Acer Aspire 1610 Series User Manual

Chapter 382
7.Fasten the LCD bezel with the four screws. Then cover the four screw pads. 

83Aspire 1610
Installing the LCD Module
Installing the LCD Module
1.Place the LCD module to the main unit.
2.Fasten the LCD module with the two screws on the bottom; one on the right and another one on the left.
3.Secure the LCD hinge with the four screws; two on the right and two on the left.
 
4.Connect the inverter cablet to the main board. Connect the LCD coaxial cable to the maine board. Then 
fasten the LCD coaxial cable with one screw.
 
Installing the Launch Board
1.Attach the launch board to the...

Chapter 384
Installing the Middle Cover
1.See ”Installing the Launch Board” on page 99.
2.Connect the launch board cable to the launch board.
.
3.Attach the middle cover to the main unit carefully. Then close the LCD panel and fasten the middle cover 
with your fingers on its ridge.
4.Secure the middle cover with one screw as the picture shows.
5.Then attach the left hinge cap.
6.Secure the middle cover with one screw on another side as the picture shows.
7.Then attach the right hinge cap. 

85Aspire 1610 

Chapter 386
Installing the Hard Disk D rive Module
1.Inster the hard disk drive to the main unit. Then push it to the original position carefully.
NOTE: Please attend the positive and negative of hard disk drive when insert the hard disk drive to the main 
unit. 

87Aspire 1610
Removing the Modem Board
1.Connect the modem cable to the modem board.
2.Place the modem board to the main unit carefully. Then fasten the modem board with the two screws.
3.Place the modem cover back to the machine. Then secure the modem cover with one screw. 

Chapter 388
Installing the Memory Module
1.Insert the memory module to the DIMM slot.
2.Put the DIMM cover back to the machine.
3.Fasten the DIMM cover with the two screws. 

89Aspire 1610
Installing the Battery
1.Place the the battery back to the machine. 

Chapter 490
Use the following procedure as a guide for computer problems.
NOTE: The diagnostic tests are intended to test only Acer products. Non-Acer products, prototype cards, or 
modified options can give false errors and invalid system responses.
1.Obtain the failing symptoms in as much detail as possible.
2.Verify the symptoms by attempting to re-create the failure by running the diagnostic test or by repeating 
the same operation.
3.Use the following table with the verified symptom to determine...

91Aspire 1610
System Check Procedures
External Diskette D rive Check
Do the following to isolate the problem to a controller, driver, or diskette. A write-enabled, diagnostic diskette is 
required.
NOTE: Make sure that the diskette does not have more than one label attached to it. Multiple labels can cause 
damage to the drive or cause the drive to fail. 
Do the following to select the test device.
1.Boot from the diagnostics diskette and start the diagnostics program.
2.See if FDD Test is passed as the...