ADDER CCS4USB Manual

							



30
g

Safety information
•	 For	use	in	dry,	oil	free	indoor	environments	only.
•	 Not	suitable	for	use	in	hazardous	or	explosive	environments	or	next	to	highly	
flammable	materials.
•	 Warning	–	the	power	adapter	contains	live	parts.
•	 No	user	serviceable	parts	are	contained	within	the	power	adapter	-	do	not	
dismantle.
•	 Do	not	use	the	power	adapter	if	the	power	adapter	case	becomes	damaged,	
cracked or broken or if you suspect that it is not operating properly.
•	 Replace	the	power	adapter	with	a	manufacturer	approved	type	only.	
•	 If	you	use	a	power	extension	cable,	make	sure	the	total	ampere	rating	of	the	
devices plugged into the extension cable do not exceed the cable’s am\
pere 
rating. Also, make sure that the total ampere rating of all the devices \
plugged into the wall outlet does not exceed the wall outlet’s ampere rating.
•	 Do	not	attempt	to	service	the	CCS4-USB	switch,	the	power	adapter	or	the	
optional remote control yourself.
•	 The	power	adapter	can	get	warm	in	operation	–	do	not	situate	it	in	an	
enclosed space without any ventilation. 
•	 The	CCS4-USB	switch	does	not	provide	ground	isolation	and	should	not	be	
used for any applications that require ground isolation or galvanic isol\
ation.
•	 When	using	the	power	adapter,	use	only	with	a	grounded	outlet.	When	
using a backup power supply (UPS), power the computers, the monitors a\
nd 
the CCS4-USB from the same supply.
Warranty
Adder Technology Ltd warrants that this product shall be free from defects in 
workmanship and materials for a period of two years from the date of ori\
ginal 
purchase. If the product should fail to operate correctly in normal use \
during the 
warranty period, Adder will replace or repair it free of charge. No liab\
ility can be 
accepted for damage due to misuse or circumstances outside Adder’s co\
ntrol. 
Also Adder will not be responsible for any loss, damage or injury arisin\
g directly 
or indirectly from the use of this product. Adder’s total liability u\
nder the terms 
of this warranty shall in all circumstances be limited to the replacemen\
t value 
of this product. If any difficulty is experienced in the installation \
or use of this 
product that you are unable to resolve, please contact your supplier.   
						

							



31
g

Radio Frequency Energy
All interface cables used with this equipment must be shielded in order \
to 
maintain compliance with radio frequency energy emission regulations and\
 
ensure a suitably high level of immunity to electromagnetic disturbances\
.
European EMC directive 2004/108/EC
This equipment has been tested and found to comply with the limits for a\
 class 
A	computing	device	in	accordance	with	the	specifications	in	the	European	
standard	EN55022.	These	limits	are	designed	to	provide	reasonable	protection	
against harmful interference. This equipment generates, uses and can rad\
iate 
radio frequency energy and if not installed and used in accordance with \
the 
instructions may cause harmful interference to radio or television recep\
tion. 
However, there is no guarantee that harmful interference will not occur \
in a 
particular installation. If this equipment does cause interference to ra\
dio or 
television reception, which can be determined by turning the equipment o\
n 
and off, the user is encouraged to correct the interference with one or \
more 
of the following measures: (a) Reorient or relocate the receiving ante\
nna. (b) 
Increase the separation between the equipment and the receiver. (c) Co\
nnect 
the equipment to an outlet on a circuit different from that to which the\
 receiver 
is	connected.	(d)	Consult	the	supplier	or	an	experienced	radio/TV	technician	for	
help. 
FCC Compliance Statement (United States)
This equipment generates, uses and can radiate radio frequency energy 
and if not installed and used properly, that is, in strict accordance wi\
th the 
manufacturer’s instructions, may cause interference to radio communic\
ation. 
It has been tested and found to comply with the limits for a class A com\
puting 
device	in	accordance	with	the	specifications	in	Subpart	J	of	part	15	of	FCC	rules,	
which are designed to provide reasonable protection against such interfe\
rence 
when the equipment is operated in a commercial environment. Operation of\
 this 
equipment in a residential area may cause interference, in which case th\
e user at 
his own expense will be required to take whatever measures may be necess\
ary 
to correct the interference. Changes or modifications not expressly ap\
proved by 
the manufacturer could void the user’s authority to operate the equip\
ment.
Canadian Department of Communications RFI statement
This equipment does not exceed the class A limits for radio noise emissi\
ons from 
digital apparatus set out in the radio interference regulations of the C\
anadian 
Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioé\
lectriques dépassant 
les limites applicables aux appareils numériques de la classe A presc\
rites dans 
le règlement sur le brouillage radioélectriques publié par le m\
inistère des 
Communications du Canada.   
						

							



32
g

www.ctxd.com Documentation by:
©	2014	Adder	Technology	Limited
All trademarks are acknowledged.
Part	No.	MAN-CCS4-USB-ADDER	•	Release	2.9i
Web:  www.adder.com
Contact:  www.adder.com/contact-details
Support: forum.adder.com