Acer Projector Pd726 User Manual

9... English

Appendices

Replacing the lamp
The	projector	will	detect	the	lamp	life	itself.	It	will	show	you	a	
warning	message	“Lamp	is	approaching	the	end	of	its	useful	
life	in	full	power	operation.	Replacement	Suggested!”	When	
you	see	this	message,	changing	the	lamp	as	soon	as	possible.	
Make	sure	the	projector	has	been	cooled	down	for	at	least	30	
minutes	before	changing	the	lamp.	
Warning:	Lamp	
compartment	is	hot!		
Allow	it	to	cool	down	
before	changing	lamp!
Warning:  To	
reduce	the	risk...

0English ...

Appendices

Problem: Message Reminders
	“Lamp	is	approaching	the	end	of	its	useful	life	in	full	power	opera-
tion.	Replacement	Suggested!”	will	be	shown	about	10	seconds	
when	lamp	life	is	going	to	deplete.
	“Projector 	Overheated.	 Lamp	will	automatically	turn	 off	soon.” 	will	
be	shown	when	the	system	temperature	is	over	heat.
	“Fan	fail.	Lamp	will	automatically	turn	off	soon.”	will	be	shown	
when	the	fan	is	out	of	order. 

... English

Appendices

SpecificationsSpecifications
The	specs	specified	below	are	subject	to	change	without	notice.		Regarding	the	final	specs,	
please	refer	to	Acer	accounced	marketing	specs.
Light	Valve-Single	Chip	DLPTM	Technology	by	Texas	Instruments
Lamp-260W	User	Replaceable	Lamp	for	PD724
-
300	W	User	Replaceable	Lamp	for	PD726
Number	of	Pixels
- 1024	pixels(H)	X	768	lines(V)
Displayable	Color
- 16.7M	colors
Contrast	Ratio
- 2500:1	(Full	On/Full	Off)
Uniformity-90%
Noise...

English ...

Appendices

Compatibility Modes
ModesResolutionV.Frequency [Hz]H.Frequency [KHz]
VGA - Analog
VGA640x4806031.5640x4807237.9
640x4807537.5640x4808543.3
720x4007031.5720x4008537.9
SVGA800x6005635.2800x6006037.9
800x6007248.1800x6007546.9
800x6008553.7XGA1024x7686048.4
1024x7687056.51024x7687560.0
1024x7688568.7SXGA1152x8647063.8
1152x8647567.51152x8648577.1
1280x10246063.981280x10247276.97
1280x10247579.98QuadVGA1280x9606059.7
QuadVGA1280x9607575.23SXGA+1400x10506063.98
MAC	LC	13”...

... English

Appendices

ModesResolutionV.Frequency [Hz]H.Frequency [KHz]
DVI – Digital
SVGA(Compressed)800x6005635.2
800x6006037.9
800x6007248.1
800x6007546.9
800x6008553.7
XGA(Native)1024x76843.435.5
1024x7686048.4
1024x7687056.5
1024x7687560.0
1024x7688568.7
SXGA(Compressed)1152x8647063.8
1152x8647567.5
1152x8648577.1
1280x10246063.98
1280x10247579.98
1280x10248591.1
SXGA+(Compressed)1400x10506063.98
UXGA(Compressed)1600x12006075
HDMI – Digital
(1) PC Signal.*Support	above	DVI	digital...

English ...

Appendices

Regulation & safety notices
This	appendix	lists	the	general	notices	of	your	Acer	Projector.	
FCC notice 
This	device	 has	been	 tested	 and	found	 to	comply	 with	the	limits	 for	a	Class	 B	
digital	 device	 pursuant	 to	Part	 15	of	the	 FCC	 rules.	 These	 limits	are	designed	
to 	provide 	reasonable 	protection 	against 	harmful 	interference 	in 	a 	residential	
installation. 	This 	device 	generates, 	uses, 	and 	can 	radiate 	radio 	frequency 	en
-
ergy 	and, 	if...

... English

Appendices

Operation conditions	
This	 device	 complies	 with	Part	15	of	the	 FCC	 Rules.	 Operation	 is	subject	 to	the	
following	two	conditions:	 1.	this	device	may	not	cause	harmful	interference,	and
2.	this 	device 	must 	accept 	any 	interference 	received, 	in 	cluding 	interfer
-
ence	that	may	cause	undesired	operation.	
Notice: Canadian users 
This	Class	B	digital	apparatus	complies	with	Canadian	ICES-003.	
Remarque à l’intention des utilisateurs canadiens 
Cet 	appareil...

6English ...

Appendices

Important safety instructions 
Read	these	instructions	carefully.	Save	them	for	future	reference.	1.		 Follow	all	warnings	and	instructions	marked	on	the	product.	
2.		 Unplug	 this	product	 from	the	wall	 outlet	 before	 cleaning.	 Do	not	 use	
liquid 	cleaners 	or 	aerosol 	cleaners. 	Use 	a 	water-moistened 	cloth 	for	
cleaning.	
3.		 Do	not	use	this	product	near	water.	
4.		 Do 	not 	place 	this 	product 	on 	an 	unstable 	cart, 	stand 	or 	table. 	If 	the	
product...

... English

Appendices

Canada  —  Low-power  license-exempt  radio 
communication devices (RSS-210)	
a.	Common 	information 	Operation 	is 	subject 	to 	the 	following	
two	conditions:	
1.	This	device	may	not	cause	interference,	and	
2. 	This 	device 	must 	accept 	any 	interference, 	including 	interfer
-
ence	that	may	cause	undesired	operation	of	the	device.
b. 	Operation 	in 	2.4 	GHz 	band 	To 	prevent 	radio 	interference 	to	
the	 licensed	 service,	this	device	 is	intended	 to	be...