ADDERLink AV100 Manual





20


To zero the skew adjustment dials
When supplied, the two skew dials are set in 
their neutral positions. i.e. no delay to either 
of its colours. However, if the module has 
been previously used and adjusted then you 
may	need	to	relocate	the	zero	point.	There	are	
no setting markers around the two skew dials 
and the dial itself does not have a pointer.  
1	 Insert	a	small	screwdriver	into	the	skew	
dial and twist it all the way...





21


Further information
Troubleshooting
If	you	experience	problems	when	installing	or	using	the	AdderLink	AV	modules,	
please	check	through	this	section	for	a	possible	solution.	If	your	problem	is	not	
listed here and you cannot resolve the issue, then please refer to the ‘\
Getting 
assistance’	section.
No video image is received at the receiver module.
•		 Check	that	the	both	the	red	power	indicators	are	lit	on	both	the	transmitter	
and...





22


Safety information
•	 For	use	in	dry,	oil	free	indoor	environments	only.
•	 Do	not	use	to	link	between	buildings.
•	 Not	suitable	for	use	in	hazardous	or	explosive	environments	or	next	to	highly	
flammable materials.
•	 Ensure	that	all	twisted	pair	interconnect	cables	are	installed	in	compliance	
with all applicable wiring regulations. 
•	 Do	not	connect	the	CATx	link	interface	(RJ45	style	connector)	to	any	other	
equipment, particularly...





23


Products in the AdderLink AV range
The following items are available within the AdderLink AV product range:\
•		AdderLink AV100 pair (part number: ALAV100P) 
One	AdderLink	AV100	transmitter	and	one	AdderLink	AV100	receiver.	
•		AdderLink AV100 transmitter (part number: ALAV100T) 
Single AdderLink AV100 transmitter.
•		AdderLink AV100 receiver (part number: ALAV100R) 
Single AdderLink AV100 receiver.
•		AdderLink AV104 transmitter (part...





24


Emissions and Immunity
A Category 5 (or better) twisted pair cable must be used to connect th\
e 
modules in order to maintain compliance with radio frequency energy emis\
sion 
regulations and ensure a suitably high level of immunity to electromagne\
tic 
disturbances.
All other interface cables used with this equipment must be shielded in \
order 
to maintain compliance with radio frequency energy emission regulations \
and 
ensure a...





25


www.ctxd.com Documentation by:
© 2012 Adder Technology Limited
All trademarks are acknowledged.
Part	No.	MAN-ALAV	•	Release	1.3b
Web:  www.adder.com
Contact:  www.adder.com/contact-details
Support: forum.adder.com