Acer Projector K135 User Manual

21
English
Note: H. Position, V. Position, Frequency and Tracking functions 
are not supported under HDMI, DVI or Video mode.
Note: Sharpness functions is not supported under HDMI (RGB) or 
Computer mode.
Note: HDMI Color Range and HDMI Scan Info functions are only 
supported under HDMI mode. H. Position
•Press   to move the image left.
•Press   to move the image right.
V. Position
•Press   to move the image down.
•Press   to move the image up.
Frequency Frequency changes the projectors refresh rate to...

22
English
Setting
Management
Menu Location Choose the menu location on the display screen.
Reset
Press the   button and choose Yes to return the parameters 
on all menus to the factory default settings.
ECO Mode Choose On to dim the projector lamp which will lower power 
consumption, extend the lamp life and reduce noise. Choose Off 
to return normal mode.
High Altitude Choose On to turn on High Altitude mode. Operate the fans at 
full speed continuously to allow for proper high altitude cooling of 
the...

23
EnglishAudio
3D
Volume•Press   to decrease the volume.
•Press   to increase the volume.
Mute
•Choose On to mute the volume. 
•Choose Off to restore the volume. 
Alarm Volume
•Select this function to adjust the volume of any warning 
notifications.
Audio Out
•Choose Speaker to play sound through the projectors 
speaker.(internal)
•Choose Audio Jack to play sound from your headphone 
or audio amplifier. (external)
3D Choose On to enable DLP 3D function.
•On: Choose this item while using DLP 3D glasses,...

24
English
Note: It needs correct settings on graphic card 3D application program for 
correct 3D display.
Note: The SW players, such as Stereoscopic Player and DDD TriDef Media 
Player can support 3D format files. You can download these three players 
on web page below,
- Stereoscopic Player (Trial): http://www.3dtv.at/Downloads/Index_en.aspx
- DDD TriDef Media Player (Trial): 
http://www.tridef.com/download/TriDef-3-D-Experience-4.0.2.html
Note: 3D Sync Invert is only available when 3D is enabled....

25
EnglishAppendices
Troubleshooting
If you experience a problem with your Acer projector, refer to the following 
troubleshooting guide. If the problem persists, please contact your local reseller 
or service center.
Image Problems and Solutions
# Problem Solution
1 No image appears 
onscreen•Connected as described in the Getting Started 
section.
•Ensure none of the connector pins are bent or 
broken.
•Make sure the projector is switched on.
2 Partial, scrolling 
or incorrectly 
displayed image 
(For...

   26
English
3 Partial, scrolling 
or incorrectly 
displayed image 
(for notebooks)•For an incorrectly displayed image:•Follow the steps for item 2 (above) to adjust 
the resolution of your computer.
•Press the toggle output settings. Example: 
[Fn]+[F4], Compaq [Fn]+[F4], Dell [Fn]+[F8], 
Gateway [Fn]+[F4], IBM [Fn]+[F7], HP [Fn]+[F4], 
NEC [Fn]+[F3], Toshiba [Fn]+[F5]
•If you experience difficulty changing resolutions or 
your monitor freezes, restart all equipment 
including the projector.
4 The...

27
English
Problems with the Projector
9 Image is too small 
or too large•Adjust the zoom ring on the top of the projector.
•Move the projector closer to or further from the 
screen.
•Press MENU on the remote control or on the 
control panel. Go to Image --> Aspect Ratio and 
try different settings.
10 Image has slanted 
sides
•If possible, reposition the projector so that it is 
centered on the screen.
•Press the Keystone on the OSD until the sides are 
vertical.
11 Image is reversed
•Select Image -->...

   28
English
OSD Messages
# Condition Message Reminder
1 Message Fan Fail - the system fan is not working.
Projector Overheated - the projector has exceeded its 
recommended operating temperature and must be allowed to 
cool down before it may be used. 

29
EnglishLED & Alarm Definition Listing
LED Messages
Note: When power on, click any key, Menu/Up/Down/Left/Right 
key LED will all be trigger.
MessageMenu Lamp
(UP/Down 
LED)Temp
(Left/Right 
LED)Power LED Power LED 
BLUE BLUE BLUE RED BLUE
Input Power Plug --- Flash On 
to OFF 
100msFlash On 
to OFF 
100msFlash On 
to OFF 
100ms---
Standy by --- --- --- ON ---
Power buttom on ON 1sec 
then offON 1sec 
then offON 1sec 
then off--- ON
Lamp retry --- --- --- --- Quick 
Flashing 
Power button 
OFF; Standby...

   30
English
Specifications
The specifications listed below are subject to change without notice. For final 
specs, please refer to Acers published marketing specifications.
Projection system
DLP®
Resolution WXGA (1280 x 800)
Computer compatibility IBM PC and compatibles, Apple Macintosh, iMac and 
VESA standards: SXGA, XGA, SVGA, VGA, WXGA
Aspect ratio Full, 4:3, 16:9, L.Box
Displayable colors 16.7 million colors
Projection lens YM101, fixed lens, F/2.0
Projection screen size (diagonal) 30 (0.76 m) -...