AEG Condenser dryer T61275AC User Manual

 OptionsProgrammes 1)DelicateAnti-creasePillows 2) Delicates 2)Synthetics; Extra DrySynthetics; Cupboard DrySynthetics; Iron DryEasy Iron 2)MicrofiberTime 60’Time 30’1) Together with the programme you can set 1 or more options.
2)  Activated by default.6.2  Consumption DataProgrammeSpun at / residual humidityDrying timeEnergy
consump- tionCottons 7 kgCupboard Dry1400 rpm / 50%111 min.3,75 kWh 1000 rpm / 60%126 min.4,27 kWhIron Dry1400 rpm / 50%92 min.3,04 kWh 1000 rpm / 60%105 min.3,46 kWhSynthetics 3...

7.2 Buzzer
When the buzzer option is activated you
can hear the buzzer at the:
• cycle end
• anti-crease phase start and end
• cycle interruption
The buzzer option is by default always on. You can use this function to activateor deactivate the sound.You can activate the Buzzer
option with all programmes.7.3  Anti-crease
Extends anti-crease phase (30 minutes) at
the end of the drying cycle to 90
minutes. This option prevents laundry from creases. Laundry can be removedduring the anti-crease phase.
7.4...

Fabric labelDescriptionLaundry that is applicable for tumble dryer. Set the programme with
standard temperature.Laundry that is applicable for tumble dryer. Set the programme with
low temperature.Laundry that is not applicable for tumble dryer.9.2  Loading the laundryCAUTION!
Do not lock the laundry in
between the appliance door
and rubber seal.
1. Pull the appliance door.
2. Load loosely the laundry.
3. Close the appliance door.
9.3  Turning on the appliance
To turn on the appliance:
Push the On/Off...

9.7 Child lock option
The child lock can be set to prevent the
children to play with the appliance. The
child lock option locks all push buttons
and the programme dial (this option
does not lock  On/Off button).
You can activate the child lock option:
• before you push the  Start/Pause
button - the appliance cannot start
• after you push the  Start/Pause button
- programmes and option selection is off.Child lock option activation:
1. Turn on the dryer.
2. Wait approximately 8 seconds.
3. Select 1 of the...

10.2 Adjustment of the
remaining laundry moisture
degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the  Delicate and Anti-crease
buttons.
One of the symbols goes into the view
on the display:
 - the maximum dry laundry
 - the more dry laundry
 - the standard dry laundry
5. Push the  Start/Pause  button again
and again until you set necessary...

5.If necessary remove fluff from the
filter socket and gasket. You can use a vacuum cleaner. Put the filter inside
the filter socket.
11.2  Draining the water
container
Drain the condensed water container after each drying cycle.
If the condensed water container is full,
the programme breaks off automatically.
The indicator  Tank is on and you must
drain the water container.
To drain the water container:
1. Pull the water container and keep it
in horizontal position.
2. Move the plastic connection out...

5.Catch the handle and pull the
condenser out from the bottom
compartment. Move condenser
horizontally to do not spill remaining
water.
6. Clean the condenser in vertical
position over a basin or paddling.
Rinse through with a hand shower.
7. Put the condenser back inside the
bottom compartment.
8. Close the condenser cover.
9. Lock 2 blockages until they snap.
10. Close the condenser door.11.4  Cleaning the drumWARNING!
Disconnect the appliance
before you clean it.
Use a standard neutral soap detergent...

12. TROUBLESHOOTINGProblem 1)Possible causeRemedy
The tumble dry-
er does not op-
erate.
The tumble dryer is not connected
to mains supply.Connect in at mains socket. Check
fuse in fuse box (domestic installa-
tion).The loading door is opened.Close the loading door.The On/Off button was not push-
ed.Push the On/Off button.The Start/Pause button was not
pushed.Push the Start/Pause button.The appliance is in the standby
mode.Push the On/Off button.
Unsatisfactory
drying result.
Incorrect programme...

Problem 1)Possible causeRemedyAbnormally
elapsing time on
the display.The time to end is calculated on
the basis of the volume and damp-
ness of the laundry.The automatic procedure — this is
not the appliance malfunction.Programme in-
active.The water container is full.Drain the water container, push
the Start/Pause button. 3)
Drying cycle too
short.
Too small laundry volume.Do the selection of time pro-
gramme. The time value must be
related to the load. To dry 1 item
or small quantities of the laundry...

Necessary fuse13 ATotal power2800 WEnergy efficiency classBEnergy consumption1)4,27 kWhAnnual energy consumption2)504 kWhLeft—on mode power absorption0,41 WOff mode power absorption0,41 WType of useHouseholdPermitted ambient temperature+ 5°C to + 35°CLevel of protection against ingress of solid
particles and moisture ensured by the pro-
tective cover, except where the low voltage equipment has no protection against mois-
tureIPX41)  With reference to EN 61121. 7kg of cotton centrifuged at 1000 rpm.
2)...