Aaxa Projector M1 Limited User Manual

Table of Contents            1
Warnings              2
Overview       3
Remote Control Functions          4
Packing List              5
General Operation            6
  Startup and control          6
  Shutdown            6
  Positioning / Throw Distance / Focus      6-7
  Connecting to Computer (USB – VGA Input)    8
  Connecting to A/V Source         8-9
  Accessing the onboard memory        9
  Using Onboard Media Player        10
    Accessing SD Card        10
    Accessing Flash Memory        10...

*Do not operate the projector in direct sunlight 
  or near heat sources such as heaters, fres, and 
  stoves as this may cause a fre hazard.
*Do not operate the projector close to sources 
  of steam or oil such as a humidifer as this 
  may cause electric shock.
*Do not operate the projector near water such as by the sink or bathtub as this may 
cause electric shock.
 
*Do not block or restrict airfow from ventilation holes as this may cause the 
  projector to overheat.
*Do not place infammable...

Overview03 

Remote Control Functions04
  

Packing List05
Projector          Remote ControlA/V Cable          USB Cable
Power Cord 

Startup and Shutdown – To startup, connect 
the power supply or external battery to the 
rear power input.  Press and hold the  power 
button for 3 seconds until the welcome 
logo appears.  To shutdown hold the power 
button for 3 seconds until optical engine 
turns of.
Positioning – Position the projector at an even 
plane and a right angle to the desired image.  
If the projector is not at a right angle or on an 
even plane the projected image will appear 
distorted.
General Operation
 06 

Focus Adjustment / Throw Distance – The 
focus can be adjusted by turning the wheel 
located at the front of the projector.  The 
projector is capable of the following throw 
and focus distances:
General Operation
07
 
Diagonal size Diagonal size Vertical size Horizontal size Throw distance
(inch) (mm) (mm) (mm) (mm)
30 762 457 6101250
40 1016 610 8131666
50 1270 762 10162083
60 1524 914 12192499
70 1778 1067 14222916
80 2032 1219 16263332
90 2286 1372 18293749
100 2540 1524 20324166 

Connecting to a VGA / Computer input source 
The projector can accept a 15-pin RGB input 
source from a laptop’s external monitor port or 
graphics card. This source is connected through 
the 15-pin “VGA” port on the back of the 
projector.
To connect a VGA cable, plug the VGA cable into 
the back of the projector. Then select the “VGA PC” option in the Main Menu. This 
will enable the projector to receive VGA signals.
Important: Be sure to setup the computer to enable video signal output. If using 
the...

To connect an A/V cable insert the 3.5mm portion into the A/V port of the projec-
tor.  Then click on either the “A/V input” icon in the main menu, or press “source” on 
the remote control and select “A/V input”.  A blue screen will appear and the 
Projector will be ready to accept an A/V signal.
Possible A/V sources:  Composite (included), Iphone / Ipod (optional), Zune 
(optional), Playstation Portable (optional), and others.  Please check 
www.aaxatech.com or your AAXA dealer for optional A/V cables....