Acer Aspire 7315 Service Guide

							Chapter 3101
Replacing the Mainboard
3.Align the screw holes on the Thermal Module and 
Mainboard then replace the module. Keep the 
module as level as possible to spread the thermal 
grease evenly.4.Replace the four securing screws (in numerical 
order from screw 1 to screw 4) to secure the 
Thermal Module in place.
1.Ensure that the Mainboard is face up (the CPU is not visible). Place the Mainboard in the chassis, left edge 
first (1), then rotate it downward into position (2).
NOTE: Ensure the I/O ports are positioned correctly through the casing.
2.Replace the single securing screw in the mainboard.
12
3 4
(1)(2) 
						

							102Chapter 3
Replacing the TouchPad Bracket
1.Replace the TouchPad bracket top edge first to 
engage the securing clips. 2.Press the bracket down to engage the securing 
clips.
3.Replace the two screws to secure the TouchPad Bracket to the Upper Cover.
4.Replace the TouchPad FFC and close the locking latch on the connector. 
						

							Chapter 3103
5.Replace the FFC and press down as indicated to secure it to the Upper Cover. 
						

							104Chapter 3
Replacing the Right Speaker Module
1. Place the module left side first on the Upper Cover 
as shown. Ensure that the left side of the module is 
seated correctly in the securing clip.2.Replace the single screw to secure the module in 
place.
3.Pass the cable through the Upper Cover as shown.4.Turn the Upper Cover over and run the cable along 
the cable channel using all available cable clips.
5.The cable runs as shown when correctly installed. 
						

							Chapter 3105
Replacing the Left Speaker Module
1. Place the module right side first on the Upper 
Cover as shown. Ensure that the right side of the 
module is seated correctly in the securing clip.2.Replace the single screw to secure the module in 
place.
3.Run the cable along the cable channel using all available cable clips.
4.Secure the cable in place with adhesive tape.5.The cable runs as shown when correctly installed. 
						

							106Chapter 3
Replacing the Power Board
Replacing the Upper Cover
1. Slide the Power Board in to the Upper Cover front edge first to engage the securing clip.
2.Press the board down to locate the securing pin.3.Replace the two screws to secure the board to the 
Upper Cover.
1. Place the Upper Cover on the Lower Cover as shown. 
						

							Chapter 3107
2.Press down around the edges to secure it in place.
3.Replace the nine screws in the Upper Cover as shown. 
						

							108Chapter 3
4.Replace the three screw caps as shown.
5.Connect the following cables to the Mainboard.
AB
C
D 
						

							Chapter 3109
6.Connect A as shown.7.Connect C as shown.
8.Connect B and close the locking latch to secure the cable in place.
9.Connect D and close the locking latch to secure the cable in place. 
						

							11 0Chapter 3
Replacing the LCD Module
10.Turn the computer over and replace the eleven screws as shown.
1.Align the screw holes on the LCD Module and 
Upper Cover and replace the LCD Module.2.The left and right screw covers are shaped 
differently. Ensure that the correct cover is used.
3.Replace the left screw cover as shown. Ensure that the securing tab on the rear of the cover is seated 
correctly in the Upper Cover.
Left Screw
CoverRight Screw
Cover