Acumen Camera IP Speed Dome Series AiPY14D03N2B User Manual

 20 
   
Preset Go 
To have the camera move to a specified Preset position, please select the Preset Point from the drop-down Preset Point list. Then the camera shall readily move to the target position. 
 
Chapter 3-6-2 PTZ Advanced Settings 
3-6-2.1 Lens Advance 
Lens Advance Setting Menu can be found under this path: PTZ> PTZ Advance> Lens Advance 
In the Lens Advance Setup Menu, users can set various Lens parameters including Focus, Focus 
Sensitivity, Digital Zoom, Zoom Speed and Focus Speed. Each...

 21 
 
3-6-2.2 Pan-Tilt Setup 
Pan-Tilt Setting Menu can be found under this path: PTZ> PTZ Advance> Pan-Tilt Setup 
In the Pan-Tilt Setup Menu, users can set various Pan-Tilt parameters including Home Position, 
Self Return Time, Self Return Mode and Auto Mode. Each setting is specified as follows: 
 
Home Position Specify home position for one of the presets.  
Self Return Time 
User Define if IP Speed Dome idles for a period of time, the selected function will be activated automatically. 
Self Return...

 22 
The IP Speed Dome Camera supports totally four Tour Path; each Tour Path consists of up to 32 
Preset Points. Please refer to the instructions below to program a Tour table. 
 
NOTE: Before setting this function, users must pre-define at least two Preset Points. 
 
Tour Path Setting 
 Tour Path 
Please select the number of Tour Path to be set from the drop-down list in the top of the Tour Setup menu.  Sequential Preset Points Setting 
Please setup each Preset Point of the programmed Tour Path in...

 23 
 
 
Chapter 3-7 SD Card Recording 
To record video on SD Card, please insert SD card into the SD card slot.    Enable SD card recording 
feature.    The IP camera can start to record video into the SD card. 
 
Chapter 3-7-1. SD Card Recording Setting 
For SD card recording setting, please see the following for detail. 
 
  
To un-mount the SD card, please click “un-mount SD Card” button.    It might crash the file system of 
the SD card, if a user does not un-mount the SD card properly. 
 SD...

 24 
 
 
Chapter 3-8 Alarm Settings 
H.264 D1 video server or IP PTZ camera’s hardware alarm system contains motion detection, alarm 
sensors, and one alarm/relay output.    Many alarm features such as motion/alarm email notification 
and FTP archiving can be found at this section.    
 
Chapter 3-8-1 Motion/Alarm Setup 
There are motion detection zones allowed in the H.264 D1 video server or IP PTZ camera.    A user 
can enable the detection zones with different sensitivities ranging from 1 to 99...

 25 
  
Chapter 3-8-4 Audio Detection 
For audio model, the IP camera has audio detector detecting acoustic level.    If the volume exceeds 
the audio sensitivity value, audio detector triggers an alarm for notification.        
 
 
Chapter 3-9. Audio Setting 
Audio setting is based on the following:  
 
 MIC Volume: MIC or line input volume 
 Audio Input Mode: Choose MIC input or Line input. 
 Audio Input Gain: Voice input gain magnification  Audio Output Volume: Line output volume 
adjustment 
...

 26 
Appendix  
Advance Network DDNS and PPPoE Technologies 
The advantage of using DDNS and PPPoE is to save the cost of IP address.   H.264 AVC IP 
camera’s PPPoE service gets a dynamic global IP address after system reboot.    This IP address 
may get changed periodically.    This is the address needed to access the video server over Internet.   
When ISP re-assigns a new IP address to H.264 AVC IP camera, H.264 AVC IP camera notifies 
DDNS service.    A remote PC can access H.264 AVC IP camera by...

 27 
         
Execute Live Cams Pro application. Please click on “Add Camera” button on your phone while using 
Live Cams Pro. Task bar gets prompted as below:  
Please selection one of the following drivers for cameras: Profile 1: H.264 HD or D1 IP camera.            
Android Access: 
Please use your Android phone and select Android Market for downloading IP Cam Viewer/IP Cam 
Viewer Lite application developed by Robert Chou. 
 
Execute IP Cam Viewer/IP Cam Viewer Lite application. Please click on...

 28 
“Add/Edit IP Camera” dialog box gets prompted for editing an IP camera or a DVR. 
 
In “Add/Edit IP Camera” dialog box, please enter the following information:  
 
1. Name: Name of the IP camera or DVR’s camera 
2. Category: Please select AI. 
3. Type: Select device type,  AI D1/ AI HD/ AI DVR. 
4. IP Address: Please type IP address, for example http://122.116.191.129:86 where 86 is the 
port number. 
5. Provide username and password information. For IP camera, the default username and 
password are...

 29 
Specification 
 Design and specification are subject to change without further notice. 
 
Network Function 
Video compression H.264, Motion JPEG 
Resolution SXGA(1280 x 1024), D1(720 x 480), CIF(352 x 240) 
Frame rate H.264 : 30 FPS at SXGA(1280 x 1024) 
Motion JPEG : 30 FPS at D1(720 x 480 ) 
Video streaming RTP/HTTP, RTP/TCP, RTP/UDP 
Video bitrate 
128Kbps ~ 5Mbps 
Frame rate and bitrate controllable on-the-fly 
VBR / CBR / GOP supported 
Security 
Base64 HTTP encryption 
Multiple user access...