3M Streaming Projector Users Manual

							3M™ Streaming Projector SPR1000
© 2012 3M. All Rights Reserved.
 41
EnglishItem Menu Item Description
4 Image Orientation Changes the image orientation
 - Normal (Default) - Upside down - Upside down and mirrored - Mirrored
5Picture Mode Changes the image based on the input type: video or computer.
6 Navigation Help Since the buttons on the projector have multiple purposes, 
Navigation Help provides a key for the buttons on the projector. 
Using the menu
You can navigate the menu using the buttons on the projector or the remote control. 
Open the Projector Menu:  Press the Menu button. 
Select a Menu Item:  
•	 Projector Control Panel:  Press the Volume Up and Down to move the selector.
•	 Remote Control:  Press the up or down arrows.
Adjust Menu Item:
•	 Projector Control Panel:  Press the Info button and press Volume Up and Down to 
adjust the setting.
•	 Remote Control:  Press the OK or right arrow and then press right or left button 
to adjust the setting. 
Downloaded From projector-manual.com 3M Manuals 
						

							3M™ Streaming Projector SPR1000
 42 © 2012 3M. All Rights Reserved.
English
Return to Menu Item Selection: Press the Menu button or press OK on the remote 
control. 
On-Screen Icons
One of the following icons will appear when the projector does not detect an input, 
detects a MHL device but no input, or the video resolution is not supported.
- No input detected
- video resolution is not supported
- A MHL device is detected but the video signal is not 
detected. 
Information Screen
Press the Info button on the remote or projector to open the information screen. The 
information shows you if the sound is muted or not, the lamp power level and battery 
power level. 
Downloaded From projector-manual.com 3M Manuals 
						

							3M™ Streaming Projector SPR1000
© 2012 3M. All Rights Reserved.
 43
EnglishReset Button
The reset button restarts the projector in the event the projector stops responding. 
Reset the projector by disconnecting the video input and power, and then press the 
reset button using an uncoiled paper clip. This will turn off the projector and allow you 
to turn the projector on again.
Reset button
Cleaning the Projector
1 Turn off the projector and disconnect power and other cables.
2 Use a soft cloth, such as the 3M™ High Performance Cleaning Cloth, to wipe 
off dust. If the dust is difficult to remove, dampen the cloth with clean water and 
then wipe the projector clean. Then use a clean cloth to dry the projector.
Important Note: Do not use cleaning chemicals or solvents to clean the projector. 
Cleaning chemicals and solvents may cause the plastic parts to discolor.
Downloaded From projector-manual.com 3M Manuals 
						

							3M™ Streaming Projector SPR1000
 44 © 2012 3M. All Rights Reserved.
English
Troubleshooting
The Power Adapter and Charging the Battery
I do not see where to insert the outlet clip. 
•	There is a blank clip, which covers the power adapter contacts, when it is 
shipped. Remove the blank clip.
I do not see an amber light when I plug the power adapter into the projector.
•	 Make sure the outlet that the power adapter is plugged into is working.
•	 Make sure the connector from the power adapter is plugged into the "DC In" on 
the projector and not the headphone jack.
•	  If the LED indicator is flashing green then the battery is fully charged.
Installing the Roku Streaming Stick into the Projector
The Roku Streaming Stick will not insert into the projector. 
•	 There is a dust cap on the end of the connector. Remove it before inserting it into 
the projector.
•	 When you insert the stick, make sure the word Roku is facing out.
The cover hits the Roku Streaming Stick when I close the cover.
•	 The streaming stick may not be inserted properly. Try removing the stick and 
inserting it again. 
Downloaded From projector-manual.com 3M Manuals 
						

							3M™ Streaming Projector SPR1000
© 2012 3M. All Rights Reserved.
 45
English The cover does not close properly. 
•	 There is tongue on the bottom corner of the cover. Make sure the tongue inserts 
into the groove on the projector and the rest of the cover snaps into place.
Turning the Projector On or Off
The projector will not turn on. 
•	 The battery is not charged. Plug the power adapter into the projector and try 
again.
The projector button panel is on but the projector is not projecting an image.
•	 The video source (such as the Roku Stick) is outputting a black image. First, try 
removing the Roku Streaming Stick or disconnect the video cable. Do you see the 
3M logo screen? If not, try turning off the projector and turning it on again. If you 
still do not see a 3M Logo screen while the status indicator is green, contact 3M 
for additional support.
•	 The Lamp is off. Press the Lamp ON/Off button on the remote control.
The remote control will not turn on the projector. 
•	 When the projector is new and never been turned on, you must use the power 
button on the projector. Now you can turn on the projector by pressing the power 
button on the projector or the remote control.
Downloaded From projector-manual.com 3M Manuals 
						

							3M™ Streaming Projector SPR1000
 46 © 2012 3M. All Rights Reserved.
English
The projector is powered on and the Roku Stick is inserted but the 3M Streaming 
Projector displays the No Input Detected screen.
•	You should see a power light on the stick. If you do not, the stick may not be 
inserted properly. Try removing the stick and inserting it again. 
The status indicator on the projector flashes red. 
•	 The projector's battery needs to be charged. 
I continue to see the bouncing Roku screen and that's all. 
•	 While the Roku Streaming Stick boots up, you will see the bouncing Roku screen. 
Normally the Roku Streaming Stick takes about two minutes to boot up. If the 
screen does not change within 10 minutes, try turning off the projector and try 
again.
Setting Up the Projector
The projector falls over when I place it on its rear cover. 
•	 The cover may not be seated properly. There is a tongue on the bottom corner of 
the cover. Insert the tongue into the groove on the projector and the rest of the 
cover will snap into place. 
The image is tinted or discolored. 
•	 The wall or surface you're projecting onto is colored. Try projecting onto a white 
wall or surface.
•	 The lens may be dirty. Use a dry cotton swab to clean it off. 
Downloaded From projector-manual.com 3M Manuals 
						

							3M™ Streaming Projector SPR1000
© 2012 3M. All Rights Reserved.
 47
EnglishFocusing the Image
The image is blurry. 
•	 Use the focus wheel on the side of the projector (next to the lens) to sharpen the 
image.
•	 Reduce the input resolution. The native resolution of the projector is 480p. 
Therefore, resolutions greater that 720p may appear blurry. 
•	 If you are closer to the projected image than the projector, you might be seeing 
the individual pixels that make up the image. Reduce the size of the image or 
move away from the image. 
The image is too dim. 
•	 Reduce the image size and/or decrease (darken) the room lighting.
The image seems bright enough but there are no details in the dark shadows. 
•	 Open the projector menu and increase the brightness setting and then decrease 
the contrast slightly.
The image seems bright enough but there are no details in the highlights. 
•	 Open the projector menu and decrease the contrast.
Adjusting the Volume
There is no audio coming out of the speaker.
•	 Turn up the volume or turn off mute.
Downloaded From projector-manual.com 3M Manuals 
						

							3M™ Streaming Projector SPR1000
 48 © 2012 3M. All Rights Reserved.
English
•	Turn up the volume on the external speakers.
•	 There may be a moment of silence in the show you are watching. 
Using the Remote Control
The remote control does not work. 
•	 Remove the plastic film that is in-between the battery and the remote control. 
•	 Replace the battery because it may be dead. The battery size is CR 2025.
•	 The remote control is out of range of the projector. The remote control's range is 
up to 20 feet.
•	 Sunlight or the lighting in the room can interfere with the projector's reception of 
the remote control's signal.
Downloaded From projector-manual.com 3M Manuals 
						

							3M™ Streaming Projector SPR1000
© 2012 3M. All Rights Reserved.
 49
EnglishProduct Specification
Description Specification
Imager Technology TI DLP
Size 0.3"
Resolution WVGA 854 x 480 Pixels
Aspect Ratio 16:9
Projection Distance 16 5/8 in. – 199 1/4 in. (42.2 – 506 cm)
Image Size 10 in. – 120 in. Diagonal (25.4– 304.8 cm)
Throw Ratio (Diagonal: Distance) 1:1.66
Lens Offset 100%
Inputs DC-in, HDMI (MHL)
Audio Outputs 1x2 Watt Speaker, Headphone Jack
Video Compatibility NTSC, PAL
Video Resolutions 480p, 576p, 720p, 1080i
Dimensions 4.33 x 4.21 x 2 in. (110 x 107 x 51.6mm)
Weight 11 oz (311 g)
Tripod Socket ¼" - 20
Operating Conditions Temperature Range 32 – 95°F (0 – 35°C)
Humidity Range 10 – 80% RH without condensation
Altitude Range Sea Level to 1,829 m (6000')
Downloaded From projector-manual.com 3M Manuals 
						

							3M™ Streaming Projector SPR1000
 50 © 2012 3M. All Rights Reserved.
English
DescriptionSpecification
Power Consumption 11.5 Watts (Standard Lamp Mode)
7.0 Watts (Eco Lamp Mode)
Battery Specification
DescriptionSpecification
Type Rechargeable Lithium-Ion Battery
Rated Capacity 7.4 V, 2600mAh
Video and Audio Support
The following list shows the resolutions that are supported by the projector. The 
projector displays a W VGA (854 x 480) image. The best input resolution for the 
projector is 480p. Other higher resolution will be reduced to 480p resolution.
Video Support
DescriptionResolution  
(width x height) Refresh Rate
Aspect Ratio
480p 640 x 480p 59.94/60 Hz4:3
720 x 480p 59.94/60 Hz4:3
720 x 480p 59.94/60 Hz16:9
576p 720 x 576p 50 Hz4:3
Downloaded From projector-manual.com 3M Manuals