ADT Security Services Gemini GEMRP8 User Manual

By pressing 
A
 followed by the the appropriate key, (do not press simultaneously) these special functions and 
features can be enabled: 
Easy Arm  (when system is disarmed) 
The Easy Arm feature allows the system to be armed by 
pressing 
A
 followed by 
0
.  This will allow the easy 
arming of the system by someone who is not a regular 
system user. 
 
 Easy Exit  (when system is armed) 
This function (if programmed) allows an occupant to leave 
the premises without disarming the system.  Pressing 
A...

12 
The Control Panel is constantly monitoring its own components, as well as all critical services, such as AC power and the 
telephone line, to insure that it is always ready to provide the protection for which it was designed.  When a system trouble does 
occur, it will caution you by lighting the TROUBLE H
 light and beeping the keypad buzzer.
 
If you cannot immediately clear the system trouble, the system can still be used.  Simply press 
A
 followed by 
4
 to view 
the trouble as described below,...

13  
Keypad Beeps or   
H
 Flashes 
Zone light  
ON 
System Trouble 
Condition 
Action 
2 Beeps 
2 
Fire Trouble  
A problem has  been detected in the Fire Circuit.   
Call installing company for service. 
2 Beeps 
3 
Wireless Receiver 
Trouble 
A problem has been detected with the wireless receiver. 
Call installing company for service. 
2 Beeps 
4 
Wireless Receiver Jam  
A problem has been detected with a wireless receiver. 
Call installing company for service.  
3 Beeps 
1-8 
Wireless Transmitter...

Your Installer has assigned a User 1 Code which can be used to not only Arm and Disarm the system, but also to enter the User 
Program Mode, where you can program other user codes.  The following explains how you will use this code to program or erase 
additional user codes.  Entering the User Program Mode        Press 
A
 followed by 
8
 and enter the User 1 code folowed by 
D.
  The Armed, Status and H lights will flash, and the 
keypad will beep 4 times.  You are now in the User Program mode.  Zones 1...

Ambush Code - In the event that you 
are forced by an intruder to disarm your 
system, this  special code can be used 
to disarm the system, and 
simultaneously send a silent alarm to 
Central Station. If your system has the 
Ambush feature enabled, the code 
assigned as the User 8 code will 
function as your Ambush Code.  Arming / Disarming - Turning the 
system on or off by entering your user 
code at the keypad, followed by
D.  
 Auto Interior Bypass - A feature which 
allows the system to recognize...

 
NAPCO LIMITED WARRANTY 
THE FOLLOWING STATEMENT IS REQUIRED BY THE FCC
. 
This equipment generates and uses radio-frequency energy and, if not installed and used properly, that 
is, in strict accordance with the manufacturers instructions, may cause interference to radio and 
television  
reception. It has been type tested and found to comply with the limits for a Class-B computing device in 
accordance with the specifications in Subpart J of Part 15 of FCC Rules, which are designed to provide...