PANEL REPAIRS
PROCEDURES3REVISED: PANEL REPLACEMENT PROCEDURE
General
This information is designed to explain the basic
panel removal and replacement method. This
standard method might vary slightly from one vehicle
to another. The main criterion in removal and
replacement of body panels is that Rovers original
standard is maintained as far as possible.
Remove Panel
1.Expose resistance spot welds. For those spot
welds which are not obviously visible, use a
rotary impregnated wire brush fitted to an air...
Our Land Rover experts are ready to help you, just give us a call.FAX 24 HOURS (802) 879-9152 Order on-line: www.roversnorth.comYour Customer Speed Number As the name suggests, the use of your “speed number” allows us to quickly
draw up your name and address on our computers whenever you call. This
means shorter phone calls and no confusion over whether you’re John
Smith of San Francisco or John Smith of San Juan. Take a minute to fill out
the quick-reference chart below to make ordering...
PARTS SUITABLE FOR
L AND ROVER SERIES 2a & 3PAGE1QUICK REFERENCE
SUSPENSION
STEERING
OILSEALS
GEARBOX
GASKETS
FUELSYSTEM
FILTERS
FASTENERS
EXHAUST
ENGINE
ELECTRICAL
DRIVELINE
COOLING
CLUTCH
CHASSIS
CABLES
BRAKES
BODY
BELTS
BEARINGS
A XLE
DRAWING QUANTITY BEARMACH PART DESCRIPTIONREF REF NUMBER1 1 BR 0607 599698 Distance Piece Stub Axle2 6 BR 0538 237339 Bolt Stub Axle to Swivel Housing3 3 BR 0965 277311 Locking Plate4 1 BR 0547 599827 Stub Axle Assembly5 1 BR 1403 277289 Joint Washer6 BR 1977 STC3409...
PROPELLER SHAFTS
Introduction and Legacy Vehicles 5
Propeller Shafts Introduction and Legacy VehiclesPropeller Shafts - Introduction
Unlike many others, Land Rover provides grease fittings on both the universal joints and slip
yokes for routine servicing.
PROPELLER SHAFT/UNIVERSAL JOINT SERVICE
Normal service intervals are:
Range Rover Classic, Defender 110, 1994-1995 Defender 90:
Universal Joints: Every 7,500 miles (12,000 km)
Slip Joints: Every 22,500 miles (36,000 km)
1994 - 1995 Discovery:
Universal...
RANGE ROVER 05MY
Electrical Circuit Diagrams
Publication Part No. LRL 18 38 55 501
Published by Land Rover
© 2004 Land Rover
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form, electronic, mechanical, recording or other means without prior written permission from Land Rover.
,...’
‘,:: .::, :.:
R”;;; 1987
LT230 TRANSFER GEARBOX [39 1
‘.
‘.
LT230 TRANSFER BOX
The following operations can be carried out with
the gearbox in the vehicle. For ease of working, the
vehicle should be raised on a suitable hoist or
placed over a pit.
SPEEDOMETER DRIVE PINION
Remove and refit
Removing1. Disconnect the battery.
2. Raise the vehicle on a suitable hoist.
3. Remove the speedometer drive clamp and nut
and withdraw the cable.
4.
Pry out the drive pinion assembly.
Refitting
5. Push in a new...
POWER STEERING BOX
Remove and refit
Service tools:
Drop arm extractor-MS252A
NOTE: It is important that whenever any part of
the system,including the flexible piping, is
removed or disconnected, that the utmost
cleanliness is observed.
All ports and hose connections should be
suitably sealed off to prevent ingress of dirt, etc.
If metallic sediment is found in any part of the
system, the complete system should be checked,
the cause rectified and the system thoroughly
cleaned.
Under no circumstances must...
Owner’s Handbook
Instruktieboekje
Manuel du Conducteur
Betriebsanleitung
Manuale di Istruzioni
Manual del Conductor
Manual do Propriet ário
Owner’s Handbook
Instruktieboekje
Manuel du Conducteur
Betriebsanleitung
Manuale di Istruzioni
Manual del Conductor
Manual do Propriet ário
