.
2. To disconnect the appliance from the...

You can deactivate this
alarm by closing the door or
by pressing the temperature
key.3.8  High temperature alarm
An increase in the temperature in the
appliance (for example due to an earlier
power failure or opening of the door)
activates the high temperature alarm.
The LED indicator of the currently set
temperature flashes and the sound is on.When normal conditions are
restored, the high
temperature alarm
deactivates. You can switch
off this alarm by pressing the
temperature key.4.  DAILY USEWARNING!...

5. CARE AND CLEANINGWARNING!
Refer to Safety chapters.5.1  Cleaning the interior
Before using the appliance for the first
time, the interior and all internal
accessories should be washed with
lukewarm water and some neutral soap
to remove the typical smell of a brand- new product, then dried thoroughly.
CAUTION!
Do not use detergents,
abrasive powders, chlorine
or oil-based cleaners as they
will damage the finish.5.2  Periodic cleaningCAUTION!
Do not pull, move or damage any pipes and/or
cables inside...

ProblemPossible causeSolutionThe temperature in the ap-
pliance is too high.Refer to "Door Open
Alarm"or "High Temperature
Alarm".The compressor operates
continually.Temperature is set incor-
rectly.Refer to "Operation" chapter. Many food products were
put in at the same time.Wait some hours and then
check the temperature again. The room temperature is
too high.Refer to climate class chart on
the rating plate. Food products placed in
the appliance were too
warm.Allow food products...

7. INSTALLATIONWARNING!
Refer to Safety chapters.7.1  Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
classAmbient temperatureSN+10°C to + 32°CN+16°C to + 32°CST+16°C to + 38°CT+16°C to + 43°C7.2  Electrical ConnectionCAUTION!
Any electrical work required to install this appliance
should be carried out by a
qualified electrician or
competent person.WARNING!...