Accusplit Timer AL625M8D User Manual

							
INTRODUCTION
This unit has five modes: Stopwatch, Auto Repeat Countdown 
Timer, Dual Display Countdown Timer, Pacer, and Preset 
Countdown Timer.
Press C (MODE) to change between modes. Note: Timing must 
be stopped and reset to zero to change modes. 
MEMORY STOPWATCH
SPLIT TIMING
1. Press C to move the cursor to point to
2. Press A to start stopwatch
3.  Press B repeatedly to remember the last 8 splits 
  • Lower display shows cumulative split and upper 
 
    display shows lap split
  • After 5 seconds, the unit will unlock splits to display 
 
    current running split time
4.  Press E to recall the last 8 splits 
5.  Press A to stop counting
6.  Press B to reset to zero
START-STOP TIMING
1. Press C to move the cursor to point to
2. Press A to start counting 
3.  Press A repeatedly to remember the last 8 time-cuts
4.  Press E to recall the last 8 times-outs 
5.  Press A to stop counting
6.  Press B to reset to zero
AUTO REPEAT COUNTDOWN TIMER
1. Press C to move the cursor to point toAUTO
2.  Press D to enter set mode
  • Press B to set hours, E to set minutes, A to set seconds
  • Press A & B at the same time to reset digits to zero
    ACCUSPLIT®
       ALLIANCE™ 625M8D
MULTIMODE TIMER/STOPWATCH
          OPERATING INSTRUCTIONS
3. Press A to start countdown timing
4.  Press E to show the time from start (
)
5.  Press E again to return to countdown timing (
)
6.  Press A again to stop counting
7.  Press B to return to the original setting
8.   When time is up, the unit will beep once, then start 
 
  counting again. The number of cycles completed is 
 
  recorded in brackets in upper left of display. 
DUAL DISPLAY COUNTDOWN TIMER
1. Press C to move the cursor to point to DUAL
2.  Press E to change the dual display timer mode (
SU  
  or 
Id or UP)
3.  Press D to adjust the timer on the lower display
  Press D again to adjust the timer on the upper display
  • Press B to set hours, E to set minutes, A to set seconds
  • Press A & B at the same time to reset digits to zero
  • Press D again to complete the settings
4. 
SU - Two countdown timers work simultaneously
  • Press A to start 
 
  • Press A to stop (STOP: flashes)
  • Press B to reset to the original settings
 Id - Two countdown timers work independently
  • Press A to start/stop lower display
  • Press B to start/stop upper display
  • Press A & B at the same time to reset to the original 
 
    settings
   
UP - Two count up timers work independently
  • Press A to start/stop lower display (STOP: flashes 
 
    when stopped)
  • Press B to start/stop upper display (STOP: flashes 
 
    when stopped)
  • Press A & B at the same time to reset to zero
PACER WITH COUNT UP TIMER
1. Press C to move the cursor to point to PACE
2.  Press D to adjust the frequency
  • Press A to increase the digits
  • Press B to decrease the digits
3.  Press A to start pacer
4.  Press A again to the stop
5.  Press B to reset to zero
6.  Press E to turn the pacer’s beep ON or OFF 
 
  and the symbol (((•))) will appear or disappear
7.  Upper display shows count up timer
16 PRESET COUNTDOWN TIMER
1. Press C to move the cursor to point to (1-60)
2.  Turn the rotary switch to the desired minutes (1-60)
3.  Press A to start countdown timing
4.  Press A again to stop countdown timing
5.  Alarm Sounds
6.  Press B to return to the original setting
To Show Count Up  Timing
1. When the time is not up.
  a. Press E to check elapsed time (
)
  b. Press E again to return to countdown (
)
2.  When the time is over,
  a. Press E to check the time from start (
flashes)
  b. Press E again to show overtime (
flashes)
RESET/SPLIT
RECALL
UP/DOWN
START/STOP
ROTARY 
SWITCH
MODE
SET
BA
E
C
D 
						

							DUAL TIMER S 
(1 second t o 100 hours)
•  3 special timer modes
  —“SU” is  Two Simultaneous  Timer s with one   
    but ton Star t/Stop
  —“ID” is  Two Independent  Timer s with own      
Star t/Stop but ton
  —“UP” is  Two Independent  Timer s counting   
    UP with own Star t/Stop button
•  Single interval timing
•  Two-but ton Reset to return to pre-set interval   
  and  Two-but ton Reset to z ero during set ting  
  of interval
PA CER/RA TE TIMER 
(beats per minut e)
•  Timer up to 1 00 hour s by second
•   Signal/P ace Counter up to 1 0,000
•   Selectable P ace/Rate frequency from 1 0 to  
  240 by 1 0
•   Selectable ON or OFF P ace/Rate beep
BATTER Y 
(see bac k of timer)
•  CR 2032 3V lithium bat tery Panasonic or  
  equi valent
•  Not w ater-resistant
FUNCTIONS  AND FEATURES
PRESET INTER VAL COUNTDO WN TIMER 
(in seconds)
•  Selectable preset timer intervals – 1, 2, 3, 5,   
  10, 1 2, 15, 20, 25, 30, 35, 40, 45, 50, 55, and   
  60 minutes
•  Selectable display of Count UP or  
  Count DO WN
•  30 second w arning beep
•  3 second star t of 1 second w arnings
•  Alarm at z ero for 5 seconds
•  Then selectable display of total elapsed 
  time or o vertime
USER SELECT ABLE AUT O REPEA T TIMER 
(1 second t o 100 hours)
•  Repeat timer
•  Alarm at z ero for eac h repeat
•  3 second w arnings (if interval o ver 5 minutes)
•  Selectable display of time remaining in an  
  interval or cumulati ve elapsed time
•  Repeat timer counter to 99
8 DU AL MEMOR Y STOPW ATCH 
(1/1 00 second t o 10 hours)
• Saves in memory the last 8 Dual Split  
  (Lap and Cum) Splits
•  Split Counter up to 99
•  Memory R eview during timing
•  5 second  Automatic Split release and return  
  to running display
ACCUSPLIT ®
        A LLIANCE
™ 625M8D
            MUL TIMODE TIMER/S TOPW ATCH
ACCUSPLIT , Inc.  •  3090 Independence Drive, Suite 148  •  Livermore, CA 94551 USA
800-935-1996  •  925-290-1900  •  FAX 925-290-1930  • www.ACCUSPLI T.co m  •  support@ACCUSPLIT .com
 
960-012A
NO-PR
OOF-OF-PUR CHASE LIMITED  WARRANT Y
S ee la b el o n b a ck o f u nit  f o r d eta ils , o r c heck   
h tt p :/ /s u ppo rt.A CC U SPLIT .c om
REGISTER NOW Please return 
your AL625M8D Registration to 
the Repair Center address in the 
warranty , and we will let you 
know about future products.  Email (preferred)
User