AEG Condenser dryer T61270AC User Manual

							1.Push the On/Off button for 2 sec-
onds to deactivate the appliance.
2.Open the appliance door.
3.Remove the laundry.
4.Close the appliance door.
After each drying cycle:• clean the filter
• drain the water container
(See chapter CARE AND CLEANING.)
8. HINTS AND TIPS
8.1 Ecological hints
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry
becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If necessary
clean the condensate before (e.g. with
a coffee filter) to remove possible
small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Use the load volumes specified in the
programmes chapter.
• Make sure that is good airflow in the
appliance installation position.
• Clean the filter after each drying cycle.
• Spin good the laundry before drying.
8.2 Water hardness and
conductivity
Water hardness can be different for dif-
ferent locations. Water hardness has an
effect on the water conductivity and the
operation of the conductivity sensor in
the appliance. If you know the value of
the water conductivity you can adjust the
sensor to dry with the better results.
To change the sensor conductivity:
1.Turn the programme dial to availa-
ble programme.
2.Push at the same time the Delicate
and Anticrease buttons and hold
down until one of the these symbols
go into view on the display:
–
 low conductivity 600
μS/cm
3.Push the Start Pause button again
and again until you set necessary
level.
4.To memorise setting push at the
same time the Delicate and Anti-
crease buttons.
8.3 Water container full —
indication
By default the indication LED is always
on. It comes into the view at the end of
the cycle or when the water container is
full. When you use an external equip-
ment to drain the container, the LED can
be off.
To activate or deactivate the indication:
1.Turn the programme dial to availa-
ble programme.
2.Push at the same time the Delicate
and Delay Start buttons and hold
down until you see the correct set-
ting:
– the LED is off and the symbol
 goes into the view - The
LED is permanently off
– the LED is on and the symbol
 goes into the view - The
LED is activated
ENGLISH11 
						

							9. CARE AND CLEANING
9.1 Cleaning the filter
At the end of each cycle the filter LED is
on to tell you that the filter must be
cleaned.
The filter collects the fluff. The
fluff occurs while the cloths are
dried in the tumble dryer.
To clean the filter:  
1.Open the door.
2.Pull the filter.
3.Open the filter.
4.Use a moist hand to clean the filter.
5.If necessary clean the filter with
warm water using a brush.
Close the filter.
12www.aeg.com 
						

							 6.Remove fluff from the filter socket.
For this a vacuum cleaner can be
used.
7.Put the filter inside the filter socket.
CAUTION!
Do not operate the tumble dryer
without the filter or with dam-
aged or blocked filter.
Clean the filter after each drying
cycle. Clogged filter increases
the cycle time and causes higher
energy consumption.
9.2 Draining the condensed
water container
Drain the condensed water container af-
ter each drying cycle.If the condensed water container is full,
the programme breaks off automatically
and the drain the condensed water con-
tainer LED is on. To continue the pro-
gramme, drain the condensed water
container and press the start button.
To drain the condensed water
container automatically you can
install draining accessory (see
chapter: ACCESSORIES)
To drain the condensed water container:  
1.Pull the condensed water container
and keep it in horizontal position.
2.Move the plastic connection out and
drain the condensed water container
into a sink or equivalent receptacle.
3.Move plastic connection in and in-
stall water container.
WARNING!
Risk of poisoning. The con-
densed water is not applicable to
drink or to prepare food.
The condensed water can be
used as distilled water, e.g. for
steam ironing. If necessary filter
the condensed water (e.g. with a
coffee filter) to remove possible
residue and small pieces of fluff.
9.3 Cleaning the condenser
If the condenser LED is on, the condens-
er must be cleaned.
ENGLISH13 
						

							To clean the condenser:  
1.Open the loading door.
2.Move the release button on the bot-
tom of the door opening and open
the condenser door.
3.Turn the 2 blockages to unlock the
condenser lid.
4.Lower the condenser lid.
5.Catch the handle and pull the con-
denser out from the bottom com-
partment. Move condenser horizon-
tally to do not spill remaining water.
14www.aeg.com 
						

							6.Clean the condenser in vertical posi-
tion over a basin or paddling. Rinse
through with a hand shower.
 
7.Put the condenser back inside the
bottom compartment.
 
8.Close the condenser lid.
 
9.Lock the 2 blockages until they snap.
 
10.Close the condenser door.
CAUTION!
Do not operate the tumble dryer
when the condenser is blocked
with fluff. This could cause the
damage to the tumble dryer. This
also increases energy consump-
tion.
Do not use sharp objects to
clean the condenser. The dam-
aged condenser could cause
leaks.
Do not operate the tumble dryer
without the condenser.
9.4 Cleaning the drum
WARNING!
Disconnect the appliance before
you clean it.
Use a standard neutral soap detergent
to clean the inner surface of the drumand drum ribs. Dry the cleaned surfaces
with a soft cloth.
CAUTION!
Do not use abrasive materials or
steel wool to clean the drum.
9.5 Cleaning the control panel
and housing
Use a standard neutral soap detergent
to clean the control panel and housing.
Use a moist cloth to clean. Dry the
cleaned surfaces with a soft cloth.
CAUTION!
Do not use furniture cleaning
agents or cleaning agents which
can cause corrosion to clean the
appliance.
10. TROUBLESHOOTING
10.1 Troubleshooting
Problem1)Possible causeRemedy
The tumble
dryer does
not operate.The tumble dryer is not con-
nected to mains supply.Connect in at mains socket.
Check fuse in fuse box (domes-
tic installation).
ENGLISH15 
						

							The loading door is opened.Close the loading door.
The On/Off button was not
pushed.Push the On/Off button.
The Start/Pause button was not
pushed.Push the Start/Pause button.
The appliance is in the standby
mode.Push the On/Off button.
Unsatisfac-
tory drying
results.
Incorrect programme selection.Do the selection of the applica-
ble programme. 2)
The filter is clogged.Clean the filter. 3)
The condenser is clogged.Clean the condenser. 3)
Too high volume of the load.Obey the maximum load vol-
ume.
The airflow grill is clogged.Clean the airflow grill in the
bottom of the appliance.
Dirt on the inner surface of the
drum.Clean the inner surface of the
drum.
Too high water hardness.Set applicable water hard-
ness4).
The door
does not
close.The filter not locked in the po-
sition.Put the filter in the correct posi-
tion.
The laundry is locked between
the door and the seal.Put the load correctly in the
drum.
Err (Error)
on the dis-
play.
You try to change the pro-
gramme or the function after
the start of the cycle.Turn the tumble dryer off and
on. Make the new selection.
The function you try to activate
is not applicable with the selec-
ted programme.Turn the tumble dryer off and
on. Make the new selection.
Abnormally
elapsing
time on the
display.
)
The time to end is calculated
on the basis of the volume and
dampness of the laundry.The automatic procedure —
this is not the appliance mal-
function.
Programme
inactive.The water container is full.Drain the water container3) ,
push the Start/Pause button.
Drying cycle
too short.
To small laundry volume.Do the selection of time pro-
gramme.
The laundry is too much dried.Do the selection of time pro-
gramme or higher drying level
(e.g. Extra Dry )
Drying cycle
too long 5)
The filter is clogged.Clean the filter.
Too high volume of the load.Obey the maximum load vol-
ume.
16www.aeg.com 
						

							The laundry not spun sufficient-
ly.Spin correctly the laundry.
Very high room temperature -
this is not the appliance mal-
function.If possible, lower the room
temperature.
1) 
If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on.
Make a selection of the new programme. Push the Start/Pause button. Does not
operate? - contact the service centre and give the error code.
2) 
follow the programme description — see PROGRAMMES chapter
3) 
see CARE AND CLEANING chapter
4) 
see section WATER HARDNESS in HINTS AND TIPS chapter
5) 
Note: After maximum 5 hours the drying cycle ends automatically (see Drying cycle
complete section).
11. TECHNICAL INFORMATION
height x width x depth850 x 600 x 540 mm (maximal 575 mm)
drum volume104 l
maximum depth with the load door
opened1030 mm
maximum width with the load door
opened950 mm
adjustable height850 mm (+ 15 mm - feet regulation)
the appliance weight37 kg
maximum load volume7 kg
voltage230-240 V
frequency50 Hz
necessary fuse13 A
total power2800 W
energy efficiency classB
energy consumption kWh/cycle 1)4,27 kWh
annual energy consumption2)504 kWh
left—on mode power absorption0,41 W
off mode power absorption0,41 W
type of useDomestic
permitted ambient temperature+ 5°C to + 35°C
1) 
7 kg of cotton, centrifuged at 1000 rpm with reference to EN 61121
ENGLISH17 
						

							2) 
Energy consumption per year in kWh, based on 160 drying cycles of the standard cotton
programme at full and partial load, and the consumption of the low-power modes.
Actual energy consumption per cycle will depend on how the appliance is used
(REGULATION (EU) No 392/2012).
12. INSTALLATION
12.1 Unpacking
CAUTION!
Before use all parts of the transport
packaging must be removed.
To remove the polystyrene blockages:
1.Open the load door.
2.Pull plastic hose with the polystyrene
blockages out from the drum.
It is possible to adjust the height of the
tumble dryer. To do that adjust the feet
(see picture).
15mm
12.2 Installation under a
counter
The appliance can be installed as free-
standing or below the kitchen counter
with correct space (see picture).
> 850 mm600 mm540 mm
12.3 The load door reversal
The load door can be installed by the
user in the opposite side. It can help to
easily put and remove the laundry or if
there is a limit to install the appliance.
(see separate leaflet).
13. ENVIRONMENT CONCERNS
Recycle the materials with the
symbol  . Put the packaging in
applicable containers to recycle it.Help protect the environment and
human health and to recycle waste
of electrical and electronic
18www.aeg.com 
						

							appliances. Do not dispose
appliances marked with the symbol 
with the household waste. Return theproduct to your local recycling
facility or contact your municipal
office.
ENGLISH19 
						

							www.aeg.com/shop
136926590-A-152013