Addonics Technologies SnapIn Mobile Rack AESN5DA35A User Manual

							Technical Support
If you need any assistance to get your unit functioning properly, please have 
your product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: 408-453-6212
Email: http://www.addonics.com/support/query/
T E C H N O L O G I E S
www.addonics.com
Snap-In Disk Array PRO
(AESN5DA35-A)
User Guide         
						

							www.addonics.com
Phone:   408-573-8580
Fax:     408-573-8588
Email:   http://www.addonics.com/sales/query/
CONTACT US
Overview
FrontRear
Door LockSATA Connectors
HDD LED On/Off SwitchFan High/Low Switch
Fan
Individual
Drive
Bay Door
Drive Power & 
Activity LED for Each Drive Bay Power Connector 1 Power Connector 2
Drive Power & Activity LED (each bay): Glows blue to indicate a drive is 
inserted and has power, blinks violet to indicate drive activity.
HDD LED On/Off Switch: On position allows Hard Disk LED signal to drive 
activity LED, Off position leaves activity LED off at all times.
Fan High/Low Switch: Controls cooling fan speed.
Power Connectors: Both connectors must be used, each with separate 
cables from the power supply.
Installation
Step 1. Unlock the drive bay door if necessary and tug gently on the handle. 
If a drive is seated in the bay, continue pulling gently on the door until the 
drive is unseated from the connectors. Do not use excessive force, this \
may 
break the door. Once the drive is unseated it may be pulled out.
Step 2. Insert drive with connectors toward the rear, as shown on the drive 
bay door label, until it stops. Do not force the drive into the bay any \
further.
Step 3. Gently close the door over the drive, pressing the drive into its fina\
l 
position in the bay until the door snaps shut.
Step 4. If desired, use the provided keys to lock the door closed.