Acer Aspire 5535 Service Guide
Here you can view all the pages of manual Acer Aspire 5535 Service Guide. The Acer manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 101
Chapter 389 12. Carefully pry open the LCD bezel and place the bezel on top of the LCD panel. Removing the LCD panel with the Brackets 1.See “Removing the Battery Pack” on page 50. 2.See “Removing the SD dummy card” on page 51. 3.See “Removing the ExpressCard dummy card” on page 51. 4.See “Removing the Lower Cover” on page 52. 5.See “Removing the WLAN Board Modules” on page 54. 6.See “Removing the Middle Cover” on page 62. 7.See “Removing the Heatsink Fan Module” on page 64. 8.See “Removing the CPU...
Page 102
90Chapter 3 11 .Disconnect the cable from the web camera. 12.Remove the five screws (5 x B) securing the LCD module. 13.Remove the LCD with the brackets from the back cover. Removing the Inverter Board and FPC Cable 1.See “Removing the Battery Pack” on page 50. StepSize (Quantity)ColorTo r q u e 1~5 M2.5 x L6 (5) Black 3.0 kgf-cm
Page 103
Chapter 391 2.See “Removing the SD dummy card” on page 51. 3.See “Removing the ExpressCard dummy card” on page 51. 4.See “Removing the Lower Cover” on page 52. 5.See “Removing the WLAN Board Modules” on page 54. 6.See “Removing the Middle Cover” on page 62. 7.See “Removing the Heatsink Fan Module” on page 64. 8.See “Removing the CPU Heatsink Module” on page 65. 9.See “Removing the LCD Module” on page 67. 10.See “Removing the LCD Bezel” on page 88. 11 .See “Removing the LCD panel with the Brackets” on...
Page 105
Chapter 393 14.Disconnect the FPC cable from the LCD panel. Removing the LCD Brackets 1.See “Removing the Battery Pack” on page 50. 2.See “Removing the SD dummy card” on page 51. 3.See “Removing the ExpressCard dummy card” on page 51. 4.See “Removing the Lower Cover” on page 52. 5.See “Removing the WLAN Board Modules” on page 54. 6.See “Removing the Middle Cover” on page 62. 7.See “Removing the Heatsink Fan Module” on page 64. 8.See “Removing the CPU Heatsink Module” on page 65. 9.See “Removing the LCD...
Page 106
94Chapter 3 Removing the Antennas 1.See “Removing the Battery Pack” on page 50. 2.See “Removing the SD dummy card” on page 51. 3.See “Removing the ExpressCard dummy card” on page 51. 4.See “Removing the Lower Cover” on page 52. 5.See “Removing the WLAN Board Modules” on page 54. 6.See “Removing the Middle Cover” on page 62. 7.See “Removing the Heatsink Fan Module” on page 64. 8.See “Removing the CPU Heatsink Module” on page 65. 9.See “Removing the LCD Module” on page 67. 10.See “Removing the LCD Bezel”...
Page 107
Chapter 395 13.Remove the left and right antenna cables together with the tapes holding them in place. NOTE: There is no need to remove the antenna unless you really need to replace it. Removing the Web Camera 1.See “Removing the Battery Pack” on page 50. 2.See “Removing the SD dummy card” on page 51. 3.See “Removing the ExpressCard dummy card” on page 51. 4.See “Removing the Lower Cover” on page 52. 5.See “Removing the WLAN Board Modules” on page 54. 6.See “Removing the Middle Cover” on page 62....
Page 109
Chapter 497 Use the following procedure as a guide for computer problems. NOTE: The diagnostic tests are intended to test only Acer products. Non-Acer products, prototype cards, or modified options can give false errors and invalid system responses. 1.Obtain the failing symptoms in as much detail as possible. 2.Verify the symptoms by attempting to re-create the failure by running the diagnostic test or by repeating the same operation. 3.Use the following table with the verified symptom to determine...
Page 110
98Chapter 4 System Check Procedures External Diskette Drive Check Do the following to isolate the problem to a controller, driver, or diskette. A write-enabled, diagnostic diskette is required. NOTE: Make sure that the diskette does not have more than one label attached to it. Multiple labels can cause damage to the drive or cause the drive to fail. Do the following to select the test device. 1.Boot from the diagnostics diskette and start the diagnostics program. 2.See if FDD Test is passed as the...