Acer Aspire 7530g Service Guide
Here you can view all the pages of manual Acer Aspire 7530g Service Guide. The Acer manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 101
Chapter 391 4. Lift up the bezel and remove it from the LCD Module.
Page 102
92Chapter 3 Removing the Inverter Board 1.Remove the LCD Bezel. See “Removing the LCD Bezel” on page 90. 2.Disconnect the left and right Inverter board cables as shown. 3.Lift up the Inverter Board and remove.
Page 103
Chapter 393 Removing the Camera Module 1.Remove the LCD Bezel. See “Removing the LCD Bezel” on page 90. 2.Remove the two securing screws from the Camera Module. 3.Disconnect the Camera Module cable as shown. StepSizeQuantityScrew Type Camera Module M2*3 1
Page 104
94Chapter 3 Removing the LCD Panel 1.Remove the LCD Bezel. See “Removing the LCD Bezel” on page 90. 2.Remove the six securing screws from the LCD Module. 3.Disconnect the left and right sides of the Inverter cable. 4.Disconnect the Camera Module cable as shown. StepSizeQuantityScrew Type LCD Panel M2.5*6.5 6
Page 105
Chapter 395 5.Grasp the panel by both ends and lift to remove.
Page 106
96Chapter 3 Removing the LCD Brackets and FPC Cable 1.Remove the LCD Panel. See “Removing the LCD Panel” on page 94. 2.Turn the LCD panel over to expose the rear. Grip the FPC cable and lift upward to detach the adhesive pads. 3.Remove the eight securing screws (four on each side) from the LCD Panel brackets. StepSizeQuantityScrew Type LCD Brackets M2*3 8
Page 107
Chapter 397 4.Remove the LCD brackets by pulling away from the LCD Panel as shown.
Page 108
98Chapter 3 LCD Module Reassembly Procedure Replacing the LCD Panel 1.Align the LCD brackets with the eight screw holes (four on each side) on the LCD Panel as shown. 2. Secure the LCD brackets to the LCD panel. 3. Turn the panel over. Insert the LCD Panel cable into the LCD Panel as shown.
Page 109
Chapter 399 4. Align the LCD Panel cable as shown and press down to secure in place. 5. Take care to insert the top of the panel fist and then angle the it in place.6. Place the LCD Panel in the back cover. 7. Secure the LCD module with the six securing screws.
Page 110
100Chapter 3 8. Connect the left and right Inverter cables. 9.Connect the camera cable.