Acer Aspire 6930g Service Guide

Chapter 351
Removing the SD dummy card
1.Push the SD dummy card all the way in to eject it.
2.Pull it out from the slot.  

52Chapter 3
Removing the ExpressCard dummy card
1.Push the ExpressCard all the way in to eject the ExpressCard dummy. 
2.Pull it out from the slot. 

Chapter 353
Removing the Lower Covers
1.See “Removing the Battery Pack” on page 50.
2.See “Removing the SD dummy card” on page 51.
3.See “Removing the ExpressCard dummy card” on page 52.
4.Loosen the captive screws in the covers as shown.
   
5.Carefully open the Lower Cover. 
6.Remove the HDD2 Cover as shown. 
HDD2 
Cover
Lower 
Cover 

54Chapter 3
Removing the DIMM Modules
1.See “Removing the Battery Pack” on page 50.
2.Remove the Lower Cover See “Removing the Lower Covers” on page 53.
3.Push out the release latches on both sides of the DIMM socket to release the DIMM module. 
4.Remove the DIMM module. 
5.Repeat steps for the second DIMM module. 

Chapter 355
Removing the VGA Module
1.Remove Lower Cover. See “Removing the Lower Covers” on page 53.
2.Remove the four securing screws from the VGA Module.
3.Grasp the VGA module and pull to remove.
StepSizeQuantityScrew Type
VGA Module M2.5*8-I BNI NYLOK 4 

56Chapter 3
Removing the TV Tuner Module
1.See “Removing the Battery Pack” on page 50.
2.Remove the Lower cover. See “Removing the Lower Covers” on page 53.
3.Disconnect the antenna cable from the TV Tuner board as shown.
NOTE:  To ensure proper assembly, the antenna cable must be installed as shown.
4.Move the antenna cables away and remove the two screws to release the TV Tuner module and bracket 
assembly. 
 
StepSizeQuantityScrew Type
TV Tuner Module M2.0*3.0-I(BKAG)(NYLOK) IRON 2
Replace cabling as...

Chapter 357
5.Detach the TV Tuner module by grasping the assembly and pulling away as shown. 
6.Grasp the module and pull the bracket away.
Removing the WLAN Module
1.Remove the TV Tuner module. See “Removing the TV Tuner Module” on page 56.
2.Disconnect the two antenna cables. 

58Chapter 3
3.Remove the two securing screws.
4.Remove the WLAN module as shown.
StepSizeQuantityScrew Type
WLAN Module M2.0*3.0-I-NI-NYLOK 2 

Chapter 359
Removing the Main Hard Disk Drive Module 
1.See “Removing the Battery Pack” on page 50.
2.Remove the Lower Cover. See “Removing the Lower Covers” on page 53.
3.Hold the Pull Tab and slide the HDD away from the connector. Pull the HDD up as shown to remove.
NOTE: To prevent damage to HDD, avoid pressing down on it or placing heavy objects on top of it. 
4.Remove the four screws securing the HDD to the carrier.
StepSizeQuantityScrew Type
HDD Carrier M3*0.5+3.5I 4 

60Chapter 3
5.Lift the HDD carrier to remove.
6.Grasp the HDD connector and pull firmly to remove.