Acer Aspire 5538 Service Guide

91Chapter 3
 LCD Module Disassembly Process
IMPORTANT: Cable paths and positioning may not represent the actual model. During the removal and 
replacement of components, ensure all available cable channels and clips are used and that the cables are 
replaced in the same position.
NOTE: The product previews seen in the disassembly procedures may not represent the final product color or 
configuration.
LCD Module Disassembly Flowchart
Screw List
StepScrewQuantityPart No.
LCD Bezel M2.5*4 4 86.PEA02.003
LCD...

Chapter 392
Removing the LCD Bezel
1.See “Removing the LCD Module” on page 85.
2.Remove the four screw covers and four screws securing the front bezel to the LCD cover.
3.Starting from the inside top edge, pry the bezel away from the panel. Continue moving along the top, 
prying the bezel away from the LCD Module. If necessary, use a plastic pry to release the corners of the 
bezel.
StepSizeQuantityScrew Type
LCD Bezel M2.5*4 4
p 

93Chapter 3
4.Work towards the middle and down the sides of the bezel, separating the securing clips.
5.Pry apart the bottom edge of the bezel and push slightly upwards to release the hinge covers.
6. Lift up the bezel and remove it from the LCD Module. 

Chapter 394
Removing the Camera Board
1.See “Removing the LCD Bezel” on page 92.
2.Remove the Camera Board from the LCD Module.
3.Disconnect the cable from the Camera Board as shown. 

95Chapter 3
Removing the LCD Panel
1.See “Removing the Camera Board” on page 94.
2.Remove the four screws securing the LCD Panel to the LCD Module.
3.Lift the LCD Panel out of the LCD Module front edge first.
StepSizeQuantityScrew Type
LCD Panel M2*3 4 

Chapter 396
Removing the FPC Cable
1.See “Removing the LCD Panel” on page 95.
2.Turn the LCD panel over on a clean surface.
3.Lift the camera cable to detach the adhesive securing the cable to the LCD Panel.
4.Carefully lift the adhesive tape securing the LVDS cable connector to the LCD Panel. 

97Chapter 3
5.Hold the adhesive tape clear of the LCD Panel.
6.Disconnect the LCD cable as shown and remove the cable from the LCD Panel. 

Chapter 398
Removing the LCD Brackets
1.See “Removing the LCD Panel” on page 95.
2.Pick up the antenna cable so the bracket can clear the cable.
3.Lift the top of the left LCD Bracket up and slide out from under the antenna cable.
4.Lift the top of the right LCD Bracket up and slide out from under the antenna cable. 

99Chapter 3
Removing the Microphone
1.See “Removing the LCD Panel” on page 95.
2.Remove the tape securing the Microphone cable to the antenna cables.
3.Remove the Microphone cable from the shielding along the bottom edge of the LCD Cover.
4.Lift up the shielding where it covers the Microphone cable and lift the cable as shown to remove the 
adhesive securing it to the LCD Cover. 

Chapter 3100
5.Lift the Microphone Module upward to detach the adhesive holding it in place.