Acer Ferrari 1100 Service Guide

Chapter 371
5.Remove the two screws (F) from the left hinge cover and carefully pry loose and remove the left hinge 
cover.    
6.Carefully pry loose the latch on the right hinge cover; close the LCD panel and then pull up the right hinge 
cover to remove. 
StepSize (Quantity)ColorTo r q u e
1~2 M2 x L4 (2) Black 1.6 kgf-cm 

72Chapter 3
7.Carefully pull out the wireless antenna cables from the hole and remove any adhesive tapes securing the 
cables.   

Chapter 373
8.Remove the large adhesive tape by the battery bay area and carefully pull the wireless antenna cables 
throught the routing hole.  
9.Disconnect the LCD cable connector from the main board.  

74Chapter 3
10.Remove the four screws (A) from the left and right hinge of the LCD module.  
11 .Carefully remove the LCD module from the base unit. 
NOTE: When connecting the cable back to the unit, please note that the cable should be routed well.
Separating the Upper Case from the Lower Case
1.See “Removing the Battery Pack” on page 60.
2.See “Removing the SD dummy card” on page 60.
3.See “Removing the ExpressCard dummy card” on page 61.
4.See “Removing the Lower Cover” on page 61.
5.See “Removing the...

Chapter 375
11 .Disconnect the touchpad cable from the TPAD1 on the main board. 
12.Remove the thirteen screws (2 x B, 10 x A, 1 x F) on the bottom and top panel.    

76Chapter 3
13.Gently remove the upper case from the lower case. 
Removing the Button Board
1.See “Removing the Battery Pack” on page 60.
2.See “Removing the SD dummy card” on page 60.
3.See “Removing the ExpressCard dummy card” on page 61.
4.See “Removing the Lower Cover” on page 61.
5.See “Removing the DIMM” on page 62.
6.See “Removing the WLAN Board Modules” on page 63.
7.See “Removing the Hard Disk Drive Module” on page 64.
8.See “Removing the Keyboard” on page 67.
StepSize (Quantity)ColorTo r q u e...

Chapter 377
9.See “Removing the Middle Cover” on page 68.
10.See “Removing the LCD Module” on page 70.
11 .See “Separating the Upper Case from the Lower Case” on page 74.
12.Release the latch and disconnect the two cables from the button board.    

78Chapter 3
13.Disconnect the fingerprint cable from the button board.  

Chapter 379
14.Remove the two screws (B) securing the button board bracket and remove the button board bracket 
together with the button board.   
15.Remove the one screw (B) and remove the button board from the bracket.  
StepSize (Quantity)ColorTo r q u e
1~2 M2 x L3 (2) Black 1.6 kgf-cm 

80Chapter 3
 
Removing the Fingerprint Board Module
1.See “Removing the Battery Pack” on page 60.
2.See “Removing the SD dummy card” on page 60.
3.See “Removing the ExpressCard dummy card” on page 61.
4.See “Removing the Lower Cover” on page 61.
5.See “Removing the DIMM” on page 62.
6.See “Removing the WLAN Board Modules” on page 63.
7.See “Removing the Hard Disk Drive Module” on page 64.
8.See “Removing the Keyboard” on page 67.
9.See “Removing the Middle Cover” on page 68.
10.See “Removing the LCD...