Acer V193w Service Guide

 
21   
Operating Instructions                                                                                                       
Press  the  power  button  to  turn  the  monitor  on  or  off.  The  other  control  buttons  are  located  at  front  panel  of  the 
monitor. By changing these settings, the picture ca n be adjusted to your personal preferences. 
·   The power cord should be connected. 
·   Connect the video cable from the monitor to the vi deo card. 
·   Press the power button to turn...

 
 
22 
eColor Management (OSD)    

 
23   
How to Adjust a Setting 
 
   
   

 
 
24 
Adjusting the picture 
    

 
25   
 
    

 
 
26 
OSD Message 
a. Outline 
 
 
b. The Description For OSD Message 
 
Item  Description 
Auto Config 
Please Wait  When Analog signal input, if User Press Hot-Key “Auto”, will show this message, and the 
monitor do the auto config function. 
Input Not 
Supported When  the  Hsync  Frequency,  Vsync  Frequency  or  Resolu tion  is  out  of  the  monitor 
support range, will show this message. This message will be flying. 
Cable Not 
Connected  Analog-Only  Model:  W hen  the  video  cable  is  not...

 
27   
Logo 
When the monitor is power on, the LOGO will be showed in the center, and disappear slowly. 
 
How To Optimize The DOS-Mode  
Plug And Play  
Plug & Play DDC2B Feature  
This  monitor  is  equipped  with  VESA  DDC2B  capabiliti es  according  to  the  VESA  DDC  STANDARD.  It  allows  th e 
monitor to inform the host system of its identity a nd, depending on the level of DDC used, communicate  additional 
information about its display capabilities.     
The DDC2B is a bi-directional data...

 
 
28 
Machine Disassembly                                                                                                                  
This chapter contains step-by-step procedures on ho w to disassemble the monitor for 
maintenance. 
Disassembly Procedure 
1.    Remove the cover hinge as the following indicat or. (Fig 1) 
 
 
Fig 1 
2.    Remove the screws as following indicate to rele ase base stand. (Fig 2) 
 
 
 
Fig 2 
          
Chapter 3    

 
29   
3.  Remove the back cover and bezel. (Fig 3)   
 
 
 
Fig 3 
  4.  Remove the lamp connectors and the screw. (Fig 4 -5)   
 
 
  Fig 4 
   
 
Fig 5 
        

 
 
30 
5.  Remove the screws to remove the panel. Put atten tion to the LVDS cable.(Fig 6-7)   
 
 
 
 
Fig 6 
 
 
Fig 7 
  
6.  Remove the screws to remove the main board and p ower board.( Fig 8) 
 
Fig 8