Acoustic Energy Loudspeaker Aego P5 User Manual

The following pages provide information on the operation of
AEGO
P5. The AEGOP5 was purposely designed to be simple to
operate with all functions available from the remote control.
AEGOp5 Operation 
- LCD and LEDs
1. Press the power button to turn the AEGOP5 on, 
press it again to turn it off.
2. When power is turned off but still connected to the mains:
a. LCD display and Speaker Configuration LEDs are off.
b. Decoder status and user configurations are stored.
c. Once the power is turned on again, AEGO...

AEGOP5 Operation 
- Test Mode
Test Mode
After connecting up to your source
and speakers, you can press the
TESTbutton on the remote to test the
system. You can also use the test
mode to test the location of the
speakers. When the 
TESTbutton is
pressed, white noise is generated
through all satellite speakers in an
order of Front Left, Centre, Front
Right, Rear Left, and Rear Right
channels for 2 seconds each. When
completed, the AEGO
P5 returns to
Auto Decode mode.
When test mode is running, the display...

AEGOp5 Operation 
- Delay Calibration
The recommended listening position is described below:
Centre channel speaker should be placed the same distance as the
left and right speakers from your listening position.
Rear left and right speakers should be placed behind your listening
position and above ear level.
If speaker placement is restricted due to the physical environment
of the room, delay calibration is sometimes necessary to achieve
the ideal listening environment.
If the centre speaker can only...

AEGOp5 Operation 
- Pro Logic Mode
Pro Logic Mode
Your AEGOP5 will automatically switch to
Pro Logic mode when it detects a Pro Logic
signal. With other types of input signal, you
can select the Dolby Pro Logic mode
manually by pressing 
Pro Logicbutton on
the remote. Repeatedly pressing the 
Pro Logic Button will switch the Pro Logic
mode in between the following modes;
AUTO, ALL PCM, ENABLEand DISABLE.
If a Pro Logic signal is detected, AEGO
P5 will switch to Pro Logic
mode automatically, and the...

AEGOp5 Operation 
- Saving Presets
Setting Presets
The AEGOP5 enables you to customise
up to 4 settings. This function enables
you to save and load your favourite
settings at any time.
Saving a Preset:
Press the PRESET 1button, the display
will show the following:
Press the 
SAVEbutton to save all the 
current decoder settings into Preset 1.
When complete, your AEGO
P5 will revert back to Auto Decode mode.
AEGOp5 Operation 
- Loading Preset
Loading a Preset
You can load a previously saved preset
by...

Press the EQ SETUPbutton to display the current 
setting of EQ Band 1.
Press the 
EQ SETUPbutton again to select next EQ Band.
Press the 
Vol+or Vol- button to increase or decrease 
the volume for current EQ Band.
Press 
EQ SETUPbutton to store the new EQ setting.
Press 
EQ ON/OFFbutton to switch the new EQ settings on or off.
AEGOp5 Operation - DRC
(Dynamic Range Compression)
DRC
Your AEGOP5 features Dynamic Range
Compression (DRC), its sophisticated
technology creates realistic sound fields
with richly...