Acer Aspire 5910 Service Guide

							
Chapter 133
3.Detach the ODD bracket by re moving the screws that secure it to the ODD module.
Removing the Cooling Fan          
1.Disconnect the fan cable from it s system board connector (FAN1). 
2. Remove the screw  securing the fan.
StepTy p e QuantityColorTo r q u e
3 M2 x L3 BZN+NYLOK 2 Black 1.6 kgf-cm +/-15%
StepTy p e QuantityColorTo r q u e
2 M2 x L4 BZN+NYLOK 1 Black 1.6 kgf-cm +/-15%
Acer Aspire 5910 SG.book  Page  33  Tuesday, May 29, 2007  11:40 AM 
						

							
34Chapter 1
3.Remove the fan from the main unit. 
Removing the Heat Sink      
1.Remove the screws securing the  heat sink (Discrete model). 
2. Carefully pull the heat sink from its base,  then remove it from the system board.
StepTy p e QuantityColorTo r q u e
1 M2 x L4 BZN+NYLOK 4 Black 1.6 kgf-cm +/-15%
M2 x L2.5 BZN+NYLOK 5 Black 1.6 kgf-cm +/-15%
Acer Aspire 5910 SG.book  Page  34  Tuesday, May 29, 2007  11:40 AM 
						

							
Chapter 135
Removing the Processor      
1.Use a flat screwdriver to turn the processor socket  lock to the counter-clockwise to the unlock position 
(note the unlock icon).
Torque value:  3 kgf-cm +/-15%
2. Partly peel off the processor bar code tape. 
3. Hold the processor by its edges and remove it from its socket (U36).
IMPORTANT:   When installing a processor, note the golden arrow on the corner to make sure the processor is 
properly oriented over the socket. Refer to figure above. 
Acer Aspire 5910 SG.book  Page  35  Tuesday, May 29, 2007  11:40 AM 
						

							
36Chapter 1
Removing the VGA Board      
1.Remove the screws securing the  VGA board to the system board.
2. Hold the VGA board by its edges and pull it from its slot (MXM1).
StepPart Number and Type QuantityColorTo r q u e
1 M2 x L3 BZN+NYLOK 2 Black 1.6 kgf-cm +/-15%
Acer Aspire 5910 SG.book  Page  36  Tuesday, May 29, 2007  11:40 AM 
						

							
Chapter 137
Main Unit Disassembly  
IMPORTANT:  To prevent from scratching or damaging the LCD  panel, cover it with a protective film before  
disassembling the main unit.
Main Unit Disassembly Flowchart  
ScrewTy p ePart Number
C M2.5 x L8 BZN+NYLOK 86.00E34.738
D M2 x L4 BZN+NYLOK 86.00E13.524
F M2 x L3 BZN+NYLOK 86.00E25.723
H M2.5 x L12 BZN+NYLOK 86.00E67.63C I M2.5 x L4 BZN+NYLOK 86.00D30.630
J M2.5 x L6 BZN+NYLOK 86.00E33.736
K M2 X L2 NI 86.00D77.320
Main unit
Ke yboa r dMiddle cover
LC D module (Cx2, Hx2)Power board (Dx4)
Upper case
(Ix1, Cx10, Jx2, Dx3) )Low er  cas e
Power FPC cable
Speaker case (Dx3, Kx3)
Launch board (Dx2)
Touchpad board bracket (Dx3)
Modem board (Fx2)
Bluetooth board
Subwoofer
US B boar d(Dx1)
Touchpad cable
Touchpad board
System board (Dx2)
Card reader board (Fx1)
DC - i n por t
E-key board(Fx3)
Acer Aspire 5910 SG.book  Page  37  Tuesday, May 29, 2007  11:40 AM 
						

							
38Chapter 1
Removing the Keyboard       
1.Use a flat plastic screwdriver to push the six tabs  securing the keyboard to the upper case (U-case).
2. Pry the keyboard off to release it from the  upper case, t hen turn it over the palmrest to gain access to the 
keyboard cable. 
3. Disconnect the keyboard cable from  its system board connector (KB1) to completely detach the keyboard 
from the main unit. 
Acer Aspire 5910 SG.book  Page  38  Tuesday, May 29, 2007  11:40 AM 
						

							
Chapter 139
Removing the Middle Cover      
1.Open the LCD panel completely to facilitate the easy removal of the middle cover. 
2. Use a plastic flat screwdriver to pry one end of the  middle cover. Continue prying on the other side until 
the cover is released from the U-case. 
3. Remove the middle cover from the main unit. 
Removing the LCD Module       
1.Pull out the WLAN antennas from u nderneath the computer base, and th en from under the speaker grill. 
Acer Aspire 5910 SG.book  Page 39  Tuesday, May 29, 2007  11:40 AM 
						

							
40Chapter 1
2.Disconnect the LCD and internal microphone cables from their system board connectors (LCD1, 
INTMIC1).
3. Close the computer lid and turn the unit over to the base side. 
4. Remove the lower case screws securing the LCD module. 
5. Turn the unit right side up and open the notebook lid again.
6. Remove the hinge screws securing the LCD module.   
StepTy p e QuantityColorTo r q u e
4 M2.5 x L8 BZN+NYLOK 2 Black 3 kgf-cm +/-15%
StepTy p e QuantityColorTo r q u e
6 M2.5 x L12 BZN+NYLOK 2 Silver 4 kgf-cm +/-15%
Acer Aspire 5910 SG.book  Page  40  Tuesday, May 29, 2007  11:40 AM 
						

							
Chapter 141
7.Detach the LCD module from the main unit. 
Proceed to page 55 for instructions on how to disassemble the LCD module. 
Removing the Power Board       
1. Disconnect the power FPC cable from its power board connector (PWRCN1).
2. Remove the screws securing the power board. 
StepTy p e QuantityColorTo r q u e
2 M2 x L4 BZN+NYLOK 4 Black 1.6 kgf-cm +/-15%
Acer Aspire 5910 SG.book  Page  41  Tuesday, May 29, 2007  11:40 AM 
						

							
42Chapter 1
3.Remove the power board from the upper case.   
Removing the Upper Case     
1.Disconnect the following system cables from their connectors. 
t     Empowering Key board cable (E_KEY1)
t     Speaker cable (SPKR1) 
Acer Aspire 5910 SG.book  Page  42  Tuesday, May 29, 2007  11:40 AM