3M Digital Projector X95i Opeators Manual

							
61
MIU menu
MIU menu (continued)
Item Description
SETUP
FRQWLQXHG SPEED
8VHWKH
x
zEXWWRQVWRVHOHFW
WKHWUDQVIHUUDWH
00ESV0HJDELWVSHUVHFRQG
$872
Ù0
Ù0
Ù0
Ù0
Ù0
ÚÚ
0 Ù0
Ù0
Ù0
Ù0
Ù 0
Ù0

						

							
62
MIU menu
MIU menu (continued)
Item Description
0
						

							
63
MIU menu
MIU menu (continued)
Item Description
INFORMATION
6HOHFWLQJWKLVLWHPGLVSOD\VWKH0,8,1)250$7,21GLDORJIRUFR Q¿UPLQJ
WKHQHWZRUNVHWWLQJV

						

							
64
C.C. (Closed Caption) menu
7KHFORVHGFDSWLRQVHWWLQJFDQEHFKDQJHGWKURXJK&&
PHQXLQWKHDGYDQFHPHQX3OHDVHVHOHFWWKHLWHPWKDW\RX
ZLOOFKDQJHXVLQJ
x
zFXUVRUEXWWRQV

						

							
65
Maintenance
0DLQWHQDQFH
$ODPSKDV
						

							
66
Maintenance
Lamp warning
+,*+92/7$*(+,*+7(03(5$785(+,*+35(6685(

y7KHSURMHFWRUXVHVDKLJKSUHVVXUHPHUFXU\JODVVODPS7KH
ODPSFDQEUHDNZLWKDORXGEDQJRUEXUQRXWLIMROWHGRUVFUD WFKHGKDQGOHG
ZKLOHKRWRUZRUQRYHUWLPH1RWHWKDWHDFKODPSKDVDGLIIHUH QWOLIHWLPHDQG
VRPHPD\EXUVWRUEXUQRXWVRRQDIWHU\RXVWDUWXVLQJWKHP,Q DGGLWLRQZKHQ
WKHEXOEEXUVWVLWLVSRVVLEOHIRUVKDUGVRIJODVVWRÀ\LQWR WKHODPSKRXVLQJDQG
IRUJDVFRQWDLQLQJPHUFXU\WRHVFDSHIURPWKHSURMHFWRU
						

							
67
Maintenance
3UHVVWKH0(18EXWWRQWRGLVSOD\DPHQX
 3RLQWDWWKH
						

							
Maintenance
Internal clock batter y 
Consumption of the battery causes the clock time to be incorrect. When the clock is wrong or it has 
stopped, please replace the battery according to the following procedure\
s.
 
.
 
. 
.
1. Turn the projector off, and unplug the power cord. Allow the 
projector to cool sufficiently.
2. After making sure that the projector has cooled adequately, 
slowly turn over the projector, so that the bottom is facing.
3. Turn the battery cover fully in the direction indicated OPEN 
using a coin or the like, and pick the cover up to remove it.
4. One of two kinds of clock battery holder, A or B shown to the 
right, is inside the battery cover.
 For A holder:  
Pry up the battery using a flathead screwdriver or the like to take 
it out. While prying it up, put a finger lightly on the battery since 
it may pop out of the holder.
 For B holder:  
Press the metal claw of the battery holder putting a finger lightly on the battery since it 
may pop out of the holder. Then the battery will come up. Remove the battery.
《NOTE》 • If the battery is inserted upside down in the В holder, it might be difficult to remove. 
If that happens, take following measures:    
(1) Remove the battery cover and turn the projector's upside up.    
(2) Lift the side of the projector that is close to the lens and press\
 the metal claw of the battery 
holder. The battery will fall out of the holder, so be careful not to lose it.
5. Replace battery with new HITACHI MAXELL, Part No.CR2032 or CR2032H. Slide 
the battery in under the plastic claw, and push it into the holder until it clicks.
6. Replace the battery cover in place, then turn it in the direction indicated CLOSE using 
such as coins, to fix.
WARNING  ►Always  handle  the  batteries  with  care  and  use  them  only  as  directed. 
Battery  may  explode  if  mistreated.  Do  not  recharge,  disassemble  or  dispose  of  in  fire. 
And also improper use may result in cracking or leakage, which could result in fire, injury 
and/or pollution of the surrounding environment.
• Be sure to use only the batteries specified.
• Make sure the plus and minus terminals are correctly aligned when loading a battery .
•  Keep  a  battery  away  from  children  and  pets.  If  swallowed  consult  a  physician  immediately for emergency treatment.
• Do not short circuit or solder a battery.
• Do not allow a battery in a fire or water. Keep batteries in a dark, cool and dry place. 
•  If  you  observe  battery  leakage,  wipe  out  the  leakage  and  then  replace  a  battery.  If  the  leakage adheres to your body or clothes, rinse well with water immediate\
ly.
• Obey the local laws on disposing the battery.
OPENCLOSEOPEN
B
CLOSE
OPENCLOSE
OPENCLOSEOPEN
CLOSE
OPENCLOSE
A
3M™ Digital Projector X95i
68© 3M 2009. All Rights Reserved. 
						

							
69
Maintenance
Other care
,QRUGHUWRHQVXUHWKHVDIHXVHRI\RXUSURMHFWRUSOHDVHKDYHLWFOHDQHGDQG
LQVSHFWHGE\\RXUGHDOHUDERXWRQFHHYHU\\HDU
7XUQWKHSURMHFWRURIIDQGXQSOXJWKHSRZHUFRUG$OORZWKHSU RMHFWRUWRFRRO
VXI
						

							
70
Troubleshooting
7URXEOHVKRRWLQJ
Related messages
:KHQWKHXQLW
VSRZHULVRQPHVVDJHVVXFKDVWKRVHVKRZQEHORZPD\EH
GLVSOD\HG:KHQDQ\VXFKPHVVDJHLVGLVSOD\HGRQWKHVFUHHQSO HDVHIROORZWKH
LQVWUXFWLRQVGHVFULEHGEHORZ,IWKHVDPHPHVVDJHLVGLVSOD\HG DIWHUWKHUHPHG\
RULIDPHVVDJHRWKHUWKDQWKHIROORZLQJDSSHDUVSOHDVHFRQWDF W\RXUGHDOHURU
VHUYLFHFRPSDQ\
$OWKRXJKWKHVHPHVVDJHVZLOOEHDXWRPDWLFDOO\GLVDSSHDUHGDURXQ GVHYHUDO
PLQXWHVLWZLOOEHUHDSSHDUHGHYHU\WLPHWKHSRZHULVWXUQHGR Q
Message Description
There is no input signal.
3OHDVHFRQ¿UPWKHVLJQDOLQSXWFRQQHFWLRQDQGWKHVWDWXV
RIWKHVLJQDOVRXUFH
7KHKRUL]RQWDORUYHUWLFDOIUHTXHQF\RIWKHLQSXWVLJQDO
LVQRWZLWKLQWKHVSHFL¿HGUDQJH
3OHDVHFRQ¿UPWKHVSHFVIRU\RXUSURMHFWRURUWKHVLJQDO
VRXUFHVSHFV
An improper signal is input.
3OHDVHFRQ¿UPWKHVSHFVIRU\RXUSURMHFWRURUWKHVLJQDO
VRXUFHVSHFV
The internal temperature is rising.
3OHDVHWXUQWKHSRZHURIIDQGDOORZWKHSURMHFWRUWRFRRO
GRZQDWOHDVWPLQXWHV$IWHUKDYLQJFRQ