Acer Aspire 3000 Service Guide

Chapter 352
.
Removing the Thermal Module and CPU
1.Remove the three screws holding the thermal door
2.Detach the thermal door.
3.Disconnect the fan cable from the main board.
4.Remove the three screws fastening the thermal module.
5.Disconnect the fan cable.
NOTE: When you remove the screws fastening the thermal module, please follow the number order 3, 2, 1 on 
the thermal module. When you need to assemble the thermal module, fasten the screws as the order 1, 
2, 3 on the thermal module.
6.Use a...

53Chapter 3
Removing the ODD Module
1.Remove the three screws holding the middle cover.
2.Detach the middle cover carefully.
3.Then remove the two screws fastening the keyboard.
4.Turn over the keyboard as shown.
5.Disconnect the keyboard cable from the main board then remove the keyboard.
6.Remove the screw that fastens the ODD module.
7.Turn over the notebook computer then detach the ODD module carefully.
NOTE: When you reattach the ODD, please make sure you attach the ODD module completely to the main...

Chapter 354
3.Remove the two screws that secure the keyboard as shown.
4.Turn over the keyboard as shown and disconnect the keyboard cable then remove the keyboard.
5.Pull out the antenna set with a tweezers then take out the antenna set from the main unit.
.
6.Disconnect the LCD coaxial cable.
7.Remove the four screws holding the right and the left hinge. Two on each side.
8.Then detach the LCD module from the main unit.
. 

55Chapter 3
Disassembling the Main Unit
Separate the Main Unit Into the Upper and the Lower Case Assembly
1.Remove the two screws holding the switch board.
2.Remove the switch board.
3.Disconnect the touchpad FFC from the main board.
4.Disconnect the bluetooth cable.
5.Remove the five screws that secure the upper case.
6.Remove the 17 screws on the bottom as shown.
7.Detach the upper case assembly and place it next to the lower case assembly.
8.Disconnect the microphone cable then remove the upper case...

Chapter 356
4.Remove the three screws that secure the touchpad board.
5.Remove the touchpad board from the upper case.
6.Disconnect the touchpad board to touchpad FFC.
7.Remove the touchpad board to touchpad FFC from the uppwer case assembly.
8.Remove the four screws holding the touchpad bracket.
9.Detach the touchpad bracket from the upper case assembly.
10.Remove the touchpad from the upper case.
11 .Remove the two screws that secure the bluetooth module.
12.Disconnect the bluetooth module then remove...

57Chapter 3
2.Detach the MDC cable from the main board.
3.Remove the two screws holding the modem board then disconnect the modem board from the main 
board.
4.Disconnect the speaker cable from the main board.
5.Remove the screw that secure the main board.
6.Remove the two screw nuts as shown.
7.The you can detach the main board from the upper case. 
8.Remove the ttwo screws that fasten the N/B heatsink.
9.Remove the N/B heatsink from the main board as shown.
10.Remove the card reader dummy card from the...

Chapter 358
IMPORTANT:When assembling/disassembling the main board, whenever there is a mylar on the main board 
(see the highlighted with red below; the mylar is sami-transparent, film-like stuff ), it should be 
transferred “if necessary” to the replacement main board. Because the main board mylar should be 
stuck to the main board to prevent the antenna cable and the main board components short circuit. 
The short could cause the main board or the antenna cable burned. 

59Chapter 3
Disassembling the LCD Module
1.Remove the four screw caps as shown.
2.Remove the four screws holding the LCD bezel.
3.Then detach the LCD bezel from the LCD module.
4.Disconnect the inverter board then remove it.
5.Remove the three screws holding the right hinge.
6.Then remove the three screws that secure the left hinge.
7.Remove one screw that secure the LCD bracket.
8.Remove another screw holding the LCD bracket on the other side.
9.Then detach the LCD panel from the LCD cover carefully.
....

Chapter 360
13.Remove the left bracket as the picture shows.
14.Tear off the tape fastening the LCD cable.
15.Tear off the the LCD cable fastening the LCD cable, then remove it.. 

61Chapter 3
Disassembling the External Modules
Disassembling the HDD Module
1.Remove the two screws holding the HDD bracket on one side.
2.Remove another two screws holding the HDD bracket on the other side.
3.Then take the hard disc drive out from the HDD bracket.
Disassembling the Optical Drive Module
1.Remove the four screws as the picture shows.
2.Remove the two screws that secure the optical disc drive and the ODD holder.
3.Push the ODD holder as shown.
4.Detach the ODD holder.
5.Disconnect the ODD...