ADDERLink XDVI PRO KVM Extender Manual

10
CONTENTS
INTRODUCTION
INSTALLATION
OPERATION
FURTHERINFORMATION
Power connection
1 Connect the output lead of the supplied power adapter to the socket labeled POWER 
on the remote module.   
X-DVIPRO: Output lead from the power adapter 
2 Insert the IEC connector of the separate power lead into the corresponding socket 
of the power adapter. Connect the other end of the power lead to a nearby mains 
socket.
3 After all connections are made, power up the monitor and remote module (then the 
local...

11
CONTENTS
INTRODUCTION
INSTALLATION
OPERATION
FURTHER
 
INFORMATION
Operation
Power and activity indicators
Each	module	provides	two	indicators	to	confirm	power	status	and	also	feedback	about	
the various input signals:   
GENERAL USE
In use, the X-DVIPRO and X-DVIPRO-MS2 modules should be transparent - the system 
and its peripherals should operate exactly as normal, the only difference being that they 
are now up to 50 meters apart. 
Video display (EDID) information
Extended	Display	Identification...

12
CONTENTS
INTRODUCTION
INSTALLATION
OPERATION
FURTHER
 
INFORMATION
This chapter contains a variety of information, including the following:
•	Troubleshooting - see right
•	Getting assistance
•	Safety information
•	Warranty
•	Radio frequency energy statements
Further information
TROUBLESHOOTING
If you experience problems when installing or using the X-DVIPRO/X-DVIPRO-MS2 
modules, please check through this section for a possible solution. If your problem is not 
listed here and you cannot resolve the...

13
CONTENTS
INTRODUCTION
INSTALLATION
OPERATION
FURTHER
 
INFORMATION
GETTING ASSISTANCE
If you are still experiencing problems after checking the information contained within this 
guide, then we provide a number of other solutions:
• Online solutions and updates – www.adder.com/support
 
Check the Support section of the adder.com website for the latest solutions and 
firmware	updates.
• Adder Forum – forum.adder.com
 
Use our forum to access FAQs and discussions.
• Technical support –...

14
CONTENTS
INTRODUCTION
INSTALLATION
OPERATION
FURTHER
 
INFORMATION
RADIO FREQUENCY ENERGY
A Category 6a (or better) twisted pair cable must be used to connect the units in order 
to maintain compliance with radio frequency energy emission regulations and ensure a 
suitably high level of immunity to electromagnetic disturbances.
All other interface cables used with this equipment must be shielded in order to maintain 
compliance with radio frequency energy emission regulations and ensure a suitably...

15
CONTENTS
INTRODUCTION
INSTALLATION
OPERATION
FURTHER
 
INFORMATION
www.ctxd.com Documentation by:
© 2014 Adder Technology Limited
All trademarks are acknowledged.
Part	No.	MAN-X-DVIPRO	•	Release	3.0a
Web:  www.adder.com
Contact:  www.adder.com/contact-details
Support: forum.adder.com