3M Projector Sleeve User Manual

							
User’s Manual 
10 
EN Product specifications 
Item Description Optical Technology  DLP Light Source  RGB LED Resolution 640 x 480 Pixels (VGA) Brightness Up to ANSI 35 lumens Projection Image Size  254 mm ~ 1524 mm (10” ~ 60” Diagonal) Operating System  iOS4, iOS5 Projection Source  iPhone 4, iPhone 4S Power Input    5V / 1A Power Output  5V / 1A Battery Type  Embedded 1850 mAh, Li-polymer 
rechargeable battery 
Battery Life Projection mode: 120 min    ( 下行刪除) 
Power Consumption  Projection mode: 4.5W 
iPhone charging mode: 5W 
Operation 
Temperature 5 °C ~ 35 °C 
Dimension (LxWxH)  126 x 68 x 20 mm Weight 
125 g (4.4 oz) Package Content  Projector Sleeve, USB cable, Quick Start 
Guide, and Product Safety Information 
* All specifications are subject to change without notice.  
© 3M 2012.  All Rights Reserved.  
						

							
 User’s Manual 
11  
EN Troubleshooting 
Symptom Check Point The projector will not turn on.  Ensure the battery is fully charged. The projected image is too 
dark. *  Use the Projector in a darker 
environment. 
*  Decrease the size of projecting  image. 
The projected image is too 
blurry.  Adjust the focus by using focus 
wheel. 
The projector is turned on, but 
an image is not projected. Ensure the App has a TV-out 
function. 
The temperature of the 
projector’s surface is warm. It is normal for this projector to 
generate moderate heat during 
normal operation. 
When connecting the iPhone 
to the projector and an error 
message appears on iPhone 
screen as shown below. It may be caused by poor a 
connection between iPhone and 
the projector. Please reconnect 
iPhone and projector, then turn on 
the projector again. 
 
© 3M 2012.  All Rights Reserved.  
						

							
User’s Manual 
12 
EN Symptom Check Point The projection image ratio is 
distorted. On the iPhone, switch the 
Widescreen setting to Off in 
Settings>Gerneral>TV out. 
Stop video projection 
suddenly and automatically. 
On the iPhone, switch the Auto-lock 
to Never in Settings>General. 
Only safety logos and 
numbers appear are on the 
projection screen. When the projectors power button 
is held down for too long, the 
projector enters engineering mode. 
Press the power button until the 
projector turns off, then press the 
power button again for 3 seconds. 
 
 
© 3M 2012.  All Rights Reserved.  
						

							
s Manual 
 
 
Rev. A (10/2012)  78-6971-1633-9  © 3M 2012. All Rights Reserved.Please Recycle.