Acer Aspire 4935 Service Guide

Chapter 3101
Removing the LCD Bezel
1.See “Removing the LCD Module” on page 74.
2.Remove the six screw caps and screws as shown.
 
3.Starting at the centre of the top edge, pry the inside of the bezel away from the screen. Work round the edges 
to pry the bezel away from the screen as shown.
StepSizeQuantityScrew Type
LCD Bezel M2.5*5 6 

102Chapter 3
4.Lift the bezel away from the panel. 

Chapter 3103
Removing the Camera Module
1.See “Removing the LCD Bezel” on page 101.
2.Remove the single screw from the Camera Bracket as shown.
3.Lift the Camera Bracket, right side first, clear of the casing.
4.Lift the Camera Module clear of the casing and disconnect the cable from the Module.
5.Remove the Camera Module.
StepSizeQuantityScrew Type
Camera Module M2.5*3 1 

104Chapter 3
Removing the LCD Panel
1.See “Removing the Camera Module” on page 103.
2.Remove the two securing screws from the LCD hinges and the single LCD grounding screw.
3.Remove the Camera cable bundle from the top of the casing as shown.
StepSizeQuantityScrew Type
LCD Panel
(red callout)M2.5*5 2
LCD Panel
(green callout)M2.5*3 1 

Chapter 3105
4.Lift the LCD Panel out of the casing as shown. 

106Chapter 3
Removing the LCD Brackets and FPC Cable
1.See “Removing the LCD Panel” on page 104.
2.Turn the LCD Panel over on a clean surface, and lift the cable as shown to detach the adhesive.
3.Grip the adhesive strip covering the LCD cable connector and pull it back (1). 
4.Remove the cable from the panel as shown (2).
5.Remove the six securing screws (three on each side) from the LCD Panel brackets in numeric order, from 3 to 1.
6.Remove the LCD brackets by pulling them away from the LCD Panel....

Chapter 3107
Removing the Antennas 
1.See “Removing the LCD Panel” on page 104.
2.Remove the strips holding the antenna cables in place. Ensure the cables are free from obstructions.
3.Remove the tab securing the left and right antennas to the LCD module and lift the antennas clear. 
4.Remove the antenna cables and assembly from the LCD module. 

108Chapter 3
Removing the MIC Module
1.See “Removing the Antennas” on page 107.
2.Remove the strips and tape holding the MIC Module cable in place. Ensure the cable is free from obstructions.
3.Remove the MIC cable and Module from the LCD module. 

Chapter 3109
LCD Module Reassembly Procedure
Replacing the MIC Module
1.Replace the MIC Module in the LCD casing.2.Run the cable as shown and replace the adhesive 
strips to hold it in place. 
IMPORTANT:Ensure that the cable runs as shown in the hinge well area to avoid trapping. 

11 0Chapter 3
Replacing the Antennas
1.Run the right side Antenna cable as shown in the 
hinge well to avoid trapping.2.Run the cable as shown and replace the adhesive 
strip.
3.Run the cable along the edge of the casing using 
all available cable clips.4.Run the cable as shown and replace the adhesive 
strip.
5.Replace the Antenna in the casing as shown and 
secure it in place with the tape.6.Ensure that the securing pin is properly located.